The elastic capacity of a tendon-repair construct influences the force necessary to induce gapping

The importance of plasmin for the healing of the anterior cruciate ligament

Aims

The anterior cruciate ligament (ACL) is known to have a poor wound healing capacity, whereas other ligaments outside of the knee joint capsule such as the medial collateral ligament (MCL) apparently heal more easily. Plasmin has been identified as a major component in the synovial fluid that varies among patients. The aim of this study was to test whether plasmin, a component of synovial fluid, could be a main factor responsible for the poor wound healing capacity of the ACL.

Methods

The effects of increasing concentrations of plasmin (0, 0.1, 1, 10, and 50 µg/ml) onto the wound closing speed (WCS) of primary ACL-derived ligamentocytes (ACL-LCs) were tested using wound scratch assay and time-lapse phase-contrast microscopy. Additionally, relative expression changes (quantitative PCR (qPCR)) of major LC-relevant genes and catabolic genes were investigated. The positive controls were 10% fetal calf serum (FCS) and platelet-derived growth factor (PDGF).

Results

WCS did not differ significantly among no plasmin versus each of the tested concentrations (six donors). The positive controls with PDGF and with FCS differed significantly from the negative controls. However, we found a trend demonstrating that higher plasmin concentrations up-regulate the expression of matrix metalloproteinase 13 (MMP13), 3 (MMP3), and tenomodulin (TNMD).

Conclusion

The clinical relevance of this study is the possibility that it is not solely the plasmin, but also additional factors in the synovial fluid of the knee, that may be responsible for the poor healing capacity of the ACL.

Cite this article: Bone Joint Res 2020;9(9):543–553.

Suture Tape Reduces Quadriceps Tendon Repair Gap Formation Compared With High-Strength Suture: A Cadaveric Biomechanical Analysis

PURPOSE

To compare the biomechanical differences between quadriceps tendon (QT) repair with high-strength suture (HSS) versus suture tape (ST) with varying number of suture passes.

METHODS

In total, 28 fresh-frozen QTs were randomized into 2 groups: (1) HSS; or (2) ST; specimens were then further randomized into subgroups of either 4 or 6 suture passes. Specimens were secured within a materials testing system and a 150-N preload was applied for 10 seconds followed by a cyclic loading protocol between 50 N and 250 N for 1000 cycles. Video was used to follow tracking markers used to calculate the magnitude of tendon displacement. Two-way univariate analysis of variance was used to determine the effect of suture type and passes on the displacement after preloading and mixed repeated-measures analysis of variance was used to determine the effect of suture type and passes on displacement following cyclic loading.

RESULTS

There were large increases in displacement following the preload across all conditions (7.82 ± 3.64 mm), with no statistically significant differences between groups. There was a significant difference in the mean (± standard deviation) displacement between the ST (5.24 ± 2.82 mm) and HSS (7.93 ± 2.91 mm) starting at 200 cycles, which became more pronounced with successive testing out to 1000 cycles (P = .021). There were no significant difference with respect to the number of suture or tape passes.

CONCLUSIONS

Following preloading at 150 N, significant displacement occurred in both QT repair groups. ST demonstrated significantly less displacement than HSS under cyclic loading and had greater ultimate failure loads.

CLINICAL RELEVANCE

When performing QT repair, emphasis should be placed on appropriate pretensioning of sutures to at least 150 N before knot-tying. In addition, where available, ST should be used over HSS to reduce further cyclic elongation and improve ultimate failure loads.