Incidence of osteosynthesis of members in France

Study of the position of six volar locking plates for distal radius fracture relative to the watershed line

INTRODUCTION

Volar plate malpositioning in the treatment of distal radial fracture can lead to tendinitis or even tendon tear, especially when the plate position is very distal. We studied the impact of design on plate position in the distal radius. The primary aim was to compare the position of six volar wrist plates relative to the watershed line using the Soong classification. The secondary objectives were to assess the epidemiology of volar locking plate fixation within the administrative Département of Finistère (northwestern France) and to study whether the type of fracture played a role in plate position.

HYPOTHESIS

The plate design itself influences positioning relative to the watershed line on the Soong classification.

MATERIALS AND METHODS

A total of 2723 volar locking plate fixation cases were analyzed and categorized according to the Soong classification. Plates used were divided into six groups based on design: Zimmer Biomet®, Newclip Technics®, Stryker®, Synthes®, Medartis® and Medartis® Footprint. The number of Soong 0 + 1 plates (i.e., plates graded 0 and 1 taken together) was determined for each design, then compared using the Marascuilo procedure with a significance level of α = 0.05.

RESULTS

On the Marascuilo procedure, we found significant differences in the number of Soong grade 0 + 1 plates. The Zimmer Biomet and Newclip Technics® plates were significantly more often proximal to the watershed line than the Synthes and Medartis Footprint plates. Plate position with the Medartis® design was significantly more proximal to the watershed line than for its companion design, the Medartis® Footprint plate. The rate of volar locking plate fixation of distal radial fractures over the past 10 years increased in Finistère. Also, the type of fracture affected the choice of plate when different designs were available within a hospital center (Medartis® Footprint plate used in 2R3A fractures).

CONCLUSION

Our study highlights a significant difference in volar locking plate position relative to the watershed line between the various models available. Plate design is a deciding factor when treating distal radial fracture, to avoid impingement when implant removal is not routinely planned.

LEVEL OF EVIDENCE: 3

ANALYSIS OF 45,507 SURGICAL TREATMENT OF DISTAL TIBIA AND MALLEOLAR FRACTURES OVER 14 YEARS

The distal leg joint fractures are among the most common fractures in humans across all age groups, and 50% of them require surgical treatment. Few studies discuss the epidemiology and costs of this fracture in the global and national literature.

OBJECTIVE

To evaluate the annual incidence and reimbursement value of distal leg joint fractures requiring surgical treatment from 2008 to 2021.

METHODS

A retrospective study was conducted to analyze the complex structured data of high volume and high variability (Big Data), publicly available on the TabNet platform (DATASUS), via software with artificial intelligence. Data from 2008 to 2021 on surgical treatment for malleolar fracture, distal tibia fracture, and isolated fibula fracture were analyzed.

RESULTS

From 2008 to 2021, there was an average incidence of 28.8 fractures/10⁵ inhabitants per year, representing 14.62% of all fractures. The total amount paid for hospitalizations due to these fractures was R$ 34,218,014.62 over these 14 years.

CONCLUSION

The incidence of distal leg joint fractures follows the pattern of those recorded in other countries. The adjustment of reimbursement over the years was lower than the accumulated inflation. Level of Evidence II, Economic and Decision Analyses - Developing an Economic or Decision Model.

Addressing the Needs of the Rapidly Aging Society through the Development of Multifunctional Bioactive Coatings for Orthopedic Applications

The unprecedented aging of the world's population will boost the need for orthopedic implants and expose their current limitations to a greater extent due to the medical complexity of elderly patients and longer indwelling times of the implanted materials. Biocompatible metals with multifunctional bioactive coatings promise to provide the means for the controlled and tailorable release of different medications for patient-specific treatment while prolonging the material's lifespan and thus improving the surgical outcome. The objective of this work is to provide a review of several groups of biocompatible materials that might be utilized as constituents for the development of multifunctional bioactive coatings on metal materials with a focus on antimicrobial, pain-relieving, and anticoagulant properties. Moreover, the review presents a summary of medications used in clinical settings, the disadvantages of the commercially available products, and insight into the latest development strategies. For a more successful translation of such research into clinical practice, extensive knowledge of the chemical interactions between the components and a detailed understanding of the properties and mechanisms of biological matter are required. Moreover, the cost-efficiency of the surface treatment should be considered in the development process.

Antibacterial coating of implants: are we missing something?

Implant-related infection is one of the leading reasons for failure in orthopaedics and trauma, and results in high social and economic costs. Various antibacterial coating technologies have proven to be safe and effective both in preclinical and clinical studies, with post-surgical implant-related infections reduced by 90% in some cases, depending on the type of coating and experimental setup used. Economic assessment may enable the cost-to-benefit profile of any given antibacterial coating to be defined, based on the expected infection rate with and without the coating, the cost of the infection management, and the cost of the coating. After reviewing the latest evidence on the available antibacterial coatings, we quantified the impact caused by delaying their large-scale application. Considering only joint arthroplasties, our calculations indicated that for an antibacterial coating, with a final user's cost price of €600 and able to reduce post-surgical infection by 80%, each year of delay to its large-scale application would cause an estimated 35 200 new cases of post-surgical infection in Europe, equating to additional hospital costs of approximately €440 million per year. An adequate reimbursement policy for antibacterial coatings may benefit patients, healthcare systems, and related research, as could faster and more affordable regulatory pathways for the technologies still in the pipeline. This could significantly reduce the social and economic burden of implant-related infections in orthopaedics and trauma. Cite this article: C. L. Romanò, H. Tsuchiya, I. Morelli, A. G. Battaglia, L. Drago. Antibacterial coating of implants: are we missing something? Bone Joint Res 2019;8:199-206. DOI: 10.1302/2046-3758.85.BJR-2018-0316.

Effect of reduction quality on post-operative outcomes in 31-A2 intertrochanteric fractures following intramedullary fixation: a retrospective study based on computerised tomography findings

Purpose

To determine how the reduction of medial and anteromedial cortices using CT findings in 31-A2 intertrochanteric fractures treated with the intramedullary nail could affect the clinical outcomes and complication rates of the fractures.

Methods

We retrospectively analyzed the data of 43 patients with 31-A2 intertrochanteric fractures who underwent closed reduction and intramedullary internal fixation (CRIF) between January 2010 and December 2013. Patients were classified into two groups based on the post-operative CT scans taken from the sagittal and coronal planes, respectively. Five radiographic parameters and three clinical parameters were used to evaluate the post-operative functional states and mobilization levels in this study. Post-operative complications were also recorded.

Results

The mean loss of the femoral neck-shaft angle (FNSA) was significantly smaller in Group C1 than that in Group C2. There were significant differences in the sliding distance of the cephalic nail and the loss of femoral head height between the two groups. In terms of the reduction conditions shown on the sagittal planes, the FNSA, sliding distance of the cephalic nail, and the loss of FHH were significantly different, although differences in TCD were not significant. Patients in groups C1 (3.6%) and S1 (0.0%) had lower complication rates compared to patients in groups C2 (26.7%) and S2 (27.8%).

Conclusion

Patients with good reduction quality of the medial and anteromedial sustainable cortices had better clinical outcomes and lower complication rates. The sustainable stability and anti-rotational function of these validated reductions might play a critical role in maintaining the fragment positions and reducing the incidence of complications in patients.

Electronic supplementary material

The online version of this article (10.1007/s00264-018-4098-1) contains supplementary material, which is available to authorized users.