Characterization of the precolumn bio trap 500 C18 for direct injection of plasma samples in a column-switching system

Miniaturization in sample treatment for environmental analysis

The increasing demand for faster, more cost-effective and environmentally friendly analytical methods is a major incentive to improve the classical procedures used for sample treatment in environmental analysis. In most classical procedures, the use of rapid and powerful instrumental techniques for the final separation and detection of the analytes contrasts with the time-consuming and usually manual methods used for sample preparation, which slows down the total analytical process. The efforts made in this field in the past ten years have led to the adaptation of existing methods and the development of new techniques to save time and chemicals, and improve overall performance. One route has been to develop at-line or on-line and, frequently, automated systems. In these approaches, miniaturization has been a key factor in designing integrated analytical systems to provide higher sample throughput and/or unattended operation. Selected examples of novel developments in the field of miniaturized sample preparation for environmental analysis are used to evaluate the merits of the various techniques on the basis of published data on real-life analyses of trace-level organic pollutants. Perspectives and trends are briefly discussed.

Influence of various biological matrices (plasma, blood microdialysate) on chromatographic performance in the determination of beta-blockers using an alkyl-diol silica precolumn for sample clean-up

A HPLC column-switching system with LiChrospher RP-8 ADS precolumn was applied for the determination of beta-blockers (atenolol, pindolol, propranolol) in human plasma. The influence of biological matrices on the changes of the chromatographic parameters such as retention time, peak symmetry, area and selectivity were investigated. After injection of 5 ml plasma a decrease of retention times of the analytes was observed of up to 25% and an increase of asymmetry factors of up to 5%. Peak areas and selectivities were not changed. The observed effect could indicate changes of chromatographic performance caused by contributions of the analytical column or the ADS precolumn. The experiments with microdialysis excluded the contribution of the analytical column. A detailed investigation of experiments have been discussed in this paper.

Methylcellulose-immobilized reversed-phase precolumn for direct analysis of drugs in plasma by HPLC

We evaluated a new restricted access media (RAM) precolumn for direct analysis of drugs in plasma using a column switching HPLC system. The new RAM material was prepared by the modification of the external surface of porous silica with hydrophilic methylcellulose (MC), followed by modification of the internal surface with octadecylsilane (ODS). The external surface of the MC-immobilized ODS silica material (MC-ODS) suppressed the adsorption of proteins, while the internal surface of MC-ODS retained various types of drugs, such as ketoprofen, propranolol, caffeine and atenolol in plasma samples. In addition, MC-ODS allowed direct analysis of drugs in a 1000-microL plasma sample to monitor trace amounts of analytes contained. Reduced efficiency and clogging of the MC-ODS precolumn and/or the analytical column were not observed even after the repetitive injection of plasma sample up to 40 mL. Our results indicated that the MC-ODS precolumn could be used in pharmacodynamic and clinical studies.

Quantitation of entacapone glucuronide in rat plasma by on-line coupled restricted access media column and liquid chromatography-tandem mass spectrometry

A column-switching liquid chromatography-electrospray ionization-tandem mass spectrometric (LC-ESI-MS-MS) method was developed for the direct analysis of entacapone glucuronide in plasma. The plasma samples (5 microl) were injected onto a C18-alkyl-diol silica (ADS) column and the matrix compounds were washed to waste with a mixture of 20 mM ammonium acetate solution at pH 4.0-acetonitrile (97:3). The retained analyte fraction containing (E)- and (Z)-isomers of glucuronides of entacapone and tolcapone glucuronide (internal standard) was backflushed to the analytical C18 column, with a mixture of 20 mM ammonium acetate-acetonitrile (85:15) for the final separation at pH 7.0. The eluate was directed to the mass spectrometer after splitting (1:100). The mass spectrometer was operated in the negative ion mode and the deprotonated molecules [M-H]- were chosen as precursor ions for the analytes and internal standard. Collisionally induced dissociation of [M-H] in MS-MS resulted in loss of the neutral glucuronide moiety and in the appearance of intensive negatively charged aglycones [M-H-Glu]-, which were chosen as the product ions for single reaction monitoring. Quantitative studies showed a wide dynamic range (0.0025-100 microg/ml) with correlation coefficients better than 0.995. The method was repeatable within-day (relative standard deviation, RSD<7%) and between-day (RSD<14%) and the recovery (78-103%) was better than with the traditional, laborious pretreatment method. The use of tandem mass spectrometry permitted low limits of detection (1 ng/ml of entacapone glucuronide). The method was applied for the quantitation of (E)- and (Z)-isomers of entacapone glucuronide in plasma of rats used in absorption studies.

Solid-phase extraction: method development, sorbents, and coupling with liquid chromatography

The objective of this review is to provide updated information about the most important features of the new solid-phase extraction (SPE) materials, their interaction mode and their potential for modern SPE. First, the recent developments are given in formats, phases, automation, high throughput purpose and set-up of new types of procedures. Emphasis is then placed on the large choice of sorbents for trapping analytes over a wide range of polarities, such as highly cross-linked copolymers, functionalized copolymers, graphitized carbons or some specific n-alkylsilicas. The method development is given which is based on prediction from liquid chromatographic retention data or solvation parameters in order to determine the main parameters of any sequence (type and amount of sorbent, sample volume which can be applied without loss of recovery, composition and volume of the clean-up solution, composition and volume of the desorption solution). Obtaining extracts free from matrix interferences in a few steps--one step when possible--is now included in the development of SPE procedure. New selective phases such as mixed-mode and restricted access matrix sorbents or emerging phases such as immunosorbents or molecularly imprinted polymers are reviewed. Selectivity obtained by combining two sorbents is described with the use of ion-exchange or ion-pair sorbents. Special attention is given to complete automation of the SPE sequence with its on-line coupling with liquid chromatography followed by various detection modes. This represents a fast, modern and reliable approach to trace analysis. Many examples illustrate the various features of modern SPE which are discussed in this review. They have been selected in both biological and environmental areas.