Investigation of viscoelastic attributes and vibrational characteristics of natural fabrics-incorporated hybrid laminate beams

A Comprehensive Review on the Viscoelastic Parameters Used for Engineering Materials, Including Soft Materials, and the Relationships between Different Damping Parameters

Although the physical properties of a structure, such as stiffness, can be determined using some statical tests, the identification of damping parameters requires a dynamic test. In general, both theoretical prediction and experimental identification of damping are quite difficult. There are many different techniques available for damping identification, and each method gives a different damping parameter. The dynamic indentation method, rheometry, atomic force microscopy, and resonant vibration tests are commonly used to identify the damping of materials, including soft materials. While the viscous damping ratio, loss factor, complex modulus, and viscosity are quite common to describe the damping of materials, there are also other parameters, such as the specific damping capacity, loss angle, half-power bandwidth, and logarithmic decrement, to describe the damping of various materials. Often, one of these parameters is measured, and the measured parameter needs to be converted into another damping parameter for comparison purposes. In this review, the theoretical derivations of different parameters for the description and quantification of damping and their relationships are presented. The expressions for both high damping and low damping are included and evaluated. This study is considered as the first comprehensive review article presenting the theoretical derivations of a large number of damping parameters and the relationships among many damping parameters, with a quantitative evaluation of accurate and approximate formulas. This paper could be a primary resource for damping research and teaching.

A sustainable and low pollutive strategy for the recycling of waste hot-gas filter bags: The development of filter reinforced epoxy composites

The fast accumulation of waste hot-gas filter bags has become a growing public concern considering its difficulty in degradation, severe pollution elicited by landfill and incineration, high energy consumption during burning or complicated recycling and low margin of regenerative products. Herein, we provide a new feasible recycling strategy by directly employing the cleaned polyphenylene sulfide (PPS) /polytetrafluoroethylene (PTFE) waste filters in their fabric state as the reinforcement of epoxy composites. Merely two layers of filters could produce composites with flexural strength and modulus sufficient for many applications and the additional carbon fiber fabric (CFF) covering could further strengthen the composites (295 to 1010 % increments). The filters also showed a bonding promotion function between CFF and polymethacrylimide foam in lightweight composites. After hydrothermal treatment, the composites reinforced by the recycled filters displayed 97.2 % and 90.9 % retention rate for flexural strength and modulus, respectively. Compared to the pure epoxy, the composites could achieve a limiting oxygen index of 27.6 %, and display 24 % decline in thermal energy release and 20.0 to 31.0 % reduction in the generation rate of combustion products, indicating strengthened flame-retardancy. With shortened processes and elevated properties of composites, the approach established for recycling waste filters in this work showed far-reaching implications in carbon emission reduction, environmental pollution diminishing and commercialization potential.