Gas chromatographic behaviour of urea herbicides

Photo-induced Fluorescence of Fluometuron in a Continuous-flow Multicommutation Assembly

This paper deals with the photo-induced fluorimetric determination of the herbicide Fluometuron with the aid of a continuous-flow assembly of the emergent and new methodology known as Multicommutation which was provided with an on-line photoreactor. Maximum fluorescence intensity was observed at basic pH solutions, 1x 10(-4) mol l(-1) NaOH, after 1.4 min of irradiation and being the maximum at lambda(exc) 247.0 nm and lambda(em) 325.0 nm. The influence of different experimental parameters either chemical (pH, surfactants presence, solvent polarity and temperature) or hydrodynamic (time of photo-degradation, size and number of different segments and flow-rate) was tested. The linear dynamic range was from 0.01 to 4.0 mg l(-1) of Fluometuron; the inter-day reproducibility (as R.S.D.) of the slope was 0.001% and 1.7% from the peaks intra-day reproducibility. A large series of potential interferents was studied and finally the method was applied to human urine, soil, formulation and water samples.

Application of solid-phase microextraction for determining phenylurea herbicides and their homologous anilines from vegetables

Residues of metobromuron, monolinuron and linuron herbicides and their aniline homologous were analyzed in carrots, onions and potatoes by solid-phase microextraction (SPME) performed with a polyacrylate fiber. A juice was obtained from food samples that were further diluted, and an aliquot was extracted after sodium chloride (14%) addition and pH control. At pH 4 only the phenylureas were extracted. A new extraction at pH 11 allowed the extraction of phenylureas plus homologous aniline metabolites. Determination was carried out by gas chromatography with nitrogen-phosporus detection (NPD) the identity of the determined compounds was studied by gas chromatography-mass spectrometry. Limits of quantification (LOQs) obtained with NPD and MS (selected-ion monitoring) were in the microg/kg order allowing determination of maximum residue levels (MRLs) established in the Spanish regulations. MRLs ranged from 0.02 to 0.1 mg/kg depending on the kind of food and herbicide. Under the proposed conditions matrix effects were low enough to permit calibration with samples proceeding from ecological (non-pesticide treated) crops. Twelve commercial samples of each carrots, onions and potatoes were analyzed and only three samples of potatoes contained residues of linuron at levels below MRLs.

Direct determination of monolinuron, linuron and chlorbromuron residues in potato samples by gas chromatography with nitrogen–phosphorus detection

A gas chromatography with nitrogen-phosphorus detection direct method for methoxyurea herbicide determination in powdered potato and fresh potato samples has been developed. A previous study of the thermal stability of the phenylurea herbicides seems to confirm that the ones containing the methoxy radical, i.e. monolinuron, linuron and chlorbromuron, were stable. The herbicides were extracted from the sample through liquid-liquid extraction with dichloromethane-light petroleum (1:1), followed by solid-phase extraction in a C8 cartridge. The recoveries were in the range 84-95% for powdered potato and 86-101% for fresh potato. The RSD values were less than 10%, at 0.1 microg g(-1) concentration level (n = 4) for both types of samples. Detection limits of the method were 7.0-30 ng g(-1) for powdered potato and 6.0-50 ng g(-1) for fresh potato.