Two-Photon Fluorescence Fluctuation Spectroscopy

τFCS: multi-method global analysis enhances resolution and sensitivity in fluorescence fluctuation measurements

Fluorescence fluctuation methods have become invaluable research tools for characterizing the molecular-level physical and chemical properties of complex systems, such as molecular concentrations, dynamics, and the stoichiometry of molecular interactions. However, information recovery via curve fitting analysis of fluctuation data is complicated by limited resolution and challenges associated with identifying accurate fit models. We introduce a new approach to fluorescence fluctuation spectroscopy that couples multi-modal fluorescence measurements with multi-modal global curve fitting analysis. This approach yields dramatically enhanced resolution and fitting model discrimination capabilities in fluctuation measurements. The resolution enhancement allows the concentration of a secondary species to be accurately measured even when it constitutes only a few percent of the molecules within a sample mixture, an important new capability that will allow accurate measurements of molecular concentrations and interaction stoichiometry of minor sample species that can be functionally important but difficult to measure experimentally. We demonstrate this capability using τFCS, a new fluctuation method which uses simultaneous global analysis of fluorescence correlation spectroscopy and fluorescence lifetime data, and show that τFCS can accurately recover the concentrations, diffusion coefficients, lifetimes, and molecular brightness values for a two component mixture over a wide range of relative concentrations.

Fluorescence imaging of membrane dynamics

Imaging membrane dynamics is an important goal, motivated by the abundance of biochemical and biophysical events that are orchestrated at, or by, cellular membranes. The short length scales, fast timescales, and environmental requirements of membrane phenomena present challenges to imaging experiments. Several technical advances offer means to overcome these challenges, and we describe here three powerful techniques applicable to membrane imaging: total internal reflection fluorescence (TIRF) microscopy, fluorescence interference contrast (FLIC) microscopy, and fluorescence correlation spectroscopy (FCS). For each, we discuss the physics underpinning the approach, its practical implementation, and recent examples highlighting its achievements in exploring the membrane environment.

Lipid lateral mobility and membrane phase structure modulation by protein binding

Using a combination of fluorescence correlation and infrared absorption spectroscopies, we characterize lipid lateral diffusion and membrane phase structure as a function of protein binding to the membrane surface. In a supported membrane configuration, cholera toxin binding to the pentasaccharaide headgroup of membrane-incorporated GM1 lipid alters the long-range lateral diffusion of fluorescently labeled probe lipids, which are not involved in the binding interaction. This effect is prominently amplified near the gel-fluid transition temperature, Tm, of the majority lipid component. At temperatures near Tm, large changes in probe lipid diffusion are measured at average protein coverage densities as low as 0.02 area fraction. Spectral shifts of the methylene symmetric and asymmetric stretching modes in the lipid acyl chain confirm that protein binding alters the fraction of lipid in the gel phase.

o-Nitrobenzyl Photolabile Protecting Groups with Red-Shifted Absorption: Syntheses and Uncaging Cross-Sections for One- and Two-Photon Excitation

We evaluated the o-nitrobenzyl platform for designing photolabile protecting groups with red-shifted absorption that could be photolyzed upon one- and two-photon excitation. Several synthetic pathways to build different conjugated o-nitrobenzyl backbones, as well as to vary the benzylic position, are reported. Relative to the reference 4,5-dimethoxy-2-nitrobenzyl group, several o-nitrobenzyl derivatives exhibit a large and red-shifted one-photon absorption within the near-UV range. Uncaging after one-photon excitation was studied by measuring UV-visible absorption and steady-state fluorescence emission on model caged ethers and esters. In the whole series investigated, the caged substrates were released cleanly upon photolysis. Quantum yields of uncaging after one-photon absorption lie within the 0.1-1 % range. We observed that these drop as the maximum wavelength absorption of the o-nitrobenzyl protecting group is increased. A new method based on fluorescence correlation spectroscopy (FCS) after two-photon excitation was used to measure the action uncaging cross section for two-photon excitation. The series of o-nitrobenzyl caged fluorescent coumarins investigated exhibit values within the 0.1-0.01 Goeppert-Mayer (GM) range. Such results are in line with the low quantum yields of uncaging associated with cross-sections of 1-50 GM for two-photon absorption. Although the cross-sections for one- and two-photon absorption of o-nitrobenzyl photolabile protecting groups can be readily improved, we emphasize the difficulty in enlarging the corresponding action uncaging cross-sections in view of the observed trend of their quantum yield of uncaging.

Reactant Concentrations from Fluorescence Correlation Spectroscopy with Tailored Fluorescent Probes. An Example of Local Calibration-Free pH Measurement

The present account is concerned with the measurement of local reactant concentrations by observing specific fluorescent probes in fluorescence correlation spectroscopy (FCS). The Theoretical Analysis section revisits the photophysical, thermodynamic, and kinetic information that is contained in the corresponding FCS correlation curves. In particular, we examine the conditions under which FCS is revealed as a superior tool to measure concentrations of reactive species. Careful molecular engineering of the specific fluorescent probes that simultaneously integrates photophysical, thermodynamic, and kinetic constraints will be required to benefit most from FCS. We illustrate the FCS titration approach with a series of fluorescent probes that we tailored to measure pH at around 4-6 by FCS after two-photon excitation. We show that an optimal design allows one to access pH without any preliminary calibrations such as the determination of the protonation constant or the photophysical properties of the fluorescent probe.