Computed tomography in patients with cardiac pacemakers: difficulties and solutions

[Coronary computed tomography and cardiac devices : Diagnostic results or nothing but artifacts?]

Coronary computed tomography (CT) angiography has become a major cornerstone in the diagnostic workup of cardiologic patients, particularly for evaluation of the coronary arteries and preprocedural planning of interventions for structural heart disease. Despite the possible problems that intensive electromagnetic radiation (including X‑rays) might cause when directly impacting on implanted cardiac devices, cardiac CT is a safe diagnostic test and should not be withheld from patients with devices if properly indicated. Sufficient image quality is paramount for the evaluation; hence, special attention should be paid to a low heart rate (< 60 bpm) and sufficient compliance with breathing instructions. Furthermore, pacemaker or implantable cardioverter-defibrillator (ICD) leads may cause metal artifacts, especially around the lead tip. Their dense material causes beam hardening and streak artifacts which may result in reduced image quality and limited diagnostic assessability. The prevalence of such artifacts depends not only on lead material but also on lead positioning relative to the gantry plane. Metal artifacts are more frequent in patients with unipolar leads and shock coils, which can impair the assessment of coronary arteries, mainly of the right coronary artery (RCA). Artifacts caused by left ventricular (LV) leads of cardiac resynchronization therapy (CRT) systems tend to affect assessment of the left circumflex artery (LCX). By using dual energy CT and postprocessing algorithms, the impact of artifacts can be reduced and diagnostic image quality can be achieved in most cases. Unfortunately, the actual occurrence of such artifacts or the degree of impairment of image quality cannot be reliably predicted.

Reduced artifacts and improved diagnostic value of 640-slice computed tomography in patients with cardiac pacemakers

Objective

The aim of this study was to compare the feasibility of 640-slice with 64-slice computed tomography (CT) coronary angiography for diagnosing coronary lesions in patients with pacemakers.

Methods

Forty-five and 50 patients with pacemakers and with suspected or known coronary artery disease underwent 64-slice (64 group) and 640-slice (640 group) CT scans, respectively. All segments of the vessels were evaluated according to the 15-segment model recommended by the American Heart Association.

Results

The incidence of moderate or severe artifacts was significantly lower (7.27% vs. 32.17%) and the diagnosable rate for coronary lesions was higher (98.91% vs. 94.19%) in the 640 compared with the 64 group. In the 64 group, the incidence of artifacts in patients with a heart rate >65 bpm (20.98%) was higher than in those with a heart rate <65 bpm (15.67%), although the difference was not significant, while the incidence of artifacts was significantly higher in patients with heart arrhythmia (21.40%) compared with in those with normal heart rhythm (15.09%).

Conclusions

Among patients with pacemakers and a higher heart rate or heart arrhythmia, 640-slice CT may be more effective than 64-slice CT for diagnosing coronary lesions, by reducing moderate and severe artifacts.

Coronary computed tomography angiography and endocardial leads - Image quality in 320-row CT using iterative reconstruction

PURPOSE

To investigate whether the presence of endocardial leads has an impact on image quality in coronary computed tomography angiography (CCTA), when current technique is employed using a 320-row computed tomography and iterative reconstruction.

MATERIALS AND METHODS

CCTA was performed in 1641 patients, from these we identified 51 patients (study group) with endocardial leads and 51 matched partners (control group) without endocardial leads. Noise was determined in the ascending aorta and the left ventricle; signal-to-noise ratio (SNR) and contrast-to-noise ratio (CNR) were determined in the left and right coronary artery. Subjective image quality was rated separately for the 15 segments of the coronary arteries by 2 radiologists.

RESULTS

Current CCTA technique still shows slight impairment of objective image quality in patients with endocardial leads with inferior SNR in the aorta (median 15.04 versus 16.6; p = 0.004) and inferior SNR in the left/right coronary artery (median 15.3/13.81 versus 16.1/15.41; p = 0.013/0.002). CNR of the left/right coronary artery was also inferior (median 17.4/16.46 versus 19.26/19.24; p = 0.002/<0.001). The subjective image quality was rated significantly inferior only in segment 8 (p = 0.001) compared to the control group. Artifacts by ventricular leads were found in 65% of the patients in segment 8 with non-diagnostic rating in 9 cases (18%). Atrial leads resulted in artifacts predominantly in segment 1 (45%) with non-diagnostic rating in only 2 cases (4%).

CONCLUSION

CCTA is feasible with slight restrictions for patients in the presence of implanted cardiac devices when current technique is used.

Deformable Known Component Model-Based Reconstruction for Coronary CT Angiography

Purpose

Atherosclerosis detection remains challenging in coronary CT angiography for patients with cardiac implants. Pacing electrodes of a pacemaker or lead components of a defibrillator can create substantial blooming and streak artifacts in the heart region, severely hindering the visualization of a plaque of interest. We present a novel reconstruction method that incorporates a deformable model for metal leads to eliminate metal artifacts and improve anatomy visualization even near the boundary of the component.

Methods

The proposed reconstruction method, referred as STF-dKCR, includes a novel parameterization of the component that integrates deformation, a 3D-2D preregistration process that estimates component shape and position, and a polyenergetic forward model for x-ray propagation through the component where the spectral properties are jointly estimated. The methodology was tested on physical data of a cardiac phantom acquired on a CBCT testbench. The phantom included a simulated vessel, a metal wire emulating a pacing lead, and a small Teflon sphere attached to the vessel wall, mimicking a calcified plaque. The proposed method was also compared to the traditional FBP reconstruction and an interpolation-based metal correction method (FBP-MAR).

Results

Metal artifacts presented in standard FBP reconstruction were significantly reduced in both FBP-MAR and STF-dKCR, yet only the STF-dKCR approach significantly improved the visibility of the small Teflon target (within 2 mm of the metal wire). The attenuation of the Teflon bead improved to 0.0481 mm^-1 with STF-dKCR from 0.0166 mm^-1 with FBP and from 0.0301 mm^-1 with FBP-MAR - much closer to the expected 0.0414 mm^-1.

Conclusion

The proposed method has the potential to improve plaque visualization in coronary CT angiography in the presence of wire-shaped metal components.

Unusual "ratchet syndrome": spontaneous lead retraction after a generator exchange

A 72-year-old female with idiopathic dilated cardiomyopathy underwent a generator exchange for a cardiac resynchronization therapy defibrillator with a full-pocket capsulectomy. The lead position after the operation was identical to that before the operation on the chest X-ray. After 4 months, a subacute exacerbation of her heart failure was caused by cardiac resynchronization therapy failure due to a dislodgement of the left ventricular lead. An aggressive adhesiotomy of the connective tissue around the leads made it possible for the lead to retract by a ratchet-like movement through the suture sleeve, so-called "ratchet syndrome", after the generator exchange.

Association between changes in coronary artery circulation and cardiac venous retention: a lesson from cardiac computed tomography

To use computed tomography (CT) image data to measure a potential association between the implantation of coronary artery bypass grafts (CABG) and changes in the coronary venous system has not yet been examined. In 112 (aged 59.4 ± 9.0; 45F) patients (pts.), a 64-slice CT angiography was performed. Patients were divided into 2 groups: CABG (56 pts.) and control (56 pts.)—without changes in coronaries. In each case, ten multi-planar reconstructions (MPR) and 3D volume rendering reconstructions using a 2 mm layer with ECG-gating, helical pitch: 12.8; rotation time: 0.4 s and average tube voltage: 135 kV at 380 mA. The visualization of the coronary veins was independently graded by 2 experts trained in CT. In the CABG group, the average number of visible coronary veins was 5.3 ± 1.3, while in the control group it was 3.1 ± 1.1 (p < 0.001). Statistical differences were also observed for the following coronary veins: posterolateral (control 2.1 ± 1.9 vs. CABG 2.9 ± 1.9; p < 0.05), lateral (control 2.2 ± 1.7 vs. CABG 3.1 ± 1.3; p < 0.01) and anterolateral (control 0.5 ± 0.9 vs. CABG 1.3 ± 1.0; p < 0.001). Implantation of CABG influences the coronary venous system. In patients after CABG, the number of identifiable coronary veins is significantly higher as compared to that in subjects without changes in coronaries. This might suggest an association between changes in coronary artery circulation and cardiac venous retention.

Cardiac CT: Imaging of and Through Cardiac Devices

For patients with cardiac devices, cardiac computed tomography (CT) remains the mainstay for imaging due to its superior resolution as compared with echocardiography and nuclear studies and no contraindication to metal as with cardiac magnetic resonance imaging. This review focuses on the evaluation and pitfalls of coronary arterial imaging in patients with devices, such as pacemakers, implantable defibrillators, cardiac resynchronization therapy (CRT), as well as complications such as lead perforation and safety concerns of CT interference. We discuss both pre- and post-procedural CRT assessment for coronary venous imaging and pre-procedural myocardial scar assessment to localize regions of scar and peri-infarct zone to facilitate ventricular tachycardia ablation in patients with devices. We describe potential new research on dyssynchrony and integration with myocardial scar and site of latest activation for patients with or being considered for CRT. We detail the utility of CT for the assessment of proper function and complications in patients with left ventricular assist device implantation.

Two-point left ventricle pacing and cardiac computed tomography

Endocardial leads can potentially cause problems during coronary vessels visualization in multislice computed tomography (MSCT) due to a large number of artifacts. Based on presented case, we conclude that it is possible to perform MSCT of coronary arteries and leads visualization despite coexistence of four endocardial leads.