Chiral separation of chloroquine and pemoline by capillary zone electrophoresis with sulfobutyl ether β-cyclodextrin as buffer additive

Antimalarial analysis of pharmaceutical formulations and biological samples by capillary electrophoresis: the state of the art and applications

Malaria is a serious public health problem, being an endemic disease in 84 countries, mainly in Africa. This review explores the application of capillary electrophoresis (CE) techniques for analyzing antimalarial drugs, highlighting methods from 2000 to 2023 for the analysis of pharmaceutical formulations and human biological samples. The versatility, selectivity, high efficiency, cost-effectiveness, and high analytical frequency of CE techniques have become attractive choices for pharmaceutical analysis, focusing on quality control and impurity analysis applications. The evolution of achiral and chiral electromigration methods has been described based on the features of each mode of separation: capillary zone electrophoresis (CZE), micellar electrokinetic chromatography, microemulsion electrokinetic chromatography, and capillary electrochromatography. As expected, CZE is reported in most articles owing to its compatibility with drug properties and separation mode. However, it is necessary to perform other separation modes for a few drugs that are present in neutral form. After exhaustive research using different databases and statistical analyses, 27 articles using CE techniques for antimalarial drug analysis were found and are mentioned in this review.

Conductometric and indirect AAS determination of antimalarials

Two methods are described for the determination of amodiaquine hydrochloride, chloroquine phosphate and primaquine phosphate, based on the formation of their ion-associates with [Cd(2+), Co(2+), Mn(2+) and Zn(2+)] thiocyanate, ammonium reineckate and/or sodium cobaltinitrite. The molar combining ratio reveal that (1:1) (drug:reagent) ion associates are formed for all reagents except for ammonium reineckate which form (1:2) ion associates with all studied drugs. The optimum conditions for the ion-association have been studied. Conductometric method was applied for the direct determination of the suggested drugs in bulk powders, whereas indirect atomic absorption spectrometric method, depending on the measurement of the excess metal ion present in supernatant solutions after precipitation of the ion associates is used to calculate the drug concentration. Optimum concentration ranges for the determination of aminoquinoline antimalarial drugs under consideration were 0.46-12.90 and 0.155-3.87 mg using conductometric and indirect atomic absorption spectral methods, respectively. The proposed procedures have been applied successfully to the analysis of these drugs in certain formulations and the results are favourably comparable to the official methods.

Chiral separation of pemoline enantiomers by cyclodextrin-modified micellar capillary chromatography

Micellar electrokinetic chromatography (MEKC) was successfully applied to the chiral separation with the addition of cyclodextrins (CDs) as chiral selector to running buffer. Chiral separation depended on the type of CDs. Mono-3-O-phenylcarbamoyl-beta-CD was effective for the chiral separation of pemoline. We investigated the type and concentration of CD and other parameters such as buffer pH, the concentration of SDS and the effect of organic modifier. The conditions for enantiomeric separation of pemoline were as follows: 40 mmol/l borate buffer at pH 9.0 with 40 mmol/l SDS, 20 mmol/l mono-3-O-phenylcarbamoyl-beta-CD and 10% 2-propanol. Baseline separation (Rs=2.21) of pemoline can be achieved.

Sol-gel technique for the preparation of beta-cyclodextrin derivative stationary phase in open-tubular capillary electrochromatography

A novel open-tubular capillary electrochromatography (OT-CEC) column coated with 2,6-dibutyl-beta-cyclodextrin (DB-beta-CD) was prepared using sol-gel technique. In the sol-gel approach, owing to the three-dimensional network of sol-gel and the strong chemical bond between the stationary phase and the surface of capillary columns, good chromatographic characteristics and unique selectivity in separating isomers were shown. We achieved high efficiencies of 5-14 x 10(4) plates/m for the isomeric nitrophenols using the sol-gel-derived DB-beta-CD columns. The migration time reproducibility of the separation of the isomeric nitrophenols was better than 2.2% over five runs and 4.5% from column to column. These sol-gel-coated DB-beta-CD columns have shown improved separations of isomeric aminophenols, isomeric dihydroxybenzenes and isomeric nitrophenols, in comparison with the sol-gel matrix capillary column. The influences of buffer pH and methanol solvent on separation were investigated. The chiral resolution of enantiomers such as ibuprofen and binaphthol was explored primarily.

Experimental verification of a predicted, hitherto unseen separation selectivity pattern in the nonaqueous capillary electrophoretic separation of weak base enantiomers by octakis (2,3-diacetyl-6-sulfato)-gamma-cyclodextrin

The capillary electrophoretic separation of cationic enantiomers with single-isomer multivalent anionic resolving agents was reexamined with the help of the charged resolving agent migration model. Three general model parameters were identified that influence the shape of the separation selectivity and enantiomer mobility difference curves: parameter b, the binding selectivity (K(RCD)/K(SCD)), parameter s, the size selectivity (mu0(RCD)/mu0(SCD)), and parameter a, the complexation-induced alteration of the analyte's mobility (mu0(RCD)/mu0). In addition to the previously observed discontinuity in separation selectivity that occurs as mu(eff) of the less mobile enantiomer changes from cationic to anionic, a new feature, a separation selectivity maximum was predicted to occur in the resolving agent concentration range where both enantiomers migrate cationically provided that (i) K(RCD)/K(SCD) <1 and mu0(RCD)/mu0(SCD) >1 and (K(RCD)mu0(RCD))/(K(SCD)mu0(SCD)) > 1, or (ii) K(RCD)/K(SCD) >1 and mu0(RCD)/mu0(SCD) <1 and (K(RCD)mu0(RCD))/(K(SCD)mu0(SCD)) <1. This hitherto unseen separation selectivity pattern was experimentally verified during the nonaqueous capillary electrophoretic separation of the enantiomers of four weak base analytes in acidic methanol background electrolytes with octakis(2,3-diacetyl-6-sulfato)-gamma-cyclodextrin (ODAS-gammaCD) as resolving agent.

Enantioselective determination by capillary electrophoresis with cyclodextrins as chiral selectors

This review surveys the separation of enantiomers by capillary electrophoresis using cyclodextrins as chiral selector. Cyclodextrins or their derivatives have been widely employed for the direct chiral resolution of a wide number of enantiomers, mainly of pharmaceutical interest, selected examples are reported in the tables. For method optimisation, several parameters influencing the enantioresolution, e.g., cyclodextrin type and concentration, buffer pH and composition, presence of organic solvents or complexing additives in the buffer were considered and discussed. Finally, selected applications to real samples such as pharmaceutical formulations, biological and medical samples are also discussed.

Enantioseparation of atropine by capillary electrophoresis using sulfated beta-cyclodextrin: application to a plant extract

A capillary zone electrophoresis (CZE) method, with sulfated beta-CD as chiral selector, was optimized by means of an experimental design for the enantioseparation of atropine. In this study, a central composite design was used and the following factors were varied simultaneously: buffer concentration, buffer pH and sulfated beta-CD concentration. The resolutions between littorine and its positional isomer ((-)-hyoscyamine) and between atropine enantiomers, as well as the separation time and generated current were established as responses. A model was obtained for each response by linear multiple regression of a second-degree mathematical expression. The most favorable conditions were determined by maximizing the resolution between atropine enantiomers and by setting the other responses at threshold values. Successful results were obtained with a 55 mM phosphate buffer at pH 7 in the presence of 2.9 mM sulfated-beta-CD at 20 degrees C and 20 kV. Under these optimized conditions, a baseline separation of littorine and atropine enantiomers was achieved in less than 5 min. Finally, the method allowed the enantiomeric separation of atropine in a pharmaceutical formulation and was also found to be suitable for the enantiomeric purity evaluation of (-)-hyoscyamine in plant extracts, in relation with the extraction procedure. It was demonstrated that supercritical fluid extraction induced less racemization than classical liquid-solid extraction procedures.