Development and validation of an improved liquid chromatographic method for the analysis of oxytetracycline

A Critical Review of Properties and Analytical Methods for the Determination of Oxytetracyline in Biological and Pharmaceutical Matrices

Antibiotics have an unquestionable importance in the treatment of many infections. Oxytetracycline is an antibiotic belonging to the class of tetracyclines, available for use in human and veterinary medicine. Development of analytical methods that prove the quality and efficacy of these drugs is fundamentally important to the pharmaceutical industry. In this context, the research presents an overview of the analytical profile of oxytetracycline, describing its chemical and pharmacological properties, and analytical methods for quantification of this drug in biological samples and pharmaceutical products. Oxytetracycline can be analyzed in these matrices by many types of methodologies. However, high-performance liquid chromatography is the most widely used, being recommended by official compendia. This kind of study can be useful to support the development of new efficient and sustainable analytical methods that may be utilized in the quality control routine of oxytetracycline in pharmaceutical products and pharmacokinetic monitoring in biological samples.

Statistical designs and response surface techniques for the optimization of chromatographic systems

This paper describes fundamentals and applications of multivariate statistical techniques for the optimization of chromatographic systems. The surface response methodologies: central composite design, Doehlert matrix and Box-Behnken design are discussed and applications of these techniques for optimization of sample preparation steps (extractions) and determination of experimental conditions for chromatographic separations are presented. The use of mixture design for optimization of mobile phases is also related. An optimization example involving a real separation process is exhaustively described. A discussion about model validation is presented. Some applications of other multivariate techniques for optimization of chromatographic methods are also summarized.

C18 columns for the simultaneous determination of oxytetracycline and its related substances by reversed-phase high performance liquid chromatography and UV detection

Simultaneous determination of oxytetracycline, 4-epioxytetracycline, alpha-apooxytetracycline, tetracycline and beta-apooxytetracycline on C(18) columns has been accomplished using a high performance liquid chromatographic method with UV detection. Separation was achieved on a Hypersil BDS RP-C(18) column (250 mm x 4.6 mm) and on a Waters C(18) Symmetry column (150 mm x 3.9mm), 5 microm particle size each. These columns were equilibrated with mobile phases consisted of methanol-acetonitrile-0.1M phosphate buffer pH 8.0 (12.5:12.5:75, v/v/v) and (15:15:70, v/v/v), respectively. The flow rate was 1.0 ml/min and the total elution time was 15 and 5 min, respectively. Both methods were applied to oxytetracycline raw material, human and veterinary formulations, where the excipients did not interfere. External standard calibration curves were linear for 4-epioxytetracycline, oxytetracycline, alpha-apooxytetracycline, tetracycline and beta-apooxytetracycline in the concentration range of 0.27-200 microM, 0.05-200 microM, 0.03-200 microM, 0.35-200 microM and 0.20-200 microM on column A and 0.08-200 microM, 0.15-200 microM, 0.09-200 microM, 0.25-200 microM and 0.47-200 microM on column B, respectively. Day-to-day relative standard deviation of the determination for every component was less than 3%. Concerning the first column, limits of detection and quantification of the above compounds were in the concentration ranges of 10-106 nM and 30-352 nM, respectively, whereas on the second column these ranges became 27-144 nM and 81-475 nM, respectively. Recovery of the separated compounds was 95-105%.

Improved LC of minocycline drug substance

An isocratic liquid chromatographic method is described for the separation of minocycline and its impurities. This method uses XTerra RP-18, 5 microm (25 cm x 4.6 mm I.D.), a silica-based stationary phase with reduced silanol activity. A mobile phase composed of acetonitrile-0.2 M tetrabutylammonium hydrogen sulphate pH 6.5-0.2 M ethylenediaminetetraacetic acid pH 6.5-water (20:20:20:40; v/v/v/v) was used at a flow rate of 1 ml/min. The column temperature was set at 35 degrees C. UV detection was performed at 280 nm. Optimisation of the separation method and a robustness study were performed by means of a central composite experimental design. The method allows to separate minocycline from known impurities. Some unidentified impurities are also separated. The total time of analysis is less than 20 min.

Evaluation of the stability of chlortetracycline in granular premixes by monitoring its conversion into degradation products

A methodology for the evaluation of the stability of chlortetracycline (CTC) in granular premixes is described. This methodology is based on the monitoring of the conversion of CTC into its degradation products by an improved gradient liquid chromatography (LC) method, based on one previously described by our laboratory. Sample preparation involves the extraction of CTC and its degradation products prior to LC analysis, using acidified methanol as extraction solvent. The gradient elution LC method proved to be very sensitive, especially towards the late eluting anhydro derivatives. The use of a Hypersil C8 BDS, 5 microm, 250 mm x 4.6 mm i.d. column is recommended since this column allowed a complete separation of the different impurities from each other and from the main component CTC. The applicability of this approach was demonstrated by the analysis of stability samples.