Ion-trap versus quadrupole for analysis of quaternary ammonium herbicides by LC-MS

Modified Screen-Printed Potentiometric Sensors based on Man-Tailored Biomimetics for Diquat Herbicide Determination

Screen-printed platforms integrated with molecularly imprinted polymers (MIP) were fabricated and characterized as potentiometric sensors for diquat (DQ). The synthesized MIP beads were studied as sensory carriers in plasticized poly(vinyl chloride) membranes. The sensors were constructed by using poly(3,4-ethylenedioxythiophene) (PEDOT) as solid-contact material to diminish charge-transfer resistance and water layer potential. Conventional ion-selective electrodes (ISEs) with internal filling solution were used for comparison. The designed electrodes showed near Nernstian slopes of 28.2 ± 0.7 (r² = 0.999) over the concentration range of 1.0 × 10-6-1.0 × 10-2 M with the limit of detection 0.026 µg/mL over the pH range 4.2-9.0. The electrode exhibited good selectivity for diquat cations over a large number of organic and inorganic cations. The sensor was successfully introduced for direct measurement of diquat content in commercial pesticide preparations and different spiked potato samples. The results showed that the proposed electrode has a fast and stable response, good reproducibility, and applicability for direct assessment of diquat content. The proposed potentiometric method is simple and accurate in comparison with the reported HPLC methods. Besides, it is applicable to turbid and colored sample solutions.

Emerging Lyngbya wollei toxins: A new high resolution mass spectrometry method to elucidate a potential environmental threat

Mass spectrometric methods for the quantitative and qualitative analyses of algal biotoxins are often complicated by co-eluting compounds that present analytically as interferences. This issue is particularly critical for organic polyamines, where co-eluting materials can suppress the formation of cations during electrospray ionization. Here we present an extraction procedure designed specifically to overcome matrix-derived ion suppression of algal toxins in samples of Lyngbya wollei, a filamentous benthic algae known to produce several saxitoxin analogues. Lyngbya wollei samples were collected from a large, persistent harmful algal bloom in Lake Wateree, SC. Six known Lyngbya wollei-specific toxins (LWT1-6) were successfully resolved and quantified against saxitoxin using hydrophilic interaction liquid chromatography coupled with triple quadrupole and quadrupole time-of-flight mass spectrometry. The parent ions [M²⁺ - H⁺]⁺ were observed for LWTs 1-6 and the [M]²⁺ ion was observed for LWT5. High resolution mass spectra and unique fragmentation ions were obtained for LWTs 1-6. A dilution factor of 50 resulted in a linear calibration of saxitoxin in the algae matrix. Ion suppression was resolved by sample dilution, which led to linear, positive correlations between peak area and mass of the extracted sample (R² > 0.96). Optimized sample extraction method and instrument parameters are presented.

Solid-phase microextraction liquid chromatography/tandem mass spectrometry to determine postharvest fungicides in fruits

A method to determine five postharvest fungicides (dichloran, flutriafol, o-phenylphenol, prochloraz, tolclofos methyl) in fruits (cherries, lemons, oranges, peaches) has been developed using solid-phase microextraction (SPME) coupled to liquid chromatography (LC) with photodiode array (DAD), mass spectrometry (MS), or tandem mass spectrometry (MS/MS) with ion trap detection. Extraction involved sample homogenization with an acetone/water solution (5:1), filtration, and acetone evaporation prior to fiber extraction. The pesticides were isolated with a fused-silica fiber coated with 50-microm Carbowax/template resin. The effects of pH, ion strength, sample volume, and extraction time were investigated, and their impact on the SPME-LC/MS was studied. Dynamic and static modes of desorption were compared and the variables affecting desorption processes in SPME-LC optimized. Static desorption provided the best recoveries and peak shapes. Recoveries at the limit of quantification (LOQ) levels were between 10% for prochloraz and 60% for o-phenylphenol, with relative standard deviations from 13.6% for prochloraz to 3.1% for o-phenylphenol. The versatility of the method was also exhibited by its excellent linearity in the concentration intervals between 0.0005 and 5 mg kg(-1) for dichloran and 0.01-10 mg kg(-1) for tolclofos methyl and prochloraz. LOQs ranged from 0.25 to 1 microg g(-1) using DAD, from 0.002 to 0.01 microg g(-1) using LC/MS, and from 0.0005 to 0.01 to microg g(-1) using LC/MS/MS. LOQs obtained in the present study using LC/MS and LC/MS/MS are lower than maximum residue limits established for all the fungicides in any matrix studied. The method enables to determine polar pesticides at low-microgram per gram levels in fruits.

Environmental and food applications of LC-tandem mass spectrometry in pesticide-residue analysis: an overview

An overview is given on pesticide-residue determination in environmental and food samples by liquid chromatography/mass spectrometry/mass spectrometry (LC/MS/MS). Pesticides comprise a large number of substances that belong to many completely different chemical groups, the only common characteristic is that they are effective against pests. They still constitute a challenge in MS because there is no collective pathway for fragmentation. A brief introduction to the theory of tandem MS permits a discussion of which parameters influence the ionization efficiency when the ions are subjected to different actions. Emphasis is placed on the different tandem MS instruments: triple and ion-trap quadrupoles, and hybrid quadrupole time-of-flight (Q-TOF), including advantages and drawbacks, typical detection limits, and ion signals at low concentrations. The instrumental setup, as well as LC and mass spectrometric experimental conditions, must be carefully selected to increase the performance of the analytical system. The capacity of each instrument to provide useful data for the identification of pesticides, and the possibility to obtain structural information for the identification of target and non-target compounds, are discussed. Finally, sample preparation techniques and examples of applications are debated to reveal the potential of the current state-of-the-art technology, and to further promote the usefulness of tandem MS.

Capillary gas chromatography with atomic emission detection for pesticide analysis in soil samples

A method for the simultaneous determination of 10 pesticides (organochlorines, organophosphorus compounds, and pyrethrins) in soils using capillary gas chromatography with atomic emission detection (GC-AED) is reported. Soil samples are first "cleaned-up" with 25 mL of an ascorbic acid solution (pH 2.15). The aqueous phase is extracted with ethyl acetate, and the solid residue is then extracted twice with 10 mL of ethyl acetate. The three resultant organic extracts are combined, concentrated to dryness, and reconstituted in 1 mL of acetone. The pesticides are selectively detected by monitoring chlorine and bromine in the first run and sulfur emission line wavelength in the second run. Each chromatographic run takes 19 min. Detection limits are between 25 and 75 pg, depending on the compound, which corresponds to 1.7 and 5.0 ng/g in the soil samples, respectively. Recoveries of the pesticides from spiked preparations result in an overall mean recovery of 95.3% (n = 120) at fortification levels ranging from 10 to 60 ng/g, depending on the compound. The method is reliable and can be useful for routine monitoring in soils.

Analysis of the herbicides paraquat, diquat and difenzoquat in drinking water by micellar electrokinetic chromatography using sweeping and cation selective exhaustive injection

Optimum conditions for the determination of the herbicides paraquat, diquat and difenzoquat by micellar electrokinetic chromatography (MEKC) using sweeping and cation-selective exhaustive injection (CSEI) as on-line concentration methods were developed. Sodium dodecyl sulfate (80 mM) in 50 mM phosphate buffer (pH 2.5) with 20% acetonitrile was used as a background electrolyte for the methods studied. The limits of detection, based on a signal-to-noise ratio of 3:1, were about 2.6-5.1 mg 1(-1) in purified water when MEKC was applied for the standards. By using an on-line preconcentration method known as sweeping-MEKC, up to a 500-fold increase in detection sensitivity was obtained whereas up to a 50 000-fold increase for CSEI-sweeping-MEKC was achieved. The limits of detection using optimum CSEI-sweeping-MEKC were lower than 1 microg 1(-1) and the method was validated obtaining good reproducibility (relative standard deviation lower than 22%) and linearity. CSEI-sweeping-MEKC was successfully applied to the determination of the three herbicides in spiked tap water below the levels established by the US Environmental Protection Agency.