The role of comprehensive two-dimensional gas chromatography in mineral oil determination

Impact of deodorisation time and temperature on the removal of different MOAH structures: a lab-scale study on spiked coconut oil

Vegetable fats and oils are prone to contamination by mineral oil hydrocarbons due to the lipophilic and ubiquitous character of the latter. As the aromatic fraction of these hydrocarbons, MOAH, is associated with carcinogenicity, mutagenicity, and detrimental effects on foetal development, finding strategies to limit or reduce their contamination is highly relevant. Deodorisation (i.e. a refining step) has shown the ability to remove MOAH < C25 in vegetable fats and oils, but there is little information about the structures removed. Therefore, the present study investigated the impact of deodorisation conditions on the removal of different structures of MOAH in spiked coconut oil. An inscribed central composite design was built with time and temperature as variables (0.5-4h, 150-240 °C), while pressure (3 mbar) and steam flow (1 g water/g oil per hour) were kept constant. The analysis of MOAH in the oil was performed using a fully automated liquid chromatography coupled with two parallel comprehensive two-dimensional gas chromatography systems with flame ionisation and time-of-flight mass spectrometric detection. Response surfaces plotting the MOAH loss according to time and temperature were built for different MOAH fractions. The latter were defined based on the number of aromatic rings (>3 or ≤3) and the number of carbon atoms present (C16-C20, C20-C24, C24-C35, C35-C40). It was found that at 200 °C, compounds < C24, including weakly alkylated triaromatics, could be reduced to below the limit of quantification, while at 230 °C, it was possible to remove >60% of the C24-C35 fraction, including pentaromatics of low alkylation.

Advanced separation of mineral oil aromatic hydrocarbons by number of aromatic rings using donor-acceptor-complex chromatography to extend on-line coupled liquid chromatography-gas chromatography

An automated implementation for a subfractionation of mineral oil aromatic hydrocarbons (MOAH) into a mono-/di-aromatic fraction (MDAF) and a tri-/poly-aromatic fraction (TPAF) is presented, which is highly demanded by the European Food Safety Authority (EFSA) respecting the genotoxic and carcinogenic potential of MOAH. For this, donor-acceptor-complex chromatography (DACC) was used as a selective stationary phase to extend the conventional instrumental setup for the analysis of mineral oil hydrocarbons via on-line coupled liquid chromatography-gas chromatography-flame ionization detection (LC-GC-FID). A set of six new internal standards was introduced for the verification of the MOAH fractionation and a quantification of MDAF and TPAF, respectively. The automated DACC approach was applied to representative petrochemical references as well as to food samples, such as rice and infant formula, generally showing well conformity with results obtained by state-of-the-art analysis using two-dimensional GC (GCxGC). Relative deviations of DACC/LC-GC-FID compared to GCxGC-FID methods regarding the ≥ 3 ring MOAH content ranged between -50 and +6 % (median: -2 %, all samples, only values above limit of quantification). However, crucial deviations mainly result from "border-crossing" substances, e.g., dibenzothiophenes or partially hydrogenated MOAH. These substances can cause overestimations of ≥ 3 ring MOAH fraction during GCxGC analysis due to co-elution, which is mostly avoided using the DACC approach. Furthermore, the DACC approach can help to minimize underestimations of toxicologically relevant ≥ 3 ring MOAH caused by an unavoidable loss of MOAH during epoxidation, since natural olefins, such as terpenes, predominantly elute in MDAF, which was exemplarily shown for an olive oil and a terpene reference. The presented approach can be implemented easily in existing LC-GC-FID setup for an automated and advanced screening of MOAH to lower the need for elaborate GCxGC analysis also in routine environments.

Determination of mineral oil hydrocarbon contamination in Citrus essential oils by using on-line liquid-gas chromatography: critical aspects

The present manuscript reports and discusses critical issues related to the determination of mineral oil hydrocarbon contamination in Citrus essential oils (EOs); an on-line liquid-gas chromatography system equipped with a Y-interface was used (with no additional off-line step for pre-concentration). In total, eighteen samples were analyzed, specifically eleven cold-pressed (CP) and seven distilled EOs. With regard to the CP EOs, various degrees of mineral oil saturated hydrocarbon (MOSH) contamination were detected, ranging between 10.7 and 338.4 mg kg-1 (only one sample was MOSH-free); different MOSH sub-fractions were determined, with the  > C25- ≤ C35 sub-fraction always present, with an average concentration of 74.5 mg kg-1. Based on the EO composition, different sample amounts were injected to avoid the overloading of the LC column and consequently the GC one, thus leading to different limits of quantification (LoQ), which were either 2 mg kg-1 (for bergamot EO) or 5 mg kg-1 (for all the other investigated samples). For all samples, the mineral oil aromatic hydrocarbon level was always lower than the LoQ.