Ideal Mixing of Polymer-Surfactant Complexes of Polyethylene Oxide and Sodium Dodecyl Sulfate Plus Sodium Dodecanoate

Adsorption of Mixtures of a Pegylated Lipid with Anionic and Zwitterionic Surfactants at Solid/Liquid

This work explores the association of a pegylated lipid (DSPE-PEG) with different anionic and zwitterionic surfactants (pseudo-binary and pseudo-ternary polymer+ surfactant mixtures), and the adsorption of the polymer + surfactant aggregates onto negatively charged surfaces, with a surface charge density similar to that existing on the damaged hair epicuticle. Dynamic light scattering and zeta potential measurements shows that, in solution, the polymer + surfactant association results from an intricate balance between electrostatic and hydrophobic interactions, which leads to the formation of at least two different types of micellar-like polymer + surfactant aggregates. The structure and physicochemical properties of such aggregates were found strongly dependent on the specific nature and concentration of the surfactant. The adsorption of the polymer + surfactant aggregates onto negatively charged surface was studied using a set of surface-sensitive techniques (quartz crystal microbalance with dissipation monitoring, ellipsometry and Atomic Force Microscopy), which allows obtaining information about the adsorbed amount, the water content of the layers and the topography of the obtained films. Ion-dipole interactions between the negative charges of the surface and the oxyethylene groups of the polymer + surfactant aggregates appear as the main driving force of the deposition process. This is strongly dependent on the surfactant nature and its concentration, with the impact of the latter on the adsorption being especially critical when anionic surfactant are incorporated within the aggregates. This study opens important perspectives for modulating the deposition of a poorly interacting polymer onto negatively charged surfaces, which can impact in the fabrication on different aspects with technological and industrial interest.

Investigation of pseudo-polyanion formation between polyvinylpyrrolidone and sodium dodecanoate in aqueous solution by capillary electrophoresis, conductometry, tensiometry and calcium stability

H-bonding replaces sodium bridging in the PVP–SD complexation with pH reduction.

Polymer-surfactant systems in bulk and at fluid interfaces

The interest of polymer-surfactant systems has undergone a spectacular development in the last thirty years due to their complex behavior and their importance in different industrial sectors. The importance can be mainly associated with the rich phase behavior of these mixtures that confers a wide range of physico-chemical properties to the complexes formed by polymers and surfactants, both in bulk and at the interfaces. This latter aspect is especially relevant because of the use of their mixture for the stabilization of dispersed systems such as foams and emulsions, with an increasing interest in several fields such as cosmetic, food science or fabrication of controlled drug delivery structures. This review presents a comprehensive analysis of different aspects related to the phase behavior of these mixtures and their intriguing behavior after adsorption at the liquid/air interface. A discussion of some physical properties of the bulk is also included. The discussion clearly points out that much more work is needed for obtaining the necessary insights for designing polymer-surfactant mixtures for specific applications.

Photoresponsive phase separation of a poly(NIPAAm-co-SPO-co-fluorophore) random copolymer in W/O droplet

The photoresponsive phase separation of a poly(N-isopropylacrylamide-co-spironaphthoxazine methacryloyl-co-allyl-2-(2,6-bis((E)-4-(diphenylamino)styryl)-4H-pyran-4-ylidene)-2-cyanoacetate) random copolymer, i.e., poly(NIPAAm-co-SPO-co-fluorophore), in water-in-oil (W/O) droplets is described. The photoresponsive aqueous droplets were generated in the coflow regime of a simple tubular microfluidic device. The phase separation of the copolymer in the W/O droplets was induced by UV light at 365 nm and was affected significantly by the presence of 2,2-diethoxyacetophenone (DEAP) and sorbitan monooleate (Span 80). When the droplets were subjected to UV irradiation for more than 2 min, the phase-separated copolymer was transferred completely from the aqueous droplet to the continuous phase of hexadecane. The phase separation arises from the photoisomerization shifting the spiro to the merocyanine form of the SPO pendant group in the copolymer, which in turn reduces the hydrophilicity of the copolymer via attractive hydrogen-bonding interactions between the merocyanine group and hydrophobic additives, i.e., Span 80, DEAP, and some stable fragments derived from the photocleavage of DEAP under UV irradiation. These interactions cause the copolymer to associate with the additives and then accelerate the phase separation of the copolymer and subsequent phase transfer of copolymer aggregates. The separate effects of DEAP and Span 80 were also investigated by UV spectrophotometric analysis of the rate coefficient of the reverse transformation (merocyanine to spiro) of the photochromic monomer. We propose a mechanism of phase separation of the copolymer in the W/O droplet based on the NMR and GC-MASS analyses of DEAP.

Interactions of different counterions with cationic and anionic surfactants

Specific counterion effects on the formation and electrolytic dissociation of micelles have been studied for sodium dodecyl sulfate and hexadecyl-N,N,N-trimethyl ammonium bromide in the presence of different electrolytes. Mass spectrometry has been used to investigate the affinity of counterions to surfactant free monomers in the gas phase. Linear correlations have been found between the parameters determined for micelles in the aqueous phase and the fraction of counterions preferably bound to surfactant free monomers in the gas phase. The work presents a new insight into specific ion effects.

Interfacial and bulk behavior of sodium dodecyl sulfate in isopropanol-water and in isopropanol-poly(vinylpyrrolidone)-water media

The surface activity of isopropanol (IP) and poly(vinylpyrrolidone) (PVP) at the air/water interface has been studied. The self-aggregation of sodium dodecyl sulfate (SDS) in IP-water as well as in IP-PVP-water media has been investigated using physical methods, viz., tensiometry, conductometry, calorimetry, and viscometry. The interaction of SDS with PVP in IP-water medium as well as its self-aggregation (or micellization) in the presence of PVP has been assessed. The results reveal a fair degree of surface activity of IP in aqueous medium, which is only moderate for PVP. The critical micellar concentration (CMC) of SDS passes through a minimum at (v/v) % IP = 6.62. SDS interacts with PVP, yielding a critical aggregation concentration (CAC) at a low [SDS], independent of IP content in the medium. At a higher [SDS], free micelle formation takes place in solution, which is lower in mixed solvent than in water and is independent of solvent composition by tensiometry, but not by conductometry and calorimetry. The viscosity of micelle-interacted PVP in solution takes a long time to stabilize, whereas, for non-interacting additives, such as NaCl and cetyltrimethylammonium bromide (CTAB), it is time independent.

Surfactant--polymer aggregates formed by sodium dodecyl sulfate, poly(N-vinyl-2-pyrrolidone), and poly(ethylene glycol)

The interaction of sodium dodecyl sulfate (SDS) in aqueous solution with poly(N-vinyl-2-pyrrolidone) (M(w) = 55,000 g/mol) in the presence of poly(ethylene glycol) (M(w) = 8000 g/mol) is investigated by electrical conductivity, zeta potential measurements, viscosity measurements, fluorescence spectroscopy, and small-angle X-ray scattering (SAXS). The results indicate that SDS-polymer interaction occurs at low surfactant concentration, and its critical aggregation concentration is fairly dependent on polymer composition. The polymer-supported micelles have average aggregation numbers dependent on surfactant concentration, are highly dissociated when compared with aqueous SDS micelles, and have zeta potentials that increase linearly with the fraction of PVP at constant SDS concentration. The analysis of the SAXS measurements indicated that the PVP/PEG/SDS system forms surface-charged aggregates of a cylindrical shape with an anisometry (length to cross-section dimension ratio) of about 3.0.

Variegated micelle surfaces: correlating the microstructure of mixed surfactant micelles with bulk solution properties

Electron paramagnetic resonance, viscosity, and small-angle neutron scattering (SANS) measurements have been used to study the interaction of mixed anionic/nonionic surfactant micelles with the polyampholytic protein gelatin. Sodium dodecyl sulfate (SDS) and the nonionic surfactant dodecylmalono-bis-N-methylglucamide (C12BNMG) were chosen as "interacting" and "noninteracting" surfactants, respectively; SDS micelles bind strongly to gelatin but C12BNMG micelles do not. Further, the two surfactants interact synergistically in the absence of the gelatin. The effects of total surfactant concentration and surfactant mole fraction have been investigated. Previous work (Griffiths et al. Langmuir 2000, 16 (26), 9983-9990) has shown that above a critical solution mole fraction, mixed micelles bind to gelatin. This critical mole fraction corresponds to a micelle surface that has no displaceable water (Griffiths et al. J. Phys. Chem. B 2001, 105 (31), 7465). On binding of the mixed micelle, the bulk solution viscosity increases, with the viscosity-surfactant concentration behavior being strongly dependent on the solution surfactant mole fraction. The viscosity at a stoichiometry of approximately one micelle per gelatin molecule observed in SDS-rich mixtures scales with the surface area of the micelle occupied by the interacting surfactant, SDS. Below the critical solution mole fraction, there is no significant increase in viscosity with increasing surfactant concentration. Further, the SANS behavior of the gelatin/mixed surfactant systems below the critical micelle mole fraction can be described as a simple summation of those arising from the separate gelatin and binary mixed surfactant micelles. By contrast, for systems above the critical micelle mole fraction, the SANS data cannot be described by such a simple approach. No signature from any unperturbed gelatin could be detected in the gelatin/mixed surfactant system. The gelatin scattering is very similar in form to the surfactant scattering, confirming the widely accepted picture that the polymer "wraps" around the micelle surface. The gelatin scattering in the presence of deuterated surfactants is insensitive to the micelle composition provided the composition is above the critical value, suggesting that the viscosity enhancement observed arises from the number and strength of the micelle-polymer contact points rather than the gelatin conformation per se.

The Role of the Carboxylate Head Group in the Interaction of Sodium Dodecanoate with Poly(ethylene oxide) Investigated by Electrical Conductivity, Viscosity, and Aggregation Number Measurements

The binding of sodium dodecanoate (SDoD) to poly(ethylene oxide) (PEO) in aqueous solution was investigated and compared with the well-known polymer-surfactant complexes formed between PEO and sodium dodecyl sulfate (SDS). Electrical conductivity measurements indicated that the concentration ratio of bound SDoD to PEO (on monomer basis) was greater than that for the system PEO-SDS. However, the aggregation numbers of the micelles supported on the polymer chain are practically constant and similar for both surfactants at concentrations lower than the polymer saturation point. The difference in binding capability is explained in terms of a larger PEO coil expansion upon complexation of SDoD than in the case of SDS. An increase in the polymer surface favors the binding of SDoD to PEO in aqueous solution. This conclusion is supported by the results of the viscometric studies of PEO-surfactant solution.