Active movement of cardiac myosin on Characeae actin cables

Mitochondrial colocalization with Ca2+ release sites is crucial to cardiac metabolism

In cardiomyocyte subcellular structures, colocalization of mitochondria with Ca2+ release sites is implicated in regulation of cardiac energetics by facilitating Ca2+ influx into mitochondria to modulate the tricarboxylic acid (TCA) cycle. However, current experimental techniques limit detailed examination of this regulatory mechanism. Earlier, we developed a three-dimensional (3D) finite-element cardiomyocyte model featuring a subcellular structure that integrates excitation-contraction coupling and energy metabolism. Here, using this model, we examined the influence of distance between mitochondria and Ca2+ release sites by comparing a normal (50-nm) distance model and a large (200-nm) distance model (LD). The influence of distance was minimal under a low pacing rate (0.25 Hz), but under a higher pacing rate (2 Hz), lower levels of mitochondrial Ca2+ and NADH, elevated phosphate, and suppressed force generation became apparent in the LD model. Such differences became greater when functional impairments (reduced TCA cycle activity, uncoupling effect, and failing excitation-contraction coupling) were additionally imposed. We concluded that juxtaposition of the mitochondria and the Ca2+ release sites is crucial for rapid signal transmission to maintain cardiac-energy balance. The idealized 3D model of cardiac excitation-contraction and metabolism is a powerful tool to study cardiac energetics.

Link between the enzymatic kinetics and mechanical behavior in an actomyosin motor

We have attempted to link the solution actomyosin ATPase with the mechanical properties of in vitro actin filament sliding over heavy meromyosin. To accomplish this we perturbed the system by altering the substrate with various NTPs and divalent cations, and by altering ionic strength. A wide variety of enzymatic and mechanical measurements were made under very similar solution conditions. Excellent correlations between the mechanical and enzymatic quantities were revealed. Analysis of these correlations based on a force-balance model led us to two fundamental equations, which can be described approximately as follows: the maximum sliding velocity is proportional to square root of V(max)K(m)(A), where K(m)(A) is the actin concentration at which the substrate turnover rate is half of its maximum (V(max)). The active force generated by a cross-bridge under no external load or under a small external load is proportional to square root of V(max)/K(m)(A). The equations successfully accounted for the correlations observed in the present study and observations in other laboratories.

Force-velocity relations of rat cardiac myosin isozymes sliding on algal cell actin cables in vitro

The difference in kinetic properties between two myosin isozymes (V1 and V3) in rat ventricular myocardium was studied by determining the steady-state force-velocity (P-V) relations in the ATP-dependent movement of V1 and V3-coated polystyrene beads on actin cables of giant algal cells mounted on a centrifuge microscope. The maximum unloaded velocity of bead movement was larger for V1 than for V3. The velocity of bead movement decreased with increasing external load applied by the centrifuge microscope, and eventually reached zero when the load was equal to the maximum isometric force (P0) generated by the myosin heads. The maximum isometric force P0 was less than 10 pN, and did not differ significantly between V1 and V3. The P-V curves consisted of a hyperbolic part in the low force range and a non-hyperbolic part in the high force range. The critical force above which the curve deviated from the hyperbola was much smaller for V1 than for V3. An analysis using a model with an extremely small number of myosin heads involved in the bead movement suggested a marked difference in kinetic properties between V1 and V3.

ADP inhibits the sliding velocity of fluorescent actin filaments on cardiac and skeletal myosins

We studied the effect of MgADP on the mechanical interaction of actomyosin in cardiac and skeletal muscles using an in vitro motility assay. The sliding velocities of fluorescently labeled actin filaments on rat cardiac and skeletal myosins were measured at various MgATP and MgADP concentrations. The filament velocity depended on MgATP concentration according to classic Michaelis-Menten kinetics with apparent Michaelis constants (Km) of 43 and 137 mumol/L and maximum velocity of 5.6 and 8.6 microns/s for cardiac and skeletal myosins, respectively. The presence of 2 mmol/L MgADP decreased the filament velocity and shifted the substrate concentration dependence of the velocity toward higher MgATP concentrations, yielding the inhibition constants of 194 and 478 mumol/L for cardiac and skeletal myosins, respectively. The activation energies determined by the temperature dependence of the velocity were 61 and 83 kJ/mol for rat V1 and rabbit cardiac myosins, which were similar to those of the dissociation rate constant of actomyosin-ADP complex reported in a solution study. The inhibition of the velocity by MgADP can be explained by the crossbridge scheme in which MgADP competes with MgATP for the substrate site on myosin molecules. In cardiac myosin, addition of a concentration of MgADP as low as 25 mumol/L significantly inhibited the velocity in the presence of 2 mmol/L MgATP, suggesting that increased intracellular MgADP may reduce the rate of crossbridge detachment, resulting in a decreased ATP consumption and an increased economy of force production under ischemic conditions. The present results support the idea that MgADP may be a physiologically important modulator of contraction in cardiac muscle.

Dynamic interaction between cardiac myosin isoforms modifies velocity of actomyosin sliding in vitro

To study the functional significance of cardiac isomyosin heterogeneity, active sliding of actin-myosin was studied using two different types of in vitro motility assay systems: (1) a sliding actin filament assay, in which fluorescently labeled actin filaments were made to slide on a myosin layer attached to a glass coverslip, and (2) a myosin-coated bead assay, in which myosin-coated latex beads were made to slide on actin cables of an alga. Two different isomyosins were obtained from 3-week-old (V1) and hypothyroid (V3) rat hearts and were mixed to form solutions with various mixing ratios [V1/(V1 + V3)]. For these myosin mixtures, both ATPase activity and sliding velocity of actin-myosin were determined. As the relative content of V1 increased, both ATPase activity and velocity increased. However, in contrast to the linear relation between the mixing ratio and ATPase activity, the relation between the mixing ratio and sliding velocity was sigmoid, suggesting the existence of mechanical interaction between different isomyosins. To clarify the nature of this interaction, sliding velocity was measured for mixtures of V1 and p-N,N'-phenylene-dimaleimide-treated V1 myosin (pPDM-M). A convex relation was observed between the relative content of pPDM-M and velocity. Because pPDM-M is known to form a noncycling and weakly bound crossbridge with actin, it is expected to exert a constant internal load on V1, in contrast to the actively cycling V3. In conclusion, in actomyosin sliding, different isomyosins mechanically interact when they coexist. The interaction may be a dynamic one that cannot be explained by a simple load effect.

Depressed sliding velocity of isolated cardiac myosin from cardiomyopathic hamsters: evidence for an alteration in mechanical interaction of actomyosin

We measured the relative sliding velocity of cardiomyopathic hamster cardiac myosin on actin cables by using an in vitro motility assay system. We also investigated the relationship between the velocity and both myosin isozyme content and ATPase activity. Cardiac myosin was obtained from cardiomyopathic hamsters (BIO 14.6; B) aged 3, 6, 9, and 18 months and age-matched controls (F1B; F). Long well-organized actin cables of an alga, Nitellopsis, were used for the motility assay. Small latex beads (2 microns in diameter) were coated with purified cardiac myosin. When myosin-coated beads were introduced into an algal cell in the presence of Mg-ATP, myosin interacted with actin and dragged the beads. Active movement of the beads along the actin cables was observed under a photomicroscope and the velocity was measured. The velocity was significantly lower in B than in F for each age group (0.47 vs. 0.71 microns/s at the age of 3 months, p < 0.05; 0.44 vs. 0.88 microns/s at 6 months, p < 0.01; 0.44 vs. 0.67 microns/s at 9 months, p < 0.01; 0.35 vs. 0.52 microns/s at 18 months, p < 0.05). Both Ca(2+)-activated ATPase activity and the percentage of alpha-myosin heavy chain were also lower in B than in F for each age group. When examined for individual specimens, there was a positive correlation between the velocity and both myosin Ca(2+)-activated ATPase activity (r = 0.84) and percentage of alpha-myosin heavy chain (r = 0.83). These data points of both control and cardiomyopathic hamsters were distributed near the regression line obtained from control and thyroxine-treated rabbits reported previously. The present results indicate that the difference in mechanical properties between control and cardiomyopathic cardiac myosin is attributed to isozyme redistribution and not to a qualitative change in each myosin molecule.