Improving radiographic patello-femoral tracking in total knee arthroplasty with the use of a flexion spacer: a case-control study

Spacer rotation technique allows precise evaluation of gap balance in total knee arthroplasty

The symmetry of the flexion and extension gap influences the functional and long-term outcome after total knee arthroplasty (TKA). Most surgeons check it by applying varus and valgus stress using spacers. This technique has limited accuracy and could be easily extended by rotational movement of the spacer. The objective was to determine the detection threshold and interobserver reliability of this technique. In an in vitro setting with a human cadaveric knee, gap asymmetries were simulated by different medially and laterally applied forces. Using an optical measurement system, the pivot point of the spacer was calculated as a function of the gap symmetry in the first part of the experiment. In the second part, the detection threshold and interobserver reliability of 4 surgeons were determined. For this purpose, gap asymmetries were adjusted to between 0 and 120N in a blinded trial. With a symmetrical gap, the centre of rotation of the spacer was located in the centre of the tibia. With increasing gap asymmetry, the centre of rotation of the spacer shifted to the tight side. This shift was approximately linearly dependent on the force difference. A perfectly balanced gap was detected by the examiners in 50% of the cases. From a force difference of 40N, all examiners identified the gap asymmetry in all cases (ICC = 1.0). The method of spacer rotation described is suitable for reliably detecting gap differences at ≥ 40N, independently of the examiner.

The effect of restored medial knee anatomy in total knee arthroplasty with the flexion first balancer technique on mid-flexion laxity and functional outcome

Background

The Flexion First Balancer (FFB) technique for total knee arthroplasty (TKA) was developed to maintain the isometry of the medial collateral ligament (MCL) by restoring the medial anatomy of the knee. Inability to correct MCL isometry could hypothetically result in an increased mid-flexion laxity. The aim of the current study was to evaluate if the FFB technique results in improved functional outcome and less mid-flexion laxity compared to Measured Resection (MR).

Methods

A cross-sectional study was performed comparing 27 FFB patients with 28 MR patients. Groups were matched for age, gender, BMI and ASA classification. All patient received the cruciate retained type, Vanguard Complete Knee System (Biomet Orthopedics, Warsaw, IN, USA). Stress X-rays of the knee with 30 degrees of flexion were made to assess varus-valgus laxity. Furthermore, three tests were conducted to asses functional outcome: a 6 min walk test, a stair climb test and quadriceps peak force measurements. Mean follow-up was respectively 2.6 (SD 0.4) and 3.9 years (SD 0.2).

Results

The MR group showed a postoperative elevation in joint line in contrast to the FFB group, the mean difference between the two groups was 3 mm (p < 0.001). No differences in total laxity between the two groups was found. The FFB group showed a higher quadriceps peak force (1.67 (SD 0.55) N/BMI) in comparison with the MR group (1.38 (SD 0.48) N/BMI) (p < 0.05). All other outcome parameters were comparable between the two groups (p: n.s.). Correlation analysis showed a moderate negative correlation between joint line elevation and quadriceps peak force (r = − 0.29, p < 0.05).

Conclusion

The FFB technique did not lead to less coronal laxity in the mid-flexion range compared to MR. Although peak quadriceps force was significantly higher for the FFB group no clinically relevant benefits could be identified for the patients with regards to functional outcome. Therefore, minor deviations in joint line seems to have no effect on functional outcome after TKA.

Trial registration

ISRCTN, ISRCTN85351296. Registered 23 april 2021 - Retrospectively registered, https://www.isrctn.com/ISRCTN85351296

Early results with a bicruciate-retaining total knee arthroplasty: a match-paired study

BACKGROUND

The aim of this study is to compare 2 groups of total knee arthroplasties (TKAs): the bicruciate-retaining (BCR-group) and cruciate-retaining total knee arthroplasty (CR-group), evaluating the functional results in the short-term follow-up.

METHODS

24 BCR were included in the study and were compared with a group of 24 TKAs performed with the same implant, but with sacrifice of the ACL and retention of the posterior cruciate ligament. For preoperative and postoperative clinical evaluation, the visual analogue score (VAS) and the Western Ontario and McMaster Universities Osteoarthritis Index (WOMAC) were used. Radiological evaluation included weight-bearing long-leg view, a Rosemberg view, lateral view of the knee and tangential view of the patella. Hip-knee-ankle angle (HKA) was recorded pre and postoperatively. Radiolucent lines (RLLs) were evaluated according the Knee Society Roentgenographic Evaluation System (KSRES).

RESULTS

At last follow-up the mean VAS score was 1.81 for BCR group and 1.43 for CR group (p = 0.61). The mean WOMAC score was 8.68 for BCR group and 12.81 for CR group (p = 0.33). As for the radiological evaluation, preoperative HKA angle was 0.53° varus for BCR group and 3.14° varus for CR group (p = 0.24); postoperative HKA was 0.72° valgus for BCR group and 0.38° valgus for CR group (p = 0.75). The percentage of RLLs was similar between the two groups (12% versus 15%).

CONCLUSIONS

BCR-TKA has showed to give similar functional and radiographic outcomes compared to conventional CR-TKA in a similar cohort of patients. An higher operative times and higher number of complications respect were found in BCR group. These results can be explained by the early learning curve experiences. Future randomized controlled trials should be performed to support new implant designs such as BCR.

LEVEL OF EVIDENCE

Level of evidence Case-control study, level III.