Electrochemical exfoliation of pencil graphite for preparation of graphene coating as a new versatile SPME fiber for determination of polycyclic aromatic hydrocarbons by gas chromatography

Surfactant-enhanced air-agitation liquid-liquid microextraction of polycyclic aromatic hydrocarbons from edible oil using magnetic deep eutectic solvent prior to HPLC determination

Herein, an air-agitation liquid-liquid microextraction procedure was developed for the extraction of several polycyclic aromatic hydrocarbons from edible oil samples. In this study, the extraction procedure was achieved using a new magnetic deep eutectic solvent as the extraction solvent, in which there was no need for centrifugation. To enhance the rate of extraction of the analytes from the samples, the method was promoted by the use of surfactant addition. The extracted analytes were determined by high-performance liquid chromatography with a diode array detector. The influence of various parameters on the extraction efficiency was studied by response surface methodology using a central composite design. Under optimal conditions, linear calibration curves for the target analytes were achieved in the range of 0.43-250 ng g-1. The limits of detection and quantification were in the ranges of 0.04-0.13 and 0.13-0.43 ng g-1, respectively. The repeatability of the method in terms of intra- and inter-day precision was ≤4.7% and ≤6.7%, respectively. The extraction recovery of the method ranged from 75 to 88%. The obtained results show that the proposed method is efficient for the analysis of the target analytes in various oil samples without obvious matrix effects. Pyrene was found in olive oil at a concentration of 42 ng g-1.

Biochar nanosphere-functionalized carbon fibers for in-tube solid-phase microextraction of polycyclic aromatic hydrocarbons in environmental water followed by liquid chromatography and diode array detection

In order to improve the extraction ability of carbon fibers (CFs) for microextraction of polycyclic aromatic hydrocarbons (PAHs), biochar nanospheres derived from glucose were in-situ grown onto the surface of CFs via hydrothermal synthesis. The surface morphology and elemental composition of biochar nanospheres-CFs were investigated by scanning electron microscopy and X-ray photoelectron spectroscopy. Thereafter, the biochar nanosphere-CFs were pulled into the polyetheretherketone tube for solid-phase microextraction, and the tube was combined with high-performance liquid chromatography-diode array detector to online detect PAHs. With the help of π-stacking, hydrophobic, and hydrophilic effect of biochar nanospheres, the extraction efficiency of CFs was greatly enhanced (enrichment factor increased by 293% compared with  the original). The conditions affecting the analytical performance (sampling volume, sampling rate, methanol content, and desorption time) were investigated. Under the optimal conditions, an online analytical method for microextraction and determination of several PAHs was developed, and satisfactory results were achieved. The limits of detection were 0.003-0.010 ng mL-1 owing to high enrichment effect (2973-3600), linearity ranged from  0.010-15.0 ng mL-1, and relative standard deviations were 0.4%-1.6% (intra-day) and 2.4%-4.4% (inter-day), respectively. The method was applied to analyze environmental water samples (rain water, snow water, and river water), and spiked recoveries within 80.0%-119% were obtained.

Development of a Pt-graphene nanocomposite-based solid-phase extraction coupled with ultra-performance liquid chromatography-tandem mass spectrometry for the determination of carbamate pesticides in fish

In the present work, a potential solid-phase extraction (SPE) material based on graphene anchored with platinum nanoparticles (Pt-Graphene) was prepared and characterized by scanning electron micrographs and transmission electron micrograph. The carbamates residues in fish were enriched by SPE filled with Pt-Graphene and detected by ultra-performance liquid chromatography-tandem mass spectrometry (UPLC-MS/MS). The proposed extraction protocol exhibited satisfactory recoveries (76.5-115.6%), low limit of quantitation values in μg kg^-1 level, and good precision for the studied ten carbamates. These results demonstrated the feasibility of the proposed protocol. The developed Pt-Graphene nanoparticles showed excellent performance for extracting analytes at trace levels, indicating that it could be used as a potential SPE sorbent in food residue analysis.

Interfacial Characterization of Polypyrrole/AuNP Composites towards Electrocatalysis of Ascorbic Acid Oxidation

Polypyrrole (PPy) is an interesting conducting polymer due to its good environmental stability, high conductivity, and biocompatibility. The association between PPy and metallic nanoparticles has been widely studied since it enhances electrochemical properties. In this context, gold ions are reduced to gold nanoparticles (AuNPs) directly on the polymer surface as PPy can be oxidized to an overoxidized state. This work proposes the PPy electrochemical synthesis followed by the direct reduction of gold on its surface in a fast reaction. The modified electrodes were characterized by electronic microscopic and infrared spectroscopy. The effect of reduction time on the electrochemical properties was evaluated by the electrocatalytic properties of the obtained material from the oxidation of ascorbic acid (AA) and electrochemical impedance spectroscopy studies. The presence of AuNPs improved the AA electrocatalysis by reducing oxidation potential and lowering charge transfer resistance. EIS data were fitted using a transmission line model. The results indicated an increase in the electronic transport of the polymeric film in the presence of AuNPs. However, PPy overoxidation occurs when the AuNPs’ deposition is higher than 30 s. In PPy/AuNPs 15 s, smaller and less agglomerated particles were formed with fewer PPy overoxidized, confirming the observed electrocatalytic behavior.

Contemporary Research Progress on the Detection of Polycyclic Aromatic Hydrocarbons

Polycyclic aromatic hydrocarbons (PAHs) are a class of the most common and widespread contaminants. The accumulation of PAHs has made a certain impact on the environment and is seriously threatening human health. Numerous general analytical methods suitable for PAHs were developed. With the development of economy, the environmental problems of PAHs in modern society are more extensive and prominent, and attract more attention from environmental scientists and analysts. Deeper understanding of the properties of PAHs depends on the advent of detection methods, which can also be more conducive to promoting the protection of the environment. Till now, more sensitive, more high-speed and more high-throughput analytical tools are being invented and have played important roles in the research of PAHs. In this short review article, we focused mainly on the contemporary analytical methods about PAHs. We started with a brief review on the hazards, migration, distribution and traditional analysis methods of PAHs in recent years, including liquid chromatography, gas chromatography, surface enhanced Raman spectroscopy and so on. We also presented the applications of the modern ambient mass spectrometry, especially microwave plasma torch mass spectrometry, in the detection of PAHs, as well as the far out novel results in our lab by using microwave plasma torch (MPT) mass spectrometry; for example, some new insights about Birch reduction, regular hydrogen addition and the robustness of molecular structure. These studies have demonstrated the versatility of MPT MS as a platform in the research of PAHs.

GNP/Al-MOF nanocomposite as an efficient fiber coating of headspace solid-phase micro-extraction for the determination of organophosphorus pesticides in food samples

The synthesis and utilization of a high porous nanocomposite comprising MIL-53(Al) metal-organic framework (Al-MOF) and graphene nanopowder (GNP) is reported as a fiber coating for headspace solid-phase micro-extraction (HS-SPME) of selected organophosphorus pesticides (OPPs) from apple, potato, grape juice, tomato, and river water. The adsorbed OPPs on the coated fiber were subsequently determined using GC-MS. Several parameters affecting the efficiency of extraction including time and temperature of extraction, desorption condition of extracted analytes, pH and agitation of sample solution, and salt concentration were investigated. The optimum extraction condition was achieved at 70 °C with an extraction time of 40 min, pH = 4-8, and NaCl concentration of 6.0% (w/v). The best condition of desorption were observed at 280 °C for 2.0 min under a flow of helium gas in the GC inlet. Under optimal conditions, the detection limits ranged from 0.2 to 1.5 ng g^-1 and the linear ranges between 0.8 and 600 ng g^-1. The proposed method showed very good repeatability with RSD values ranging from 4.5 to 7.3% (n = 5). The relative recoveries were between 88% and 109% at the spiked level of 25.0 ng g^-1 for the tomato sample. The fabricated fiber exhibited good enrichment factor (62-195) at optimum condition of HS-SPME. The applied HS-SPME technique is facile, fast, and inexpensive. The thermally stable GNP/Al-MOF exhibited a high sensitivity toward OPPs. So, this nanocomposite can be considered as a sorbent for the micro-extraction of other pesticides in food.

[Recent advance of new sample preparation materials in the analysis and detection of environmental pollutants]

To successfully analyze complex samples and detect trace targets, sample pretreatment is essential. Efficient sample pretreatment techniques can remove or reduce interference from the sample matrix. It can also enrich analytes, thereby improving analytical accuracy and sensitivity. In recent years, various sample preparation techniques, including SPE, magnetic dispersion SPE, pipette tip SPE, stir bar extraction, fiber SPME, and in-tube SPME, have received increasing attention in environmental analysis and monitoring. The extraction efficiency mainly depends on the type of adsorbent material. Therefore, the development of efficient adsorbents is a crucial step toward sample preparation. This review summarizes and discusses the research advances in extraction materials over recent years. These extraction materials contain inorganic adsorbents, organic adsorbents, and inorganic-organic hybrid materials such as graphene, graphene oxide, carbon nanotubes, inorganic aerogels, organic aerogels, triazinyl-functionalized materials, triazine-based polymers, molecularly imprinted polymers, covalent organic frameworks, metal-organic frameworks, and their derivatives. These materials have been applied to extract different types of pollutants, including metal ions, polycyclic aromatic hydrocarbons, plasticizers, alkanes, phenols, chlorophenols, chlorobenzenes, polybrominated diphenyl ethers, perfluorosulfonic acids, perfluorocarboxylic acids, estrogens, drug residues, and pesticide residues, from environmental samples (such as water and soil samples). These sample preparation materials possess high surface areas, numerous adsorption sites, and allow extraction via various mechanisms, such as π-π, electrostatic, hydrophobic, and hydrophilic interactions, as well as hydrogen and halogen bond formation. Various sample pretreatment techniques based on these extraction materials have been combined with various detection methods, including chromatography, mass spectrometry, atomic absorption spectroscopy, fluorescence spectroscopy, and ion mobility spectroscopy, and have been extensively used for the determination of environmental pollutants. The existing challenges associated with the development of sample preparation techniques are proposed, and prospects for such extraction materials in environmental analysis and monitoring are discussed. Major trends in the field, including the development of efficient extraction materials with high enrichment ability, good selectivity, excellent thermal stability, and chemical stability, are discussed. Green sample pretreatment materials, environmentally friendly synthesis methods, and green sample pretreatment methods are also explored. Rapid sample pretreatment methods that can be conducted within minutes or seconds are of significant interest. Further, online sample pretreatment and automatic analysis methods have attracted increasing attention. Besides, real-time analysis and in situ detection have been important development directions, and are expected to be widely applicable in environmental analysis, biological detection, and other fields. Modern synthesis technology should be introduced to synthesize specific extraction materials. Controllable preparation methods for extraction materials, such as the in situ growth or in situ preparation of extraction coatings, will acquire importance in coming years. It will also be important to adopt high-performance materials from other fields for sample pretreatment. Organic-inorganic hybrid extraction materials can combine the advantages both organic materials and inorganic materials, and mutually compensate for any disadvantages. Extraction materials doped with nanomaterials are also promising. Although existing sample pretreatment techniques are relatively efficient, it is still imperative to develop novel sample preparation methods.

Triazine-based covalent porous organic polymer for the online in-tube solid-phase microextraction of polycyclic aromatic hydrocarbons prior to high-performance liquid chromatography-diode array detection

A triazine-based covalent organic porous polymer (COP) was synthesized from the monomers 1,3,5-triphenylbenzene and tricyanogen chloride via the Friedel-Crafts reaction and characterized in detail using Brunauer-Emmett-Teller analysis, X-ray photoelectron spectroscopy, elemental analysis, and scanning electron microscopy, which confirmed that the COP had a rough surface and suitable extraction site. It was then employed in in-tube solid-phase microextraction combined with a high-performance liquid chromatography-diode array detector. The COP adsorbent was evaluated with different types of analyte, including estrogens, polycyclic aromatic hydrocarbons (PAHs), and plasticizers. The COP produced its best performance with PAHs. In order to obtain the highest extraction efficiency for PAHs, the main influential factors were optimized. Furthermore, a sensitive analytical method was established with the limits of detection of 0.004-0.010 µg L^-1, high enrichment factor of 1110-2763, and wide linear ranges (0.013-20.0 µg L^-1, 0.016-20.0 µg L^-1 and 0.033-20.0 µg L^-1). The relative standard deviation in intra-day and inter-day tests was also controlled to be within 0.3-3.1%. The proposed method was employed in the online detection of trace PAHs in real water samples, with satisfactory results obtained.

Magnetic solid phase extraction of heterocyclic aromatic hydrocarbons from environmental water samples with multiwalled carbon nanotube modified magnetic polyamido-amine dendrimers prior to gas chromatography-triple quadrupole mass spectrometer

Present study described a sensitive and efficient method for determination of heterocyclic aromatic hydrocarbons using multiwalled carbon nanotubes modified magnetic polyamido-amine dendrimers (MNPs@PAMAM-Gn@MWCNTs) as adsorbent for magnetic solid-phase extraction (MSPE) coupled with gas chromatography-triple quadrupole mass spectrometer (GC-MS/MS). Some pivotal parameters including PAMAM generation, adsorbent dosage, adsorption time, elution time and volume, pH and humic acid concentration were investigated to achieve the best adsorption efficiencies. Under the optimal conditions, 7-methylquinoline, dibenzothiophene and carbazole had good linearity in the concentration range of 0.005-20 μg L ^- 1, 9-methylcarbazole, 4-methyldibenzothiophene and 4,6-dimethyl dibenzothiophene had good linearity in the concentration range of 0.001-20 μg L ^- 1. All the correlation coefficients were higher than 0.996. The detection limits of the targets were in the range of 2.2 × 10^-4-1.8 × 10^-3 μg L ^- 1 with precisions less than 8.28% (n = 6). The enrichment factors were in the range of 141-147. The spiked recoveries were in the range of 87.0%-115.1% (n = 3). These results indicated that the method could be a reliable alternative tool for monitoring trace heterocyclic aromatic hydrocarbons in environmental water samples.