Isolation of acetoin-producing Bacillus strains from Japanese traditional food-natto

In this study, Bacillus strains with an ability to produce acetoin were isolated from a Japanese traditional food, natto, on the basis of the Voges-Proskauer (VP) reaction, and strain SF4-3 was shown to be a predominant strain in acetoin production. Based on a variety of morphological, physiological, and biochemical characteristics as well as the nucleotide sequence analysis of 16S rDNA, the strain SF4-3 was identified as Bacillus subtilis. When it was incubated at 37°C with a speed of 180 rpm for 96 hr in the flasks, the maximum acetoin concentration was up to 33.90 g/L. The fermentation broths were determined by gas chromatography (GC) and gas chromatography-mass spectrometry (GC-MS) analyses; the results showed that the major metabolite was acetoin, and the purity could reach more than 95% without butanedione and 2,3-butanediol, which were usually produced together with acetoin in other strains. A novel aqueous two-phase system (ATPS) composed of hydrophilic solvents and inorganic salts was developed for the extraction of acetoin from fermentation broths. The ethanol and dipotassium hydrogen phosphate system could be used to extract acetoin from fermentation broths. The influences of phase composition on partition of acetoin were investigated. The maximum partition coefficient (9.68) and recovery (94.6%) of acetoin were obtained, when 25% (w/w) dipotassium hydrogen phosphate and 24% (w/w) ethanol were used.

Another glimpse over the salting-out assisted liquid-liquid extraction in acetonitrile/water mixtures

The use of the salting-out effect in analytical chemistry is very diverse and can be applied to increase the volatility of the analytes in headspace extractions, to cause the precipitation of proteins in biological samples or to improve the recoveries in liquid-liquid extractions. In the latter, the salting-out process can be used to create a phase separation between water-miscible organic solvents and water. Salting-out assisted liquid-liquid extraction (SALLE) is an advantageous sample preparation technique aiming HPLC-UV analysis when developing analytical methodologies. In fact, some new extraction methodologies like QuEChERS include the SALLE concept. This manuscript discusses another point of view over SALLE with particular emphasis over acetonitrile-water mixtures for HPLC-UV analysis; the influence of the salting-out agents, their concentration and the water-acetonitrile volume ratios were the studied parameters. α-dicarbonyl compounds and beer were used as test analytes and test samples, respectively. The influence of the studied parameters was characterized by the obtained phase separation volume ratio and the fraction of α-dicarbonyls extracted to the acetonitrile phase. Results allowed the distribution of salts within three groups according to the phase separation and their extractability: (1) chlorides and acetates, (2) carbonates and sulfates and (3) magnesium sulfate; of all tested salts, sodium chloride had the highest influence on the α-dicarbonyls fraction extracted.