Hexafluoroisopropanol-mediated cloud point extraction of organic pollutants in water with analysis by high-performance liquid chromatography

Investigation of europium(III) uptake from highly sulphate solution via cloud point extraction by mono-Schiff base combined with Triton X-100

Owing to its unique physico-chemical properties, europium is one of the most precious and sought-after rare earth elements in the field of high technology. The major economic and commercial importance of such an element, combined with the pollution risks associated with its intensive use, require the development of efficient and eco-compatible recovery and recycling processes. This study focuses on the recovery of europium from highly saline sulphate media (0.5 mol/L) using an environmentally friendly two-phase aqueous extraction technique (known as cloud point extraction (CPE)), using 2((phenylimino)methyl)phenol mono-Schiff base (HPIMP) as the extractant and Triton X-100 as the non-ionic surfactant. The influence of key experimental parameters such as pH, extractant concentration, surfactant concentration and separation temperature on the europium extraction process was systematically studied and optimized. Under optimum experimental conditions, a quasi-quantitative extraction with a minimal volume fraction of surfactant-rich phase (φs = 0.025), and concentration factor of (CF = 38) was achieved at pH 9.8, in one stage. The analysis of the extraction data revealed that the CPE of europium(III) takes place by a cation exchange-solvation mechanism. The stoichiometry of the complex extracted into the surfactant-rich phase was ascertained to have a composition of 1:2 [Eu:HPIMP] with the slope analysis method. A higher extraction constant was obtained for CPE compared with conventional solvent extraction, confirming the feasibility and usefulness of CPE for Eu(III) recovery. On the other hand, this new HPIMP/Triton X-100 chelating system showed superior extractability for Eu(III) in the CPE process relative to other systems reported previously.

The Chemometric Evaluation of the Factors Influencing Cloud Point Extraction for Fluoroquinolones

This study aimed to analyze the factors that impact the cloud point extraction of ciprofloxacin, levofloxacin, and moxifloxacin. The following independent variables were analyzed: Triton X-114 concentration, NaCl concentration, pH, and incubation temperature. The dependent variable studied was recovery. A central composite design model was used. The applied quantitation method was HPLC. The method was validated for linearity, precision, and accuracy. The results underwent ANOVA^® analysis. The polynomial equations were generated for each analyte. The response surface methodology graphs visualized them. The analysis showed that the factor most affecting the recovery of levofloxacin is the concentration of Triton X-114, while the recovery of ciprofloxacin and moxifloxacin is most affected by pH value. However, the concentration of Triton X-114 also plays an important role. The optimization resulted in the following recoveries: for ciprofloxacin, 60%; for levofloxacin, 75%; and for moxifloxacin, 84%, which are identical to those estimated with regression equations-59%, 74% and 81% for ciprofloxacin, levofloxacin, and moxifloxacin, respectively. The research confirms the validity of using the model to analyze factors affecting the recovery of the analyzed compounds. The model allows for a thorough analysis of variables and their optimization.

Hydrophobic magnetic nanoparticle assisted catanionic surfactant supramolecular solvent microextraction of multiresidue antibiotics in water samples

A novel extraction technique i.e. hydrophobic magnetic nanoparticle (MNP)-assisted in situ supramolecular solvent (SUPRAS) microextraction was proposed, and it was applied for the analysis of sulfonamides (SAs) and fluoroquinolones (FQs) in aqueous samples, coupled with high performance liquid chromatography-UV detection (HPLC-UV). In this extraction method, hexafluoroisopropanol-mediated salt-free catanionic surfactant based SUPRAS in situ microextraction was initially carried out; then, the SUPRAS was quickly adsorbed by the hydrophobic magnetic nanoparticles and gathered by an external magnetic field. This can greatly shorten the separation time and overcome the dependence on centrifugation, and also perform a secondary extraction of free analytes (not extracted by SUPRAS) from water samples. The magnetic separation ability of different hydrophobic MNPs was evaluated by adsorbing supramolecular aggregates from the water sample. The effective parameters affecting the extraction efficiency of the analytes were investigated and optimized using the one variable at a time method. About 3 min was required to realize the extraction of analytes with an enrichment factor (EF) of 12-53 for SAs and 79-118 for FQs. Compared with the centrifugation-assisted SUPRAS microextraction, the hydrophobic MNP-assisted SUPRAS microextraction obtained much better extraction and preconcentration efficiency. The proposed novel extraction method with HPLC-UV provided LODs of 0.21-0.76 ng mL-1 for SAs and 0.10-0.18 ng mL-1 for FQs. Good linearity was obtained with correlation coefficients ranging from 0.9962 to 0.9999. The intra- and inter-day recoveries of the target antibiotics were in the range of 92.0-111.3% with RSD% below 10.4%. The method was successfully applied to determine SAs and FQs in real water samples, such as lake water, river water, reservoir water, and wastewater.

Twenty years of supramolecular solvents in sample preparation for chromatography: achievements and challenges ahead

Supramolecular solvents (SUPRAS) have progressively become a suitable alternative to organic solvents for sample preparation in chromatographic analysis. The inherent properties of these nanostructured solvents (e.g. different polarity microenvironments, multiple binding sites, possibility of tailoring their properties, etc.) offer multiple opportunities for the development of innovative sample treatment platforms not approachable by conventional solvents. In this review, major achievements attained in the combination SUPRAS-chromatography in the last 20 years as well as the challenges that should be addressed in the near future are critically discussed. Among achievements, particular attention is paid to the theoretical and practical knowledge gained that has helped make substantial progress in the area. In this respect, advances in the understanding of the mechanisms involved in SUPRAS formation and SUPRAS-solute interactions driving extractions are discussed, with a view to the setting up of knowledge-based extraction procedures. Likewise, the strategies followed to improve the compatibility of SUPRAS extracts with liquid and gas chromatography and adapt SUPRAS-based extractions to different formats are presented. Ongoing efforts to apply SUPRAS in multicomponent extractions and synthesize tailored SUPRAS for the development of innovative sample treatments are highlighted. Among challenges identified, discussion is focused on the automation of SUPRAS-based sample treatment and the elucidation of SUPRAS nanostructures, which are considered essential for their acceptance in routine labs and the design of tailored SUPRAS with programmed functions. Graphical abstract.

Organic Analysis of Environmental Samples Using Liquid Chromatography with Diode Array and Fluorescence Detectors: An Overview

This overview is focused to provide an useful guide of the families of organic pollutants that can be determined by liquid chromatography operating in reverse phase and ultraviolet/fluorescence detection. Eight families have been classified as the main groups to be considered: carbonyls, carboxyls, aromatics, phenols, phthalates, isocyanates, pesticides and emerging. The references have been selected based on analytical methods used in the environmental field, including both the well-established procedures and those more recently developed.

Hexafluoroisopropanol/Brij-35 based supramolecular solvent for liquid-phase microextraction of parabens in different matrix samples

A novel supramolecular solvent (SUPRAS) based on hexafluoroisopropanol (HFIP)/Brij-35 was proposed for liquid-phase microextraction (LPME) of parabens in water samples, pharmaceuticals and personal care products. Brij-35 is a cost-effective and non-toxic non-ionic surfactant, but it has a high cloud point (>100 °C). HFIP, with the features of strong hydrogen-bond donor, high density and powerful hydrophobicity, was used as the cloud point-reducing agent and self-assembling and density-regulating solvent of Brij-35. Upon adding HFIP into the Brij-35 aqueous solution, the cloud point of Brij-35 was decreased to below room temperature, and the SUPRAS was formed in the bottom over a wide range of HFIP and Brij-35 concentrations at room temperature. The SUPRAS was composed of Brij-35, HFIP and water, having a density larger than water, and it showed a large spherical structure of positive micellar aggregates (2-8 μm). The HFIP/ Brij-35 SUPRAS-based LPME procedure was non-thermodependent and could be performed at room temperature with centrifugation using normal centrifuge tubes, being very simple. In the extraction of six parabens, the HFIP/ Brij-35 SUPRAS-based LPME method showed short extraction time (3.3 min), low solvent consumption (0.3 mL), and large enrichment factor (26-193). The method of HFIP/ Brij-35 SUPRAS-based LPME with HPLC-DAD gave good linearity for the quantification of parabens with correlation coefficients larger than 0.9990. The limits of detection based on a signal-to-noise ratio of 3 were from 0.042 to 0.167 μg L^-1. The recoveries for the spiked real samples were in the range of 90.2-112.4% with relative standard deviation less than 8.9%. Except for tap water, one or several paraben (s) were detected in all the other real samples.