Bienzyme-based visual and spectrophotometric aptamer assay for quantitation of nanomolar levels of mercury(II)

Simple easy to make xanthene based optical probe for solid and liquid state Hg2+ ion detection

An easy to make xanthene based optical probe synthesized, precise recognition towards mercury ion been achieved by the probe RP and can detect Hg²⁺ effectively in both for solid and liquid state with a vivid color change. The other tested ion showed no interference, visual and instrumental methods confirms the probe selectivity. Stoichiometry (1:1) confirmed by job's plot, plausible binding of Hg²⁺ ion with the probe confirmed by mass and NMR studies. Test strip prepared for the prompt onsite detection in aqueous medium with outstanding color variation in daylight.

Ultrasensitive fluorometric biosensor based on Ti3C2 MXenes with Hg2+-triggered exonuclease III-assisted recycling amplification

Herein a fluorometric bioanalysis platform for mercury(ii) (Hg²⁺) detection was developed using two-dimensional MXenes (Ti₃C₂) as fluorescence quencher and Hg²⁺-induced exonuclease III-assisted target recycling strategy for efficient signal amplification.

Alginate-based magnetic nanosorbent immobilized with aptamer for selective and high adsorption of Hg2+ in water samples

Alginate-coated magnetic nanocluster (MNC) immobilized with Hg²⁺-specific aptamer was synthesized to obtain the nanosorbent with high adsorption capacity and high selectivity for trace analysis of inorganic mercury (Hg²⁺) in water samples. Magnetite nanoparticle was first synthesized by a co-precipitation of iron precursors in the presence of alginate to obtain alginate-coated MNC, followed by immobilization with avidin. Hg²⁺-Specific DNA aptamer labeled with biotin was then conjugated on the MNC surface via specific avidin-biotin interaction to form aptamer-immobilized MNC. Coating the MNC with alginate can improve its water dispersibility and also increase its adsorption capacity toward Hg²⁺ (350 mg/g). It exhibited high selectivity through thymine-Hg²⁺-thymine (T-Hg²⁺-T) interaction with high tolerance to other foreign ions. This nanosorbent showed linearity over the Hg²⁺ concentration range of 0.2-10 μg/L with a correlation coefficient of 0.9977, limit of detection of 0.46 μg/L, and enrichment factor of 13. Moreover, it also showed a potential for detection of Hg²⁺ in drinking and tap water samples with satisfactory recoveries.

Progress in rapid optical assays for heavy metal ions based on the use of nanoparticles and receptor molecules

This review (with 230 refs.) covers recent progress in rapid optical assays for heavy metals (primarily lead and mercury as the most relevant) based on the use of nanoparticles and receptor molecules. An introduction surveys the importance, regulatory demands (such as maximum permissible concentrations) and potential and limitations of various existing methods. This is followed by a general discussion on the use of nanoparticles in optical assays of heavy metals (including properties, basic mechanisms of signal generation). The next sections cover methods for the functionalization of nanoparticles with (a) sulfur-containing compounds (used for modification of nanoparticles or added to the reaction medium), (b) nitrogen-containing compounds (such as amino acids, polypeptides, and heterocyclic molecules), and (c) oxygen-containing species (such as hydroxy and carbonyl compounds). This is continued by a specific description of specific assays based on the use of aptamers as receptors, on the use of deoxyribozymes as synthetic reaction catalysts, of G-quadruplex aptamers, of aptamers in logic gate-type of assays of linear (unstructured) aptamers ("hairpins"), and on the use of aptamers in lateral flow assays. A next section covers assays based on the employment of antibodies as receptors (used in the immunoassay development). The properties of various nanoparticles and their applicability in optical assays are also discussed in some detail. Final sections discuss the selectivity of assays, potential interferences by other cations, methods for their elimination, and also matrix effects and approaches for sample pretreatment. A concluding section discusses current challenges and future trends. Analysis based on enzyme inhibition assay is not treated here but enzyme-like action of some receptor molecules such as DNAzymes is discussed. Graphical abstract Schematic presentation of main principles of application of various nanoparticles with receptor molecules (S-, N-, O-containing, heterocyclic compounds, proteins, antibody, aptamers) for heavy metals ions detection. The included methods cover optical assays with description of mechanisms of interactions and signal generation.

Graphitic carbon nitride quantum dots as an "off-on" fluorescent switch for determination of mercury(II) and sulfide

A rapid method has been developed for the determination of Hg(II) and sulfide by using graphitic carbon nitride quantum dots (g-CNQDs) as a fluorescent probe. The interaction between Hg(II) and g-CNQDs leads to the quenching of the blue g-CNQD fluorescence (with excitation/emission peaks at 390/450 nm). However, the fluorescence can be recovered after addition of sulfide such that the "turn-off" state is switched back to the "turn-on" state. The g-CNQDs were fully characterized by transmission electron microscopy, X-ray diffractometry, X-ray photoelectron spectroscopy, Fourier transform infrared spectroscopy, UV-vis absorption and fluorescence spectroscopy. Under the optimal experimental conditions, this probe is highly selective and sensitive to Hg(II). The linear response to Hg(II) extends from 0.20 to 21 μM with a detection limit of 3.3 nM. In addition, sulfide can be detected via the recovery of fluorescence. The linear response range for sulfide species is from 8.0 to 45 μM with a detection limit of 22 nM. The mechanism of the "turn-off-on" scheme is discussed. The methods have been applied to the analysis of spiked tap water, lake water and wastewater samples. Graphical abstract Schematic of an off-on fluorescent probe for mercury(II). The fluorescence of graphitic carbon nitride quantum dots (g-CNQDs) is quenched by Hg²⁺ but is recovered after reacting with S^2- as it can combine with Hg²⁺ on the surface of g-CNQDs.

An ultrasensitive conformation-dependent colorimetric probe for the detection of mercury(II) using exonuclease III-assisted target recycling and gold nanoparticles

An ultrasensitive conformation-dependent colorimetric assay has been developed for the detection of mercury(II) ions. It is based on the use of exonuclease III (Exo III)-assisted target recycling and gold nanoparticles (AuNPs). In the absence of Hg(II), the hairpin-shaped DNA probe (H-DNA) binds to AuNPs and stabilizes them in solutions of high ionic strength. In the presence of Hg(II), on the other hand, the sticky termini of the H-DNA form a rigid DNA duplex stem with a blunt 3'-terminus. Thus, Exo III is activated as a biocatalyst for selective and stepwise removal of mononucleotides from the 3'-terminus of the H-DNA. As a result, Hg(II) is released from the T-Hg(II)-T complexes. The guanine-rich sequences released from the H-DNA are then self-assembled with potassium ion to form a stable G-quadruplex conformation. In solutions of high ionic strength, this results in aggregation of AuNPs and a color change from red to blue which can be seen with bare eyes. The method is highly sensitive and selective. It has a linear response in the 10 pM to 100 nM Hg(II) concentration range, and the detection limit is as low as 3.2 pM (at an S/N ratio of 3). The relative standard deviation at a level of 0.5 nM of Hg(II) is 4.9% (for n = 10). The method was applied to the detection of Hg(II) in spiked environment water samples, with recoveries ranging from 92% to 106%. Graphical abstract A conformation-dependent colorimetric system was fabricated for label-free detection of mercury(II) by utilizing exonuclease III(Exo III)-assisted target recycling and gold nanoparticles (AuNPs).

Visual detection of trace lead ion based on aptamer and silver staining nano-metal composite

In this paper, visual detection of trace lead ion was established by aptamer and silver staining. The basic strategy was that aminated PS2.M aptamer was immobilized onto slide and formed stable G-quadruplex structure. PbS was generated by adding S^2-, and it catalyzed subsequent silver staining reaction, through the silver staining amplification effect, the slide presented visible ash black. The gray value of slide after silver staining was analyzed and the semi-quantitative detection of Pb²⁺ in solution was realized. The results showed that optical darkness ratio (ODR) and logarithmic value of Pb²⁺ concentration had a good linear relationship (R² = 0.951) over the range of 0.5-10 μM. In addition, there was no obvious interference of other common metal ions for the detection, indicating that this method presented outstanding selectivity. And it was also used for qualitative and semi-quantitative determination of Pb²⁺ in soil sample successfully.