One-Piece Nasal Osteotomy for the Correction of a Centrally Deviated Nose

Sutures positioning technique enhances the predictability and concordance between preoperative simulation and actual outcomes in rhinoplasty

BACKGROUND

The predictability and concordance between simulated and actual outcomes in rhinoplasty are uncertain. Here, we introduce a suture positioning technique (SPT), a simple and low-cost method to minimize the gap between the simulated and actual outcomes of rhinoplasty.

METHODS

Seventy patients were enrolled in this study between January 2018 and January 2021. Preoperative simulations were performed using Adobe Photoshop. The control group underwent surgery using simulation and intuition. In the SPT group, sutures were used to assist in the preoperative identification of the ideal nasal tip position. The SPT effectiveness was tested by measuring the nasal parameters and using the patient's subjective satisfaction questionnaire at T1 (Time 1, immediately postoperatively) and T2 (Time 2, at least 1 year postoperatively).

RESULTS

The intraclass correlation coefficient test showed a satisfactory correlation between simulation and postoperative outcomes in both groups. However, the SPT group had a higher correlation than the control group, especially for the nasal length (16% higher at T1 and 15% higher at T2). The mean absolute difference (MAD) between the outcomes and simulation indicated that the MAD of nasal tip projection between T2 and simulation and MAD of nasal length between T1 (or T2) and simulation were statistically significant between groups. Additionally, the SPT group was more satisfied with the postoperative outcomes and were consistent with the preoperative simulation.

CONCLUSION

This study demonstrated the effectiveness of SPT in intraoperative quality control. This technique may be adopted by surgeons to achieve good concordance between simulated and actual surgical outcomes.

One-Unit Osteotomy to Correct Deviated Bony Dorsum

OBJECTIVES

A crooked nose is frequently caused by nasal bony vault deviation, and proper management of the bony vault is an integral part of rhinoplasty. Conventional osteotomy to correct a deviated nose favors simultaneous medial and lateral osteotomies, which allows the free independent movement of each nasal bone. However, patient satisfaction with deviated nose surgery is sometimes low. In the present study, we introduce a one-unit osteotomy procedure that combines bilateral and root osteotomies with unilateral triangular bony wedge resection to allow symmetry of both nasal bones.

METHODS

Twenty consecutive patients who presented with bony vault deviation and underwent one-unit osteotomy were enrolled in this retrospective single-center study. The Nasal Obstruction Symptom Evaluation (NOSE) questionnaire was used to evaluate each patient's functional outcome. The angle of bony vault deviation before and after one-unit osteotomy was measured using a protractor and compared with the.

RESULTS

of 14 patients who had undergone conventional osteotomy. The improvement in dorsal deviation was evaluated using facial photography preoperatively and 3 months postoperatively.

RESULTS

NOSE values improved from 8.4±6.4 to 4.1±4.2 (P =0.021). The angle of bony vault deviation improved from 6.9°±2.2° to 2.1°±1.2° (P <0.001) in one-unit osteotomy and from 7.3°±4.0° to 2.7°±1.2° (P =0.001) in conventional osteotomy. The preoperative deviation angle improved by 70.3% in one-unit osteotomy compared with 56.6% in conventional osteotomy, which was a significant difference (P =0.033). The mean grade of the postoperative esthetic outcomes for the remaining deviation was 1.6±0.5, which was similar to that in the conventional osteotomy group.

CONCLUSION

One-unit osteotomy is a relatively simple procedure that balances the width of both lateral walls by removing excessive bony fragments from the wider bony wall and providing better structural integrity. This technique improves functional outcomes and has equivalent esthetic.

RESULTS

to those of the traditional procedure.

Simple method of saddle nose correction: A double-layer dermofat graft: case report

INTRODUCTION

Saddle nose deformities are typically reconstructed with cartilage grafts; however, conchal cartilage grafts are and associated with a risk of damage to the posterior auricular ligament and insufficient amounts, and costal cartilage grafts require invasive surgery under general anesthesia. We proposed a double-layer dermofat graft as an alternative to these methods.

PATIENT CONCERNS

Two patients with type IV saddle nose deformity underwent reconstruction with nasal augmentation with a double-layer dermofat graft harvested from the gluteal sulcus.

DIAGNOSIS

After operation, photogrammetric analysis demonstrated an improvement in the dorsal depression area, which corresponded to the angle between the sellion, most depressed point, and pronasale. Rhinoplasty Outcome Evaluation questionnaire was assessed.

INTERVENTIONS

The graft was divided into 2 sections; the first section was implanted transversely into the depressed nasal framework, and the second section was inserted vertically from the nasion to the supratip break for augmentation.

OUTCOMES

Both patients reported high satisfaction with the Rhinoplasty Outcome Evaluation questionnaire. The mean preoperative angle between the sellion, most depressed point, and pronasale was 157.8°, and the mean postoperative angle at 6 months was 176.9°.

CONCLUSION

The simple method double-layer dermofat graft technique demonstrated excellent outcomes in saddle nose deformity correction, did not require cartilage, and was easily performed under local anesthesia.

Clinical Application of a Patient-Specific, Three-Dimensional Printing Guide Based on Computer Simulation for Rhinoplasty

BACKGROUND

A practical application of three-dimensional printing technology has been considered a difficult area in rhinoplasty. However, the patient-specific three-dimensionally printed rhinoplasty guide based on the simulation program the authors developed could be a solution for minimizing the gap between simulation and actual surgical results. The aims of this study were to determine how a three-dimensional rhinoplasty guide based on three-dimensional simulation would link the patient to the surgeon to investigate its effectiveness.

METHODS

Fifty patients who underwent rhinoplasty between January of 2017 and February of 2018 were included in this study. The patients were consulted about the desired shape of their nose based on preoperative three-dimensional photography. The confirmed three-dimensional simulation was sent to a manufacturing company for three-dimensionally printed rhinoplasty guides. In the guide group, rhinoplasty was performed based on the three-dimensionally printed rhinoplasty guide, and in the control group, procedures were performed based on the surgeon's intuition.

RESULTS

The intraclass correlation coefficient test for comparing the simulated and postoperative measurements showed higher correlation in the three-dimensional printing guide group: higher correlation 11.3 percent in nasal tip projection, 21.6 percent in dorsum height, and 9.8 percent in nasolabial angle. The postoperative result of the nasal dorsum had a statistically significant difference between the two groups (p < 0.05).

CONCLUSIONS

This study demonstrated the usefulness of the three-dimensionally-printed rhinoplasty guide, which delivers the preoperative simulated image in the actual clinical practice of rhinoplasty. This approach could cause a paradigm shift in simulation-based rhinoplasty.

CLINICAL QUESTION/LEVEL OF EVIDENCE

Therapeutic, III.