Dynamic surface tension and dilational viscoelasticity of adsorption layers of alkylated chitosans and surfactant–chitosan complexes

Advancements in Surfactant Carriers for Enhanced Oil Recovery: Mechanisms, Challenges, and Opportunities

Enhanced oil recovery (EOR) techniques are crucial for maximizing the extraction of residual oil from mature reservoirs. This review explores the latest advancements in surfactant carriers for EOR, focusing on their mechanisms, challenges, and opportunities. We delve into the role of inorganic nanoparticles, carbon materials, polymers and polymeric surfactants, and supramolecular systems, highlighting their interactions with reservoir rocks and their potential to improve oil recovery rates. The discussion includes the formulation and behavior of nanofluids, the impact of surfactant adsorption on different rock types, and innovative approaches using environmentally friendly materials. Notably, the use of metal oxide nanoparticles, carbon nanotubes, graphene derivatives, and polymeric surfacants and the development of supramolecular complexes for managing surfacant delivery are examined. We address the need for further research to optimize these technologies and overcome current limitations, emphasizing the importance of sustainable and economically viable EOR methods. This review aims to provide a comprehensive understanding of the emerging trends and future directions in surfactant carriers for EOR.

Chitosan/carboxymethylcellulose-stabilized poly(lactide-co-glycolide) particles as bio-based drug delivery carriers

Poly(lactide-co-glycolide) (PLGA) colloidal particles stabilized by complexes of two oppositely charged polysaccharides, chitosan (cationic, CS) and sodium carboxymethylcellulose (anionic, NaCMC), were fabricated. Dichloromethane containing dissolved PLGA was first emulsified in an aqueous phase containing mixtures of CS and NaCMC. Evaporation of dichloromethane from the resulting emulsion led to CS/NaCMC-covered-PLGA particles. CS and NaCMC contents affected the short-term stability of PLGA particles and also their intrinsic characteristics. The particles displayed pH-dependent characteristic. Zeta potential varied from +54 to -50 mV when pH was varied from 3 to 10. CS/NaCMC-covered-PLGA particles showed colloidal stability, over a wider pH range as compared to CS-covered-PLGA particles. Curcumin, a model hydrophobic drug, was encapsulated into the particles up to 10 wt% of PLGA. The CS/NaCMC-covered-PLGA particles loaded with curcumin showed delayed release in mildly acidic conditions and faster release in neutral and basic conditions. Cytotoxicity experiments were carried out with human colorectal carcinoma cells.

The extracellular matrix of the oleolytic biofilms of Marinobacter hydrocarbonoclasticus comprises cytoplasmic proteins and T2SS effectors that promote growth on hydrocarbons and lipids

The assimilation of the nearly water insoluble substrates hydrocarbons and lipids by bacteria entails specific adaptations such as the formation of oleolytic biofilms. The present article reports that the extracellular matrix of an oleolytic biofilm formed by Marinobacter hydrocarbonoclasticus at n-hexadecane-water interfaces is largely composed of proteins typically cytoplasmic such as translation factors and chaperones, and a lesser amount of proteins of unknown function that are predicted extra-cytoplasmic. Matrix proteins appear to form a structured film on hydrophobic interfaces and were found mandatory for the development of biofilms on lipids, alkanes and polystyrene. Exo-proteins secreted through the type-2 secretion system (T2SS) were shown to be essential for the formation of oleolytic biofilms on both alkanes and triglycerides. The T2SS effector involved in biofilm formation on triglycerides was identified as a lipase. In the case of biofilm formation on n-hexadecane, the T2SS effector is likely involved in the mass transfer, capture or transport of alkanes. We propose that M. hydrocarbonoclasticus uses cytoplasmic proteins released by cell lysis to form a proteinaceous matrix and dedicated proteins secreted through the T2SS to act specifically in the assimilation pathways of hydrophobic substrates.

The equilibrium and dynamic surface tension of polymeric surfactants based on epoxidized soybean oil grafted hydroxyethyl cellulose

Analysis of the equilibrium and dynamic surface tension of epoxidized soybean oil grafted hydroxyethyl cellulose (H-ESO-HEC) surfactants with different molecular weights were carried out at pH values that ranged from 8 to 13.

Co-assembly in chitosan-surfactant mixtures: thermodynamics, structures, interfacial properties and applications

In this review, different aspects characterizing chitosan-surfactant mixtures are summarized and compared. Chitosan is a bioderived cationic polysaccharide that finds wide-ranged applications in various field, e.g., medical or food industry, in which synergistic effects with surfactant can play a fundamental role. In particular, the behavior of chitosan interacting with strong and weak anionic, nonionic as well as cationic surfactants is reviewed. We put a focus on oppositely charged systems, as they exhibit the most interesting features. In that context, we discuss the thermodynamic description of the interaction and in particular the structural changes as they occur as a function of the mixed systems and external parameters. Moreover, peculiar properties of chitosan coated phospholipid vesicles are summarized. Finally, their co-assembly at interfaces is briefly reviewed. Despite the behavior of the mentioned systems might strongly differ, resulting in a high variety of properties, few general rules can be pointed out which improve the understanding of such complex systems.

Polycation-sodium lauryl ether sulfate-type surfactant complexes: influence of ethylene oxide length

Polyelectrolyte-surfactant complexes (PESC) are a class of materials which form spontaneously by self-assembly driven by electrostatic and hydrophobic interactions. PESC containing sodium lauryl ether sulfates (SLES) have found wide application in hair care products like shampoo. Typically, SLES with only one or two ethylene oxide (EO) groups are used for this application. We have studied the influence of the size of the EO block (ranging from 0 to 30 EO groups) on complexation with two model polycations: linear polyDADMAC and branched PEI. PESC size and electrostatic properties were determined during stepwise titration of buffered polycation solutions. The critical aggregation concentration (CAC) of PESC was determined by surface tension measurements and fluorescence spectroscopy. For polyDADMAC, there is no influence of the size of the EO block on the complexation behavior; the stiff polycation governs the structure formation. For PEI, it was seen that the EO block size does affect the structure of the complexes. The CAC value of the investigated complexes turns out to be rather independent of the EO block size; however, the CMC/CAC ratio decreases with increasing size of the EO block. This latter observation explains why the Lochhead-Goddard effect is most effective for small EO blocks.

Effect of poly(vinyl alcohol-co-vinyl acetate) copolymer blockiness on the dynamic interfacial tension and dilational viscoelasticity of polymer-anionic surfactant complex at the water-1-chlorobutane interface

Poly(vinyl alcohol-co-vinyl acetate) (PVA) copolymers obtained by partial hydrolysis of poly(vinyl acetate) (PVAc) are of practical importance for many applications, including emulsion and suspension polymerization processes. Their molecular characteristics have a major influence on the colloidal and interfacial properties. The most significant characteristics are represented by the average degree of hydrolysis D̅H̅, average degree of polymerization D̅P̅w̅ but also by the average acetate sequence length n(VAc)(0) which designates the so-called blockiness. Colloidal aggregates were observed in the aqueous PVA solutions having a D̅H̅ value of 73 mol%. The volume fraction of these aggregates at a given D̅H̅ value is directly correlated to the blockiness. Three PVA samples with identical D̅H̅ and D̅P̅w̅ but different blockiness were examined. By pendant drop and oscillating pendant drop techniques it was shown that the PVA sample having the lowest blockiness and thus the lowest volume fraction of colloidal aggregates has lower interfacial tension and elastic modulus E' values. On the contrary, the corresponding values are highest for PVA sample of higher blockiness. In the presence of sodium dodecyl sulfate (SDS), the colloidal aggregates are disaggregated by complex formation due to the hydrophobic-hydrophobic interactions. The PVA-SDS complex acts as a partial polyelectrolyte that induces the stretching of the chains and thus a reduction of the interface thickness. In this case, the interfacial tension and the elastic modulus both increase with increasing SDS concentration for all three PVA samples and the most significant effect was noticed for the most "blocky" copolymer sample.

Polyelectrolyte/surfactant mixtures in the bulk and at water/oil interfaces

Stabilization of emulsions by mixed polyelectrolyte/surfactant systems is a prominent example for the application in modern technologies. The formation of complexes between the polymers and the surfactants depends on the type of surfactant (ionic, non-ionic) and the mixing ratio. The surface activity (hydrophilic-lipophilic balance) of the resulting complexes is an important quantity for its efficiency in stabilizing emulsions. The interfacial adsorption properties observed at liquid/oil interfaces are more or less equivalent to those observed at the aqueous solution/air interface, however, the corresponding interfacial dilational and shear rheology parameters differ quite significantly. The interfacial properties are directly linked to bulk properties, which support the picture for the complex formation of polyelectrolyte/surfactant mixtures, which is the result of electrostatic and hydrophobic interactions. For long alkyl chain surfactants the interfacial behavior is strongly influenced by hydrophobic interactions while the complex formation with short chain surfactants is mainly governed by electrostatic interactions.

Attachment of a hydrophobically modified biopolymer at the oil-water interface in the treatment of oil spills

The stability of crude oil droplets formed by adding chemical dispersants can be considerably enhanced by the use of the biopolymer, hydrophobically modified chitosan. Turbidimetric analyses show that emulsions of crude oil in saline water prepared using a combination of the biopolymer and the well-studied chemical dispersant (Corexit 9500A) remain stable for extended periods in comparison to emulsions stabilized by the dispersant alone. We hypothesize that the hydrophobic residues from the polymer preferentially anchor in the oil droplets, thereby forming a layer of the polymer around the droplets. The enhanced stability of the droplets is due to the polymer layer providing an increase in electrostatic and steric repulsions and thereby a large barrier to droplet coalescence. Our results show that the addition of hydrophobically modified chitosan following the application of chemical dispersant to an oil spill can potentially reduce the use of chemical dispersants. Increasing the molecular weight of the biopolymer changes the rheological properties of the oil-in-water emulsion to that of a weak gel. The ability of the biopolymer to tether the oil droplets in a gel-like matrix has potential applications in the immobilization of surface oil spills for enhanced removal.

Metal ions: driving the orderly assembly of polyelectrolytes at a hydrophobic surface

The accumulation of polyelectrolytes at the interface between water and nonpolar fluids is an important process in both environmental and biological systems. For instance, polyelectrolytes such as humic acids are highly charged molecules that play a role in the remediation of water contaminated by oil, and the adsorption of other polyelectrolytes such as proteins and DNA to cellular surfaces is essential in biological processes. The properties of these naturally occurring polyelectrolytes are highly tunable and depend strongly on the binding of metal ions commonly found in environmental and biological systems. While the metal complexation behaviors of many polyelectrolytes and biomolecules are well characterized in bulk solution, this work shows in molecular detail that the behavior of a common polyelectrolyte in the presence of metal ions can be quite different when it adsorbs to a hydrophobic-aqueous liquid interface. In these studies, vibrational sum frequency spectroscopy and interfacial tension measurements conducted on poly(acrylic acid) (PAA) at a model oil-water interface show how small amounts of monovalent and divalent cations significantly alter the interfacial conformation of PAA at the interface and act to enhance its interfacial adsorption. The results provide important new insights that have direct relevance for understanding the effect of metal ions on the adsorption of charged macromolecules to a hydrophobic-aqueous boundary layer, specifically in biological and environmental systems.

Dilational surface visco-elasticity of polyelectrolyte/surfactant solutions: formation of heterogeneous adsorption layers

Recent application of the methods of surface dilational rheology to solutions of the complexes between synthetic polyelectrolytes and oppositely charged surfactants (PSC) gave a possibility to determine some steps of the adsorption layer formation and to discover an abrupt transition connected with the formation of microaggregates at the liquid surface. The kinetic dependencies of the dynamic surface elasticity are always monotonous at low surfactant concentrations but can have one or two local maxima in the range beyond the critical aggregation concentration. The first maximum is accompanied by the generation of higher harmonics of induced surface tension oscillations and caused by heterogeneities in the adsorption layer. The formation of a multilayered structure at the surface for some systems leads to the second maximum in the dynamic surface elasticity. The hydrophobicity and charge density of a polymer chain influence strongly the surface structure, resulting in a variety of dynamic surface properties of PSC solutions. Optical methods and atomic force microscopy give additional information for the systems under consideration. Experimental results and existing theoretical frameworks are reviewed with emphasis on the general features of all studied PSC systems.

Effect of Electrolyte Concentration on the Dynamic Surface Tension and Dilational Viscoelasticity of Adsorption Layers of Chitosan and Dodecyl Chitosan

The effect of an external salt (AcONa) on the kinetics of adsorption and structure formation inside the adsorption layers (ALs) of chitosan (Ch) and dodecyl chitosan (C12Ch) as well as on the frequency dependence of the complex dilational elasticity modulus of these layers has been studied. The complex dilational elasticity modulus of adsorption layers of polymers has been measured on the drop tensiometer (Tracker, IT Concept, France) upon applying a small sinusoidal variation of the drop area with a given frequency, omega, in the range from 10(-2) to 0.63 rad/s and recording the variation of the surface pressure. It has been found that, in the absence of the salt, the dilational storage modulus, E'(omega), of ALs of both Ch and C12Ch is lower with regard to the loss modulus, E' '(omega), in the whole range of frequencies used, testifying for the liquidlike rheological behavior of these layers. With an increase of the salt concentration up to CAcONa > 0.1 M, the ALs become solidlike, as shown when E'(omega) > E' '(omega). Consequently, the characteristic frequency, omega c, corresponding to the intercept between the E'(omega) and E' '(omega) curves, gradually varies from omega c > 1 rad/s to omega c < 0.01 rad/s when the salt concentration is increased from zero to CAcONa = 1 M. Hydrophobically modified C12Ch, having long grafted alkyl chains, exhibited a higher sensitivity to the presence of salt than Ch: the former solidifies more readily and at lower salt concentrations than the latter. It has been found that the experimental E'(omega) and E' '(omega) curves exhibit two characteristic relaxation frequencies, omega 01 approximately 1 rad/s and omega 02 approximately 10(-3)-10(-2) rad/s, whose physical meaning and values were related to the structure of the ALs and to the competitive contribution of electrostatic and hydrophobic interactions between amino and nonpolar groups of Ch and C12Ch to the formation of a gel-like network inside the polymeric film at the interface.