Computed tomography-based three-dimensional visualisation of bone corridors and trajectories for screws in open reduction and internal fixation of symphysis diastasis: a retrospective radiological study

Identifying safe corridors for anterior pelvic percutaneous instrumentation using computed tomography-based anatomical relationships

INTRODUCTION

Percutaneous anterior pelvic ring instrumentation is performed for retrograde screw fixation of ramus fractures, as well as for repair of pubic symphysis diastasis. The anatomic relationships of critical structures around the anterior pelvic ring, such as the spermatic cord and round ligament, have been described in only a few studies regarding the risk of iatrogenic injury during surgery. Our goal is to further describe these relationships, as well as provide radiographic information on safe corridors for percutaneous fixation.

METHODS

Eighty (80) axial computed tomography scans of the abdomen, obtained for non traumatic diagnostic purposes and screened for prior abdominal trauma or procedures, were evaluated by 3 fellowship trained radiologists. Mid-symphyseal cuts were used to obtain several measurements relative to the spermatic cords (SC) or round ligaments (RL): inter-cord or inter-ligament distance, skin to cortex of symphysis distance (vertical), skin to cortex of symphysis distance (oblique), safe corridor distance (between SC/RL and femoral triangle), center safe angle (relative to bilateral ischia), maximal safe angle, and minimal safe angle.

RESULTS

There were 41 male and 39 female scans included in the final analysis. The average inter-cord distance was 50.2 mm, skin to cortex vertical distance of 43.0 mm, skin to cortex oblique distance of 83.5 mm, safe corridor distance 26.3 mm, center safe angle 19.3˚, maximal safe angle 32.3˚, and minimal safe angle 13.6˚. These were further broken down by range and gender in Table 1. Agreement between radiologists was high for these different measurements with the exception of the skin to cortex oblique distance in female patients and the maximal safe angle in female patients, due to absence of round ligament in a majority of the scans. The round ligament was only present at the mid-symphyseal level for our three reviewers in 37/39, 36/39, and 24/39 of female patient scans.

CONCLUSIONS

We have identified defined safe corridors for instrumentation of the anterior pelvic ring that can assist the surgeon in percutaneous application of fixation for fracture care.

Trans-obturator cable fixation of open book pelvic injuries

Operative treatment of ruptured pubic symphysis by plating is often accompanied by complications. Trans-obturator cable fixation might be a more reliable technique; however, have not yet been tested for stabilization of ruptured pubic symphysis. This study compares symphyseal trans-obturator cable fixation versus plating through biomechanical testing and evaluates safety in a cadaver experiment. APC type II injuries were generated in synthetic pelvic models and subsequently separated into three different groups. The anterior pelvic ring was fixed using a four-hole steel plate in Group A, a stainless steel cable in Group B, and a titan band in Group C. Biomechanical testing was conducted by a single-leg-stance model using a material testing machine under physiological load levels. A cadaver study was carried out to analyze the trans-obturator surgical approach. Peak-to-peak displacement, total displacement, plastic deformation and stiffness revealed a tendency for higher stability for trans-obturator cable/band fixation but no statistical difference to plating was detected. The cadaver study revealed a safe zone for cable passage with sufficient distance to the obturator canal. Trans-obturator cable fixation has the potential to become an alternative for symphyseal fixation with less complications.

[Outcome after plate stabilization of symphyseal diastasis]

Hintergrund

Die Symphysensprengung mit entsprechender Diastase kann durch eine Symphysenplatte stabilisiert werden.

Fragestellung

Welche Beckenverletzungen werden mit einer Symphysenplatte stabilisiert und wie ist das Outcome?

Material und Methoden

Retrospektive Auswertung von 64 Patienten über einen Untersuchungszeitraum von 24 Monaten.

Ergebnisse

Es waren 56 Patienten männlich, 8 weiblich und das mittlere Alter betrug 44 Jahre (SD ± 17). Unfälle im Straßenverkehr waren der führende Grund für die Beckenverletzung. Die Verteilung nach AO-Klassifikation zeigte sich wie folgt: 14-mal B1-, 10-mal B2-, 5‑mal B3-, 23-mal C1-, 9‑mal C2- und 3‑mal C3-Verletzungen. Die Verteilung nach Young und Burgess ergab: 9‑mal APC-I-, 18-mal APC-II-, 13-mal APC-III-, 9‑mal LC-I-, 3‑mal LC-II-, 2‑mal LC-III- und 10-mal VS-Verletzungen. Der mittlere Injury Severity Score (ISS) betrug 32 und die mittlere stationäre Verweildauer 29 Tage (pos. Korrelation p ≤ 0,001). Im Verlauf war eine radiologische Implantatlockerung bei 52 Patienten nachweisbar. Therapierelevante Komplikationen gab es in 14 Fällen. Hierbei war das Implantatversagen (n = 8) der Hauptgrund für eine operative Revision.

Diskussion

Obwohl die radiologische Implantatlockerung häufig beobachtet wird, ist sie nur selten Grund für einen Revisionseingriff. Kommt es hingegen zum vollständigen Implantatversagen, tritt dies meist innerhalb der ersten postoperativen Wochen auf und ist revisionsbedürftig. Eine frühzeitige Abklärung durch Röntgenbildgebung sollte bei Verdacht erfolgen.

Pre-Surgery Planning of Lower Limbs Major Joints Arthroplasty

BACKGROUND:

Knee and hip joints endoprosthetics are the main surgical method of arthrosis treatment. The epidemiological incidence rate of the disease is growing steadily every year, affecting younger and younger people. Despite the proven tactics of joint endoprosthetics, an important issue is quality planning of surgery.

AIM:

The aim of this research is to develop a device and a method that would contribute to solving the existing challenges of pre-surgery planning of hip endoprosthetics in patients with related pathologies, which have caused compensatory deformation, and making long vertebrarium-pelvis-lower limbs scout images with the patient lying on his back with an axial load in a computer tomography.

METHODS:

Analog X-ray photographs of the pelvis made on film, digital DICOM images, and special planning programs are used for planning. However, according to numerous studies, the disease of the hip joint is not an independently isolated pathology. In most cases, this pathology is accompanied by changes in the lumbar spine. Often, patients prepared for endoprosthetics have a congenital deformity of tarsus or hip segment, which, during the knee, joint endoprosthetics surgery causes difficulties with the installation of an intramedullary guide.

RESULTS:

The results after total knee arthroplasty according to the method modified at the Department showed a reduction of the WOMAC index slightly more than twice down to 37.26 ± 7.92. The number of revision surgeries after endoprosthetics decreased from 5 (5.7%) to 1 (1.1%) for the hip joint, and from 7 (4.3%) to 2 (1.3%) for the knee joint, respectively.

CONCLUSION:

To form a proper guide entry point, it is necessary to assess the segment at the stage of surgery planning and examination of patients, which can be done using the proposed method. To remove the complications during the pre-surgery planning of hip joint endoprosthetics in patients with related pathologies, a device and methods have been developed for obtaining long topograms of the vertebrarium-pelvis-lower limbs complex with the patient lying on his back with the axial load in computer tomography.