Korneale Biomechanik: Corvis® ST-Parameter nach Laser-in-situ-Keratomileusis

Measurement of In Vivo Biomechanical Changes Attributable to Epithelial Removal in Keratoconus Using a Noncontact Tonometer

PURPOSE

To compare the biomechanical properties of the cornea after epithelial removal in eyes with keratoconus undergoing corneal cross-linking.

METHODS

Prospective interventional case series at a university hospital tertiary referral center. Corneal biomechanical properties were measured in patients with keratoconus undergoing corneal cross-linking, immediately before and after epithelial debridement by using a dynamic ultrahigh-speed Scheimpflug camera equipped with a noncontact tonometer.

RESULTS

The study comprised 45 eyes of 45 patients with a mean age of 19.6 ± 4.9 years (range 14-34). The cornea was found to be 23.7 ± 15.7 μm thinner after epithelial removal (P < 0.01). Corneal stiffness was reduced after epithelial removal as demonstrated by a significant decrease of parameters such as stiffness parameter A1 (12.31, P < 0.01), stiffness parameter-highest concavity (2.25, P < 0.01), A1 length (0.13 mm, P = 0.04), highest concavity radius of curvature (0.26 mm, P = 0.01), highest concavity time (0.22 ms, P = 0.04) and an increase in A1 velocity (-0.01 m/s, P = 0.01), A1 deformation amplitude (-0.03 mm, P ≤ 0.01), A1 deflection length (-0.32 mm, P < 0.01), A2 deformation amplitude (-0.03 mm, P = 0.01), and A2 deflection length (-1.00 mm, P < 0.01). There were no significant differences in biomechanical intraocular pressure (0.15 mm Hg, P = 0.78), deformation amplitude (0.03, P = 0.54), maximum inverse radius (-0.01 mm, P = 0.57), and whole eye movement length (-0.02 mm, P = 0.12).

CONCLUSIONS

Dynamic ultrahigh-speed Scheimpflug camera equipped with a noncontact tonometer offers an alternative method for in vivo measurements of the epithelial layer's contribution to corneal biomechanical properties. Our results suggest that corneal epithelium may play a more significant role in corneal biomechanical properties in patients with keratoconus than previously described.

Corneal Vibrations during Intraocular Pressure Measurement with an Air-Puff Method

Introduction

The paper presents a commentary on the method of analysis of corneal vibrations occurring during eye pressure measurements with air-puff tonometers, for example, Corvis. The presented definition and measurement method allow for the analysis of image sequences of eye responses—cornea deformation. In particular, the outer corneal contour and sclera fragments are analysed, and 3D reconstruction is performed.

Methods

On this basis, well-known parameters such as eyeball reaction or corneal response are determined. The next steps of analysis allow for automatic and reproducible separation of four different corneal vibrations. These vibrations are associated with (1) the location of the maximum of cornea deformation; (2) the cutoff area measured in relation to the cornea in a steady state; (3) the maximum of peaks occurring between applanations; and (4) the other characteristic points of the corneal contour.

Results

The results obtained enable (1) automatic determination of the amplitude of vibrations; (2) determination of the frequency of vibrations; and (3) determination of the correlation between the selected types of vibrations.

Conclusions

These are diagnostic features that can be directly applied clinically for new and archived data.

Influence of Pachymetry and Intraocular Pressure on Dynamic Corneal Response Parameters in Healthy Patients

PURPOSE

To evaluate the influence of pachymetry, age, and intraocular pressure in normal patients and to provide normative values for all dynamic corneal response parameters (DCRs) provided by dynamic Scheimpflug analysis.

METHODS

Seven hundred five healthy patients were included in this multicenter retrospective study. The biomechanical response data were analyzed to obtain normative values with their dependence on corrected and clinically validated intraocular pressure estimates developed using the finite element method (bIOP), central corneal thickness (CCT), and age, and to evaluate the influence of bIOP, CCT, and age.

RESULTS

The results showed that all DCRs were correlated with bIOP except deflection amplitude (DefA) ratio, highest concavity (HC) radius, and inverse concave radius. The analysis of the relationship of DCRs with CCT indicated that HC radius, inverse concave radius, deformation amplitude (DA) ratio, and DefA ratio were correlated with CCT (rho values of 0.343, -0.407, -0.444, and -0.406, respectively). The age group subanalysis revealed that primarily whole eye movement followed by DA ratio and inverse concave radius were the parameters that were most influenced by age. Finally, custom software was created to compare normative values to imported examinations.

CONCLUSIONS

HC radius, inverse concave radius, DA ratio, and DefA ratio were shown to be suitable parameters to evaluate in vivo corneal biomechanics due to their independence from IOP and their correlation with pachymetry and age. The creation of normative values allows the interpretation of an abnormal examination without the need to match every case with another normal patient matched for CCT and IOP. [J Refract Surg. 2016;32(8):550-561.].