New membrane extraction cell for on-line analysis of VOCs or the simultaneous determination of VOCs and phenols in water

Use of flat-sheet membrane extraction with a sorbent interface for solvent-free determination of BTEX in water

An analytical method for solvent-free determination of benzene, toluene, ethylbenzene, and xylenes (BTEX) in water using flat-sheet membrane extraction with a sorbent interface (MESI) coupled to GC-MS was established by optimizing the flow rates of the donor (20 ml water) and acceptor (helium) phases and extraction temperature. BTEX compounds permeated through a nonporous silicone membrane and evaporated into the acceptor phase were purged into a cryofocusing trap (-30 °C) with helium gas. Enriched compounds were thermally desorbed into a capillary gas chromatograph and detected with a mass spectrometer. The optimum flow rates of the donor and acceptor phases were set at 1.5 and 55 ml min(-1), respectively, and the temperature of the membrane extraction module was maintained within the 28-30 °C range. The method as established showed low method detection limits (MDLs:∼0.1 μg l(-1)) and highly linear calibration curves (r(2)>0.998) for all of the four compounds. High repeatability (relative standard deviation <∼5%) and a reasonably high extraction recovery (62-78%), after a single pass of the sample through the extraction module, also were established. Further, the method's high compatibility with the purge and trap (P&T) method indicates its applicability to field measurement. Other advantages include rapidity, simplicity, and a ready extendibility to automated on-line monitoring.

Sample preparation for the analysis of volatile organic compounds in air and water matrices

This review summarizes literature data from the past 5 years on new developments and/or applications of sample preparation methods for analysis of volatile organic compounds (VOC), mainly in air and water matrices. Novel trends in the optimization and application of well-established airborne VOC enrichment techniques are discussed, like the implementation of advanced cooling systems in cryogenic trapping and miniaturization in adsorptive enrichment techniques. Next, focus is put on current tendencies in integrated sampling-extraction-sample introduction methods such as solid phase microextraction (SPME) and novel in-needle trapping devices. Particular attention is paid to emerging membrane extraction techniques such as membrane inlet mass spectrometry (MIMS) and membrane extraction with a sorbent interface (MESI). For VOC enrichment out of water, recent evolutions in direct aqueous injection (DAI) and liquid-liquid extraction (LLE) are highlighted, with main focus on miniaturized solvent extraction methods such as single drop microextraction (SDME) and liquid phase microextraction (LPME). Next, solvent-free sorptive enrichment receives major attention, with particular interest for innovative techniques such as stir bar sorptive extraction (SBSE) and solid phase dynamic extraction (SPDE). Finally, recent trends in membrane extraction are reviewed. Applications in both immersion and headspace mode are discussed.