Extraction properties of new polymeric sorbents in SPE/GC analysis of phenol and hydroquinone from water samples

The influence of the polymers' properties on the solid-phase extraction recovery was studied. Different porous copolymers were used: di(methacryloyloxymethyl)naphtalene-divinylbenzene with ester functional groups (DMN-DVB), 4,4'-bis(maleimido)diphenylmethane-divinylbenzene with imide functional groups (BM-DVB), p,p'-dihydroxydiphenylmethane diglycidyl methacrylic ester-divinylbenzene (MEMDE-DVB) and p,p'-dihydroxydiphenylpropane diglycidyl methacrylic ester-divinylbenzene (MEDDE-DVB) with ester end hydroxyl functional groups. The extraction properties of new synthesized polymeric sorbents were compared with these of two commercial polymeric sorbents: styrene-divinylbenzene (SDB-1) and styrene-divinylbenzene with modified surface (StrataX). These sorbents were used in the SPE of phenol and hydroquinone from water samples.

Comparison of three derivatization ways in the separation of phenol and hydroquinone from water samples

Hydroquinone and phenol were analysed in aqueous alkaline model samples using chromatographic techniques. The compounds were isolated by solid-phase extraction and determined quantitatively by capillary gas chromatography after derivatization. The effectivity of derivatization was tested in three phases of sample handling: (i) before extraction; (ii) in the extraction bed; and (iii) during elution.

Chemically modified polymeric sorbents for sample preconcentration

Solid-phase extraction is an attractive alternative in sample preparation because it overcomes many drawbacks of liquid-liquid extraction and makes on-line determination possible by hyphenation with chromatographic techniques. Driven by the need for more effective and more selective sorbents, advances in solid-phase extraction include the development of new materials. This paper describes different types of chemically modified sorbents for the solid-phase extraction of compounds from aqueous samples. Chemical introduction of different functional groups into a polymeric resin improves the efficiency of solid-phase extraction by providing better surface contact with the aqueous samples; also, these sorbents have a greater capacity than the typical solid-phase materials for polar compounds have. The most important new sorbents are the chemically modified resins based on styrene-divinylbenzene copolymers. Preparation of these new sorbents is described, and advantages and drawbacks of off-line procedures and on-line procedures are also discussed. Applications for off-line and on-line chromatographic determinations of polar compounds are presented.