Utilization of pyrolytic substrate by microalga Chlamydomonas reinhardtii: cell membrane property change as a response of the substrate toxicity

Effects of polystyrene and triphenyl phosphate on growth, photosynthesis and oxidative stress of Chaetoceros meülleri

The toxicity of microplastics to marine organisms has attracted much attention; however, studies of their effects on marine microalgae remain limited. Here, the effects of the single and combined toxicity of polystyrene (PS) and triphenyl phosphate (TPhP) on the cell growth, photosynthesis, and oxidative stress of Chaetoceros meülleri were investigated. PS inhibited growth of the algae cells and caused a dose-dependent effect on oxidative stress. The significantly high production of reactive oxygen species (ROS) induced severe cell membrane damage, as confirmed by high fluorescence polarization. However, there was no obvious decrease in chlorophyll a content, and 80 mg/L of PS significantly promoted chlorophyll a synthesis. The TPhP also inhibited cell growth, except at low concentrations (0.2-0.8 mg/L), which stimulated algae growth over 48 h. Moreover, no obvious decrease in chlorophyll a and maximal photochemical efficiency of PSII was found in the TPhP experimental groups except for 3.2 mg/L TPhP, where the rapid light curves showed a significantly reduced photosynthetic capacity of algae. In addition, TPhP caused high ROS levels at 96 h, resulting in cell membrane damage. Using the additive index and independent action methods, the combined toxic effects of PS and TPhP on the algae were evaluated as antagonistic; however, cell membrane damage caused by high ROS levels was still noticeable. This study has shown the potential toxicity of PS and TPhP to marine microalgae, and provided insights into the combined risk assessment of TPhP and microplastics in the marine environment.

Effect of pluronic block polymers and N-acetylcysteine culture media additives on growth rate and fatty acid composition of six marine microalgae species

Abstract

The efficiency of microalgal biomass production is a determining factor for the economic competitiveness of microalgae-based industries. N-acetylcysteine (NAC) and pluronic block polymers are two compounds of interest as novel culture media constituents because of their respective protective properties against oxidative stress and shear-stress-induced cell damage. Here we quantify the effect of NAC and two pluronic (F127 and F68) culture media additives upon the culture productivity of six marine microalgal species of relevance to the aquaculture industry (four diatoms-Chaetoceros calcitrans, Chaetoceros muelleri, Skeletonema costatum, and Thalassiosira pseudonana; two haptophytes-Tisochrysis lutea and Pavlova salina). Algal culture performance in response to the addition of NAC and pluronic, singly or combined, is dosage- and species-dependent. Combined NAC and pluronic F127 algal culture media additives resulted in specific growth rate increases of 38%, 16%, and 24% for C. calcitrans, C. muelleri, and P. salina, respectively. Enhanced culture productivity for strains belonging to the genus Chaetoceros was paired with an ~27% increase in stationary-phase cell density. For some of the species examined, culture media enrichments with NAC and pluronic resulted in increased omega-3-fatty acid content of the algal biomass. Larval development (i.e., growth and survival) of the Pacific oyster (Crassostrea gigas) was not changed when fed a mixture of microalgae grown in NAC- and F127-supplemented culture medium. Based upon these results, we propose that culture media enrichment with NAC and pluronic F127 is an effective and easily adopted approach to increase algal productivity and enhance the nutritional quality of marine microalgal strains commonly cultured for live-feed applications in aquaculture.

Key points

• Single and combined NAC and pluronic F127 culture media supplementation significantly enhanced the productivity of Chaetoceros calcitrans and Chaetoceros muelleri cultures.

• Culture media enrichments with NAC and F127 can increase omega-3-fatty acid content of algal biomass.

• Microalgae grown in NAC- and pluronic F127-supplemented culture media are suitable for live-feed applications.

Supplementary Information

The online version contains supplementary material available at 10.1007/s00253-021-11147-8.

Effects of shear stress on microalgae - A review

Cultivation of microalgae requires consideration of shear stress, which is generated by operations such as mixing, circulation, aeration and pumping that are designed to facilitate mass and heat transfer as well as light distribution in cultures. Excessive shear stress can cause increased cell mortality, decreased growth rate and cell viability, or even cell lysis. This review examines the sources of shear stress in different cultivation systems, shear stress tolerance of different microalgal species and the physiological factors and environmental conditions that may affect shear sensitivity, and potential approaches to mitigate the detrimental effects of shear stress. In general, green algae have the greatest tolerance to shear stress, followed by cyanobacteria, haptophytes, red algae, and diatoms, with dinoflagellates comprising the most shear-sensitive species. The shear-sensitivity of microalgae is determined primarily by cell wall strength, cell morphology and the presence of flagella. Turbulence, eddy size, and viscosity are the most prominent parameters affecting shear stress to microalgal cells during cultivation.

Conversion and assimilation of furfural and 5-(hydroxymethyl)furfural by Pseudomonas putida KT2440

The sugar dehydration products, furfural and 5-(hydroxymethyl)furfural (HMF), are commonly formed during high-temperature processing of lignocellulose, most often in thermochemical pretreatment, liquefaction, or pyrolysis. Typically, these two aldehydes are considered major inhibitors in microbial conversion processes. Many microbes can convert these compounds to their less toxic, dead-end alcohol counterparts, furfuryl alcohol and 5-(hydroxymethyl)furfuryl alcohol. Recently, the genes responsible for aerobic catabolism of furfural and HMF were discovered in Cupriavidus basilensis HMF14 to enable complete conversion of these compounds to the TCA cycle intermediate, 2-oxo-glutarate. In this work, we engineer the robust soil microbe, Pseudomonas putida KT2440, to utilize furfural and HMF as sole carbon and energy sources via complete genomic integration of the 12 kB hmf gene cluster previously reported from Burkholderia phytofirmans. The common intermediate, 2-furoic acid, is shown to be a bottleneck for both furfural and HMF metabolism. When cultured on biomass hydrolysate containing representative amounts of furfural and HMF from dilute-acid pretreatment, the engineered strain outperforms the wild type microbe in terms of reduced lag time and enhanced growth rates due to catabolism of furfural and HMF. Overall, this study demonstrates that an approach for biological conversion of furfural and HMF, relative to the typical production of dead-end alcohols, enables both enhanced carbon conversion and substantially improves tolerance to hydrolysate inhibitors. This approach should find general utility both in emerging aerobic processes for the production of fuels and chemicals from biomass-derived sugars and in the biological conversion of high-temperature biomass streams from liquefaction or pyrolysis where furfural and HMF are much more abundant than in biomass hydrolysates from pretreatment.

•

HMF and furfural are common microbial inhibitors in biomass conversion.

•

HMF and furfural gene cluster was isolated from Burkholderia phytofirmans..

•

We heterologously express the HMF/furfural gene cluster in Pseudomonas putida..

•

Expression enables cultivation on HMF and furfural as a sole carbon source.

•

Expression also enables enhanced conversion on lignocellulosic hydrolysate.