Comparison of lateral and skyline fluoroscopic views for detection of prominent screws in distal radius fractures plating: results of an ultrasonographic study

Systematic use of short unicortical epiphyseal locking screws versus full-length unicortical locking screws in distal radius fracture volar plating: A prospective and comparative study

PURPOSE

Volar locking plates, used in distal radius fracture (DRF), present a risk of injuring extensor tendons with screws penetrating the dorsal cortex of the radius. Actually, even when aiming to use maximum-length unicortical locking screws, some still could be bicortical. We hypothesize the use of only short unicortical screws would allow a proper stabilization of the radial epiphysis without the risk of dorsal cortex penetration.

MATERIALS AND METHODS

A prospective monocentric non-randomized study was conducted. Patients with DRF (excepted for partial dorsal joint fractures) were treated in group A with short locking epiphyseal screws (16 mm for females, 18 mm for males) and in group B with full-length unicortical locking screws. Ultrasound was done 3 months postoperatively to evaluate the number and length of prominent dorsal screws. X-rays were performed after 6 weeks to assess stability according to volar tilt and radial inclination variations.

RESULTS

There were 37 patients in group A and 39 in group B with 148 and 156 epiphyseal screws, respectively. In group A, there were 0% of dorsal penetrating screws against 6.5% (10 screws from 8 patients) in group B (p < 0.05). There was no significant difference for the stability between the groups: mean volar tilt variation ( - 0.6° vs. - 0.7°) and mean radial inclination variation ( - 0.4° vs. - 0.4°).

CONCLUSION

For a same stability with volar locking plates for DRF, short epiphyseal locking screws should be preferred to full-length unicortical screws in order to prevent extensor tendon injuries. Based on 75% of distal radial average anteroposterior width for each sex, screw lengths of 16 mm for females and 18 mm for males seem to be the length to use. LEVEL OF EVIDENCE 2: Prospective, Comparisons made, non-randomized.

Salvage procedure after malunited distal radius fractures and management of pain and stiffness

Indications for surgical treatment of distal radius fractures (DRF) remain controversial in the literature, especially in elderly patients. Complication rates after operatively treated DRF are low and well documented. These include malunion, degenerative osteoarthritis in the radiocarpal joint and subsequently pain and impaired hand function. If conservative treatment fails then salvage procedures are necessary. This review summarizes the therapeutic options available to treat degenerative osteoarthritis after malunited distal radius fractures, regardless of the initial operative or conservative treatment.

Complications after operatively treated distal radius fractures

In the recent years, treatment of distal radius fractures (DRF) has advanced considerably. Surgical fixation with palmar angular stable plate has gained popularity, due to a reported lower complication rate when compared to dorsal fixation. The type of trauma or injury, surgical procedure and impaired bone quality are all contributors to complications in DRF. The main aim of this review is to summarize the most common complications and possible therapeutic solutions. In addition, strategies for minimizing these complications will be discussed.

Biomechanical considerations on a CT-based treatment-oriented classification in radius fractures

A wide range of different classifications exist for distal radius fractures (DRF). Most of them are based on plane X-rays and do not give us any information on how to treat these fractures. A biomechanical understanding of the mechanical forces underlying each fracture type is important to treat each injury specifically and ensure the optimal choice for stabilization. The main cause of DRFs are forces acting on the carpus and the radius as well as the position of the wrist in relation to the radius. Reconstructing the mechanism of the injury gives insight into which structures are involved, such as ruptured ligaments, bone fragments as well as the dislocated osteoligamentous units. This article attempts to define certain key fragments, which seem crucial to reduce and stabilize each type of DRF. Once the definition is established, an ideal implant can be selected to sufficiently maintain reduction of these key fragments. Additionally, the perfect approach is selected. By applying the following principles, the surgeon may be assisted in choosing the ideal form of treatment approach and implant selection.

Detection of dorsal screw penetration during volar plating of the distal radius fractures: A comparison of different fluoroscopic views and screw sizes

OBJECTIVE

The objective of this study was to compare different screw lengths combined with different fluoroscopic views to detect intraoperative dorsal screw penetration in distal radius fractures treated with volar locked plating.

MATERIAL AND METHODS

From April 2014 to October 2018, one hundred and eighty patients were included. We divided the patients into four groups. Intraoperative AP and lateral views were taken and sizes of the screws were chosen based on actual measurement (Group A, 45 patients). AP, lateral and tangential views were taken and sizes of the screws were also chosen based on actual measurement (Group B, 45 patients). Intraoperative AP and lateral views were taken and the selected screws were 2mm shorter than actual measurement (Group C, 45 patients). AP, lateral and tangential views were taken and the selected screws were 2mm shorter than actual measurement (Group D, 45 patients). Prominent screws were changed intraoperatively according to each view. A computed tomography (CT) was taken postoperatively to identify residual prominent screws.

RESULTS

The number of dorsally prominent screws exceeding 1mm was 6 of 301 in Group A (2.0%), 15 of 290 (5.2%) in Group B, 2 of 289 in Group C (0.7%), and 2 of 282 (0.7%) in Group D. All these prominent screws (25 screws) were exchanged for shorter screws during surgery. Group A and Group B had significant difference in detecting intraoperative dorsal screw penetration (p<0.05). Group C and Group D had no significant difference in detecting intraoperative dorsal screw penetration (p>0.05). Postoperative CT identified 12 additional prominent screws with≥1mm dorsal penetration in Group A, 2 screws in Group B, 1 screw in Group C and 0 screw in Group B respectively. Significant difference was found between Group A and Group B of CT results (p<0.05) while no statistical difference was found between Group C and Group D of CT results (p>0.05).

DISCUSSIONS

Tangential view helped identify screw penetration. If tangential view was not available intraoperatively, screw penetration could also be avoided by downsizing the distal locking screw by 2mm shorter than actual measurement.

Volar Plating: Imaging Modalities for the Detection of Screw Penetration

Background  Volar plating for distal radius fractures exposes the risk of extensor tendon rupture, mechanical problems, and osteoarthritis due to protruding screws. Purposes  The purpose of this review was to identify the best intraoperative diagnostic imaging modality to identify dorsal and intra-articular protruding screws in volar plating for distal radius fractures. Methods  The Preferred Reporting Items for Systematic Reviews and Meta-Analysis guidelines were followed for this review. In vitro and in vivo studies that analyzed the reliability, efficacy, and/or accuracy of intraoperatively available imaging modalities for the detection of dorsal or intra-articular screw protrusion after volar plating for distal radius fractures were included. Results  Described additional imaging modalities are additional fluoroscopic views (pronated views, dorsal tangential view [DTV], radial groove view [RGV], and carpal shoot through [CST] view), three-dimensional (3D) and rotational fluoroscopies, and ultrasound (US). For detection of dorsal screw penetration, additional fluoroscopic views show better results than conventional views. Based on small (pilot) studies, US seems to be promising. For intra-articular screw placement, 3D or 360 degrees fluoroscopy shows better result than conventional views. Conclusion  Based on this systematic review, the authors recommend the use of at least one of the following additional imaging modalities to prevent dorsal protruding screws: CST view, DTV, or RGV. Tilt views are recommended for intra-articular assessment. Of all additional fluoroscopic views, the DTV is most studied and proves to be practical and time efficient, with higher efficacy, accuracy, and reliability compared with conventional views. Level of Evidence  The level of evidence is Level III.

Three-dimensional kinematics of the flexor pollicis longus tendon in relation to the position of the FPL plate and distal radius width

INTRODUCTION

The standard therapy of intra-articular and extra-articular distal radius fractures consists of open reduction and stabilization using palmar osteosynthesis with an angularly stable plate. The integrity of the flexor pollicis longus tendon (FPLT) may be mechanically affected by the plate, with rupture rates between 1 and 12% reported in the literature, occurring during a postoperative time period from 4 to 120 months. The aim of this study was to investigate the position of the tendon in relation to the distal edge of the plate using high-resolution ultrasonic imaging.

MATERIALS AND METHODS

Nineteen patients undergoing osteosynthesis for distal radius fracture in 2015 with the Medartis^® APTUS^® FPL plate were included in this study. Of these, seven dropped out for various reasons. Therefore,  twelve patients with a median age of 52 years (range 24-82 years) were included in the final analysis. High-frequency ultrasound was performed within a median of 28 (range 10-52) weeks by an experienced radiology specialist to locate the FPLT position in two separate wrist positions: (1) wrist held in 0° position and fingers extended and (2) wrist held in 45° of dorsal extension and actively flexed fingers II to V (functional position). For analysis, we used the axial ultrasound videos. Postoperative X-rays and CT scans were included for the analysis, especially the soft-tissue CT scan window for the exact localization of the FPLT.  Dynamic ultrasound scanning was used to localize the FPLT in relation to the plate in 0° and functional position of the hand. Using CT scanning, the position of the plate relative to the bone was determined. In this way, we were able to correlate the functional FPLT position with the osseous structures of the distal radius.

RESULTS

In all cases, the FPLT was positioned closer to the volar distal edge of the FPL plate in functional position than in 0° position. In four cases, the FPLT did not touch the plate at all and was shown to shift diagonally from radio-volar in ulno-dorsal direction during wrist movement from 0° to functional position, similarly to the sliding of the tendon in the assumed physiological motion sequence. In these cases, in the functional position the center of the FPLT was positioned slightly ulnarly of the center of the distal radius (i.e., less than 50% of the distal radius width measured from the radial border of DRUJ), and positioned more ulnarly than in all other cases (i.e., in which the FPLT came into contact with the plate). In the remaining two-thirds of the cases (eight patients), the FPLT touched the plate during wrist movement from 0° to functional position, shifted in dorsal direction and slid into the plate indentation, irrespective of whether the tendon entered the indentation from the radial or the ulnar side, and independent of the ulnoradial position of the plate. No signs of tendinopathy of the FPLT were found in any of the cases.

CONCLUSION

The results show that the indentation of the Medartis^® APTUS^® FPL plate reduces the tendon-plate contact and ideally even prevents it entirely. In particular, ulnar positioning of the plate lowers the risk of tendon-plate contact. If the FPLT touches the plate, the tendon pulls into the plate indentation, thus lowering the contact. Consequently, the Soong criteria are not applicable when a FPL plate is used.

Early complications and radiological outcome after distal radius fractures stabilized by volar angular stable locking plate

INTRODUCTION

Distal radius fractures (DRF) are the most common fractures of the upper extremities. The incidence is expected to continue rising in the next years due to the increased life expectancy. Palmar locking plate stabilizing has since become the standard treatment for dorsally displaced DRF with a complication rate of 8-39% reported in the literature. Main aim of this study was to investigate the incidence of complications after DRF stabilization using palmar angular stable locking plate.

METHODS

A retrospective medical records review conducted from January 2013 to December 2016 included a total of 392 patients with DRF, that were stabilized using palmar angular stable locking plate and showed a minimum follow-up of 3 months. The group comprised 259 female and 133 male patients with a mean follow-up interval of 11 months (range 3-52 months). All recorded complications were documented. Range of motion (ROM) in extension, flexion, supination, pronation, radial- and ulnar deviation of the last follow-up was noted. Age was divided into younger than 65 years (< 65 years) and older than 65 years (≥ 65 years). The primary, immediate postoperative and final checkup radiographs were scrutinized for alignment and intra-articular step-off.

RESULTS

A total of 51 (13%) early and 17 late (4%) complications were recorded in 392 patients. The most common complications included carpal tunnel syndrome (3%), complex regional pain syndrome (3%) and loss of reduction (2%). Of the 68 complications, only 25 (6%) were directly related to the plate. 73% of all complications occurred in AO type C fractures. Patients without complications showed a significantly better ROM in extension, flexion, pronation and supination than patients with complications. No significant differences in incidence of complications, ROM or loss of reduction could be found between patients over and under 65 years of age. Gender and type of immobilization showed no significant influence on the complication rate.

CONCLUSIONS

Stabilization of DRF by palmar angular stable locking plate is a safe form of treatment. In the majority of the cases a good clinical and radiological outcome with no complications was documented. Gender and type of immobilization had no impact on the complication rate and an age over 65 years is not associated with an increased risk for complications or restricted ROM.

Distal radius fluoroscopic skyline view: extension-supination versus flexion-supination

The aim of our study was to compare the vertical fluoroscopic view of the wrist in extension and supination (ES) to the view in flexion and supination (FS) and determine which of the two views allowed the best visualization of four selected anatomical landmarks SDLR (radial styloid, dorsal radius cortex, Lister's tubercle and distal radioulnar joint). Our case series included 50 patients who had suffered a distal radius fracture and undergone an open reduction and internal fixation procedure with a volar locking plate. For each case, two fluoroscopic views were taken: ES (wrist extension and supination) (group I) and FS (wrist flexion and supination) (group II). Ten observers had to recognize the SDLR anatomical landmarks on 100 fluoroscopic skyline views (time 1) and 15 days later (time 2). The rate of recognition of the four anatomical landmarks was 78% in group I and 66% in group II (p < 0.001). The concordance rate of recognition of the four anatomical landmarks was mediocre (κ = 0.411). In conclusion, the vertical fluoroscopic skyline view in wrist extension and supination seems to be the most adequate view to assess the quality of the fracture reduction, the distal radioulnar joint and the length of the screws in open reduction and internal fixation of distal radius fractures with volar locking plates.