Bone mineral and other bone components in vertebrae evaluated by QCT and MRI

Magnetic resonance imaging T1 and T2 mapping provide complementary information on the bone mineral density regarding cancellous bone strength in the femoral head of postmenopausal women with osteoarthritis

BACKGROUND

Since bone mass is not the only determinant of bone strength, there has been increasing interest in incorporating the bone quality into fracture risk assessments. We aimed to examine whether the magnetic resonance imaging (MRI) T1 or T2 mapping value could provide information that is complementary to bone mineral density for more accurate prediction of cancellous bone strength.

METHODS

Four postmenopausal women with hip osteoarthritis underwent 3.0-T MRI to acquire the T1 and T2 values of the cancellous bone of the femoral head before total hip arthroplasty. After the surgery, the excised femoral head was portioned into multiple cubic cancellous bone specimens with side of 5 mm, and the specimens were then subjected to microcomputed tomography followed by biomechanical testing.

FINDINGS

The T1 value positively correlated with the yield stress (σ_y) and collapsed stress (σ_c). The T2 value did not correlate with the yield stress, but it correlated with the collapsed stress and strength reduction ratio (σ_c/σ_y), which reflects the progressive re-fracture risk. Partial correlation coefficient analyses, after adjusting for the bone mineral density, showed a statistically significant correlation between T1 value and yield stress. The use of multiple coefficients of determination by least squares analysis emphasizes the superiority of combining the bone mineral density and the MRI mapping values in predicting the cancellous bone strength compared with the bone mineral density-based prediction alone.

INTERPRETATION

The MRI T1 and T2 values predict cancellous bone strength including the change in bone quality.

Evaluation of Spinal Bone Changes in Patients with Chronic Renal Failure by CT and Mr Imaging with Pathologic Correlation

To investigate bone changes in patients with chronic renal failure (CRF), bone mineral density (BMD) and T1 relaxation times were measured with CT and MR imaging and the results were correlated to histology. Excised lumbar vertebrae from 25 autopsy cases of CRF (18 males and 7 females), including 12 cases in which the patients had been receiving hemodialysis were examined. BMD and T1 relaxation time values were associated with specific histologic findings for cellularity, trabeculae, and peritrabecular fibrosis. Three vertebrae with low BMD showed increased hematopoietic marrow content, a finding not observed in primary osteoporosis. The vertebrae with osteosclerosis showed prolonged T1 relaxation time, which was due to increased amount of hematopoietic marrow, and the presence of thickened or many small irregular trabeculae or peritrabecular fibrosis. These findings may be useful in the evaluation of bone changes in patients with CRF.

Multiparameter MRI assessment of normal-appearing and diseased vertebral bone marrow

OBJECTIVE

To evaluate spin-lattice (T1) and spin-spin (T2) relaxation times as well as apparent diffusion coefficients (ADCs) of the fat and water components in the vertebral bone marrow (vBM) of patients with benign and malignant lesions.

METHODS

Forty-four patients were examined at 1.5 T: there were 24 osteoporotic vertebral fractures (15 women, 9 men; median age: 73, 48-86 years) and 20 malignant vertebral infiltrations (9 women, 11 men; median age: 60, 25-87). Relaxation times were determined separately for the water and the fat component using a saturation-recovery technique for T1 and measurements with variable echo times for T2. ADCs were determined with a diffusion-weighted (DW) echo-planar imaging (EPI) and a single-shot turbo-spin-echo (ssTSE) sequence.

RESULTS

T1 of the water component and ADCs were significantly increased in the lesions compared with normal-appearing vBM (malignant: 1,252 vs. 828 ms, osteoporotic: 1,315 vs. 872 ms). ADCs determined with the DW-ssTSE were significantly increased compared with the DW-EPI. ADCs determined with the DW-ssTSE differed significantly between osteoporotic and malignant lesions (1.74 vs 1.35 x 10⁻³ mm²/s.

CONCLUSIONS

All parameters exhibit significant differences between normal-appearing vBM and the lesions. However, only the ADCs determined with the DW-ssTSE differed significantly between osteoporotic fractures and malignant lesions, potentially allowing for a differential diagnosis of these two entities.

Bone Formation in Transplants of Human Bone Marrow Stromal Cells and Hydroxyapatite–Tricalcium Phosphate: Prediction with Quantitative CT in Mice

PURPOSE

To determine whether quantitative computed tomography (CT) can be used to estimate the extent of new bone formation in hydroxyapatite-tricalcium phosphate (HA-TCP)-based transplants.

MATERIALS AND METHODS

Bone-forming transplants were generated by attaching cultured human bone marrow stromal cells to aliquots of HA-TCP particles and were placed in subcutaneous pockets in immunocompromised mice. After 8 weeks, the transplants were individually imaged; each scan included a phantom. Overall bone mineral density (BMD) of each transplant was obtained. Hematoxylin-eosin-stained sections of the same transplants were then examined histologically, which is the reference standard for assessing bone formation. The extent of bone in each transplant was scored on a semiquantitative scale ranging from 0 to 4 by three independent blinded observers; the bone score for each transplant was calculated by averaging the three observer scores. BMD was compared with the histologically determined bone score for each transplant. Statistical evaluations included (a) calculation of empiric receiver operating characteristic curves to determine optimum BMD thresholds and (b) determination of the relationship between BMD and bone score, including derivation of Pearson correlation coefficients.

RESULTS

One hundred twenty transplants were evaluated. Average BMD of 600 mg/cm3 K2HPO4 or more was noted in transplants with appreciable bone formation (bone score > or = 3), while average BMD of less than 600 mg/cm3 K2HPO4 was seen in transplants with poor bone formation (bone score < 3) (P <.001). Among transplants with appreciable bone formation, the BMD was proportional to the extent of mineralized matrix present in the new bone.

CONCLUSION

Use of quantitative CT offers a practical approach for the noninvasive determination of new bone formation in mineralizing bone marrow stromal cells and HA-TCP transplants.

Estimation of femoral head bone density using magnetic resonance imaging: comparison between men with and without hip osteoarthritis

Bone changes are thought to be one important etiological element in the pathogenesis of hip osteoarthritis (OA). The magnetic resonance imaging (MRI)-derived T2* relaxation time has been shown to provide information about bone mineral status of the femoral neck. The aim of this study was to test the hypothesis that the MRI-derived T2* relaxation time of the proximal femur in hip OA differs from that seen in healthy subjects. Based on the American College of Rheumatology criteria regarding classification of the OA of the hip, 27 men (aged 47-64 yr) with unilateral or bilateral hip OA and 30 age-matched randomly selected healthy men were studied. Bone mineral density (BMD), bone mineral content (BMC), and bone width of the femoral neck were measured with dual-energy X-ray absorptiometry (DXA). Subsequently, T2* measurements were performed with a 1.5-T scanner (Siemens Magnetom 63SP; Erlangen, Germany). A single 10-mm-thick coronal slice was generated on the femur, with a repetition time of 60 ms and nine echo times (4-20 ms) to derive T2* values. T2* measurements were performed from the different region of interests (ROIs) from the femoral neck and head. T2* relaxation times showed significant negative correlations with BMC, BMD (r = -0.401 to -0.794; p < 0.05-0.001). T2* relaxation time values revealed no significant differences between the groups in the femoral neck and in the head of the femur, whereas it was 12% lower (p < 0.01) in OA subjects than in controls in acetabulum. There were no significant differences in the T2* relaxation time values between the radiographic OA subgroups. Our findings suggest that hip OA is not associated with an increase of BMD in the femoral neck or in the head of the femur.

The X-ray attenuation characteristics and density of human calcaneal marrow do not change significantly during adulthood

Changes in the material characteristics of bone marrow with aging can be a significant source of error in measurements of bone density when using X-ray and ultrasound imaging modalities. In the context of computed tomography, dual-energy computed techniques have been used to correct for changes in marrow composition. However, dual-energy quantitative computed tomography (DE-QCT) protocols, while increasing the accuracy of the measurement, reduce the precision and increase the radiation dose to the patient in comparison to single-energy quantitative computed tomography (SE-QCT) protocols. If the attenuation properties of the marrow for a particular bone can be shown to be relatively constant with age, it should be possible to use single-energy techniques without experiencing errors caused by unknown marrow composition. Marrow was extracted by centrifugation from 10 mm thick frontal sections of 34 adult cadaver calcanei (28 males, 6 females, ages 17-65 years). The density and energy-dependent linear X-ray attenuation coefficient of each marrow sample were determined. For purposes of comparing our results, we then computed an effective CT number at two GE CT/i scan voltages (80 and 120 kVp) for each specimen. The coefficients of variation for the density, CT number at 80 kVp and CT number at 120 kVp were each less than 1%, and the parameters did not change significantly with age (p > 0.2, r2 < 0.02, power > 0.8 where the minimum acceptable r2 = 0.216). We could demonstrate no significant gender-associated differences in these relationships. These data suggest that calcaneal bone marrow X-ray attenuation properties and marrow density are essentially constant from the third through sixth decades of life.

Comparison of DXA and MRI methods for interpreting femoral neck bone mineral density

The aim of the study was to improve the practical implementation of the dual X-ray absorptiometry (DXA) by converting the areal bone mineral density BMD (BMD(areal)) to volumetric BMD using magnetic resonance (MR) imaging (MRI) because a failure to control for the femoral neck size can lead to erroneous interpretation of BMD values. We also evaluated the feasibility of MR T2* relaxation time in assessing bone mineral status of the femoral neck. Twenty-eight randomly selected 47- to 64-yr-old healthy men were studied. The men had neither unilateral nor bilateral hip osteoarthritis according to radiographs. Bone width, mineral content (BMC), BMD(areal), and apparent volumetric BMD (BMD(vol)) of the right femoral neck were measured with DXA. The BMD(vol) was calculated by approximating the femoral neck to be cylindrical with a circular cross-section (Vol(dxa)). Volumetric measurements from MR (Vol(mri)) images of the femoral neck were also used to create a BMD measure that was corrected for the femoral neck volume (BMD(mri)). T2* measurements were performed with a 1.5-T scanner (Siemens Magnetom 63SP, Erlangen, Germany). A single 10-mm-thick coronal slice was generated on the femur with a repetition time of 60 ms, and nine echo times (4-20 ms) were used to derive T2* values. Vol(mri) correlated positively (r = 0.828, p < 0.001) with Vol(dxa). However, the Vol(mri) of the femoral neck was 18% lower than the Vol(dxa). Similarly, the BMD(mri) was related to the BMD(vol) (r = 0.737, p < 0.001). Because of the difference in the volumetric measures, the BMD(mri) of the femoral neck was 21% higher than the BMD(vol) (p < 0.001). T2* relaxation time showed a significant negative correlation with BMC, BMD(areal), BMD(vol), and BMD(mri) (r = -0.423 to -0.757, p < 0.05-0.001). In conclusion, these results are evidence that DXA-derived volume approximations by the cylinder with circular cross-section geometry may lead to lower DXA-derived BMD(vol) values, as compared to true MRI-derived volumetric bone mineral density. Thus, the BMD(vol) may not be an accurate method to calculate the true volumetric BMD in the femoral neck. Our results also suggest that the MRI-derived T2* method may be used to approximate the BMD in the proximal femur.

Bone density determination

Bone mineral density determination is an integral part of the diagnosis, therapeutic planning, and monitoring of a patient with osteoporosis. Although the utility of measuring bone density seems intuitive, decisions must be made regarding whom to test, when to test, which technique to use, and which body site to evaluate. Once a determination has been made, consideration has to be given to what to do with the results. Each patient must be individually considered, incorporating genetic, nutritional, lifestyle, pharmacologic, and endocrine risk factors. Other diseases that may be associated with a reduced bone mass must be excluded.

Evaluation of dual-energy X-ray absorptiometry bone mineral measurement--comparison of a single-beam and fan-beam design: the effect of osteophytic calcification on spine bone mineral density

Dual energy X-ray absorptiometry (DXA) using a single-beam (SB) design is a well-established procedure for measuring bone mineral area density (BMD). Recently, fan beam (FB) techniques have become available to measure BMD. We evaluated the QDR1000 and QDR2000 densitometers with regard to precision and cross-compared values using single beam (SB) and FB techniques. To study the effect of osteoarthritic changes on bone measurement (BMC in g) and bone mineral area density (BMD in g/cm2), both parameters were measured in patients with and without osteophytic calcifications (OC) of the lumbar spine. Precision errors for BMD in vitro over 1 and 6 months using the QDR2000 were 0.4% and 0.6% for SB and 0.5% and 0.7% for the three FB modes. For QDR1000 only SB is available. Using this scan mode, the BMD difference (delta = 0.1%) in vitro between QDR1000 and QDR2000 was not significant. The short-term (same day) reproducibility of BMD in vivo was 0.85% for SB mode and 1.1% for FB scan mode (n = 33). The midterm (1 month) precision errors were 0.9% for SB and 1.5% for FB (n = 11). The spine BMD of 751 patients from our outpatient clinic and department of rheumatology was 1.7% lower with FB than with SB (0.878 +/- 0.137 versus 0.888 +/- 0.146 g/cm2). Lower (1.8%) BMD values were also found in the hip with FB compared to SB (0.805 +/- 0.111 versus 0.821 +/- 0.111 g/cm2). There was a highly significant (P < 0.00001) correlation between SB and FB on the spine (r = 0.99) and hip (r = 0.98) using the QDR2000. Correlations found QDR1000 and QDR2000 were lower on the spine (r = 0.97) and hip (r = 0.93).(ABSTRACT TRUNCATED AT 250 WORDS)