The influence of formulation and spacer device on the in vitro performance of solution chlorofluorocarbon-free propellant-driven metered dose inhalers

Valved Holding Chambers and In Vitro Metered Dose Inhaler Performance: Effects of Flow Rate and Inhalation Delay

BACKGROUND

Multiple factors may influence the performance of a metered dose inhaler (MDI) when used with a valved holding chamber (VHC or "spacer").

METHODS

Andersen Cascade Impactor measurements were conducted for three MDI products and two different VHCs using a specially designed system that accommodated variable delay times between MDI actuation and introduction of the aerosol into the impactor, and allowed reduced flow through the VHC while the impactor was operated at 28.3 L/min. Deposited drug mass and aerodynamic particle size distribution were determined using validated high-performance liquid chromatography (HPLC) methods. A two-level, three-factor full-factorial design of experiments (DOE) design was applied to assess the influences of VHC type, flow rate, and inhalation delay on a total of seven performance characteristics for each MDI product. An experiment without a VHC was added to assess the influence of VHC presence.

RESULTS

DOE study shows the presence and type of VHC are the major influences on emitted dose and respirable fraction. Following the VHC effect, the inhalation delay has the most significant influence on most MDI performance metrics-emitted dose, respirable particle dose and fraction (aerosols between 1.1 and 4.7 μm), and fine particle dose and fraction (aerosols under 4.7 μm).

CONCLUSION

This study illustrates the use of DOE analysis to effectively assess the effects of patient handling parameters (flow rate and inhalation delay) on the performance of MDI drugs when used with a VHC. The results of this study will inform Food and Drug Administration reviewers, the pharmaceutical industry, and healthcare practitioners as to safe and effective use of MDI products when used in conjunction with spacer devices.

Novel propellant-driven inhalation formulations: engineering polar drug particles with surface-trapped hydrofluoroalkane-philes

Challenges in reformulating pressurized metered-dose inhalers (pMDIs) with hydrofluoroalkane (HFA) propellants, and the potential of inhalation formulations for the delivery of drugs to and through the lungs have encouraged the development of novel suspension-based pMDI formulations. In this work we propose a new methodology for engineering polar drug particles with enhanced stability and aerosol characteristics in propellant HFAs. The approach consists in 'trapping' HFA-philic moieties at the surface of particles, which are formed using a modified emulsification-diffusion method. The trapped moieties act as stabilizing agents, thus preventing flocculation of the otherwise unstable colloidal drug particles. This approach has advantages compared to surfactant-stabilized colloids in that no free stabilizers remain in solution (reduced toxicity), and the challenges associated with the synthesis of well-balanced amphiphiles are circumvented. The methodology was tested by trapping polyethylene glycol (PEG) at the surface of particles of a model polar drug-salbutamol sulfate. Colloidal probe microscopy is used to quantitatively demonstrate the trapping of the HFA-phile at the surface, and the ability of PEG in screening particle-particle cohesive interactions. Both physical stability and the corresponding aerosol characteristics are significantly improved compared to those of a commercial formulation. The fine particle fraction of PEG-coated salbutamol sulfate was observed to be 42% higher than that of Ventolin HFA. The formation of stable dispersions of terbutaline hemisulfate using the same approach, suggests this to be a generally applicable methodology to polar drugs.