Investigations on analyte losses in systems suited for large-volume on-column injections

Injectors for capillary gas chromatography and their application to environmental analysis

The application of different injectors in capillary gas chromatography (GC) analysis of semi-volatile organic contaminants in environmental samples prepared in organic solvents is reviewed. The injectors examined include a split/splitless injector in splitless mode (SS), cold on-column (COC), and programmable temperature vaporizer (PTV) and adaptations of these injector designs. Key issues when selecting an injector include properties of the analyte, such as potential for thermal degradation or discrimination of high boiling point compounds within the injector, and the ability of the GC systems to handle large volume injections (LVI) primarily to lower detection limits and allow direct coupling with sample preparation techniques such as at-line or on-line solid phase extraction (SPE). LVI also require consideration of matrix interference issues. This review examines only injector chamber modifications that are feasible with a standard GC configuration, however some modifications to the chromatographic system to extend the range of applicability of gas chromatography analysis for environmental samples are also noted.

Role of the retaining precolumn in large-volume on-column injections of volatiles to gas chromatography

In the present study the retaining precolumn, which is commonly used in a set-up for large-volume on-column injections, or when solid-phase extraction (SPE) or liquid chromatography is coupled to gas chromatography (CC), was removed after varying its length from the standard length of 3 m down to zero. A dramatic increase of the evaporation rate of the injected organic solvent was obtained from a typical value of 100 microl/min up to 300 microl/min. The increased evaporation rate allowed (i) injection of a larger volume in the same retention gap, (ii) faster injection/transfer of the organic solvent and (iii) reduction of the transfer temperature. As volatile compounds under partially concurrent solvent evaporation conditions are easily lost once the organic solvent has been removed via a solvent-vapour exit (SVE), the parameters for large-volume injection, i.e. the evaporation rate and injection speed, were optimised using accurate measurements of the real flow-rate of the carrier gas into the GC system. All these options have been evaluated over the last 4 years. In order to demonstrate that omitting the retaining precolumn had no effect on the application range of the on-column interface, analytes as volatile as benzene were injected into GC-MS using 50-200 microl of n-pentane solutions. Contaminants were extracted from river water and wastewater into n-pentane using in-vial liquid-liquid extraction. The detection limits for benzene, toluene, ethylbenzene and m-xylene were approximately 10 ng/l. To obtain optimum results the SVE had to be closed 1 s before the end of evaporation. Several brands of n-pentane were analysed to check for the presence of benzene. Most of them contained interfering compounds and benzene at the low microg/l level and therefore had to be cleaned by means of column chromatography. As another example C8-C17 alkylphenones were extracted from wastewater with n-hexane. Detection limits were 10-40 ng/l.