A visual and reversible nanoprobe for rapid and on-site determination of hexavalent chromium and lysine based on dual-emission carbon quantum dots coupled with smartphone

Hydrothermal route upcycling surgical masks into dual-emitting carbon dots as ratiometric fluorescent probe for Cr (VI) and corrosion inhibitor in saline solution

Exploration effective route to convert plastic waste into valuable carbon dots with bifunction of metal fluorescence monitoring and corrosion protection in seawater is promising. Herein, using "white-pollution" polypropylene surgical masks as a single precursor, dual-emitting carbon dots (CDs) with excellent ratiometric fluorescent sensitivity and corrosion inhibitor efficiency were fabricated with high yield (∼100 %) by a one-pot in situ acid oxidation hydrothermal strategy without post-treatment and organic solvents. Chemical, structural, morphological, optical properties and the Cr (VI) detection and Cu inhibition mechanism of the synthesized CDs had been systematically studied. Furthermore, a dual-response-OFF proportional fluorescent probe had been developed for the detection of the analyte Cr (VI) with a low detection limit of 24 nM. Additionally, the corrosion inhibition efficiency of the prepared CDs reached approximately 94.01 % for Cu substrate in 3.5 wt% NaCl electrolyte under a CDs concentration of 200 mg/L, which is higher than that of most previous reports.

High-efficient nickel-doped lignin carbon dots as a fluorescent and smartphone-assisted sensing platform for sequential detection of Cr(VI) and ascorbic acid

Using lignin as a raw material to prepare fluorescent nanomaterials represents a significant pathway toward the high-value utilization of waste biomass. In this study, Ni-doped lignin carbon dots (Ni-LCDs) were rapidly synthesized with a yield of 63.22 % and a quantum yield of 8.25 % using a green and simple hydrothermal method. Exploiting the inner filter effect (IFE), Cr(VI) effectively quenched the fluorescence of the Ni-LCDs, while the potent reducing agent ascorbic acid (AA) restored the quenched fluorescence, thus establishing a highly sensitive fluorescence switch sensor platform for the sequential detection of Cr(VI) and AA. Importantly, the integration of a smartphone facilitated the portability of Cr(VI) and AA detection, enabling on-site, in-situ, and real-time monitoring. Ultimately, the developed fluorescence and smartphone-assisted sensing platform was successfully applied to detect Cr(VI) in actual water samples and AA in various fruits. This study not only presents an efficient method for the conversion and utilization of waste lignin but also broadens the application scope of the CDs in the field of smart sensors.

Chiral carbon dots derived from tryptophan and threonine for enantioselective sensing of L/D-Lysine

Presently, most fluorescent probes for amino acid enantiomers detection require metal ions participation, which greatly increases the detection steps and costs, and affects the accuracy of detection results. To solve this problem, a dual pattern recognition sensor of chiral carbon dots (L-Try-Thr-CDs) with a quantum yield of 36.23 % was prepared by a one-step solvothermal method for the highly selective detection of lysine (Lys) enantiomers. Under optimal experimental conditions, the fluorescence and circular dichroism (CD) signals of the obtained L-Try-Thr-CDs could rapidly and effectively responded to L-Lys with limits of detection (LOD) of 16.51 nM and 24.38 nM, respectively, much lower than previously reported sensors. Importantly, the L-Try-Thr-CDs as a dual-mode sensor could not only detect amino acid enantiomers and simplify the steps, but also avoid inaccurate detection results due to unstable metal ions. Furthermore, the L-Try-Thr-CDs could detect L-Lys in living cells via a fluorescence microscope because of their excellent fluorescence characteristics and low toxicity. These results indicated that the dual-mode sensor not only provided a practical strategy for the design of new fluorescent probes, but also possessed outstanding application prospects in the accurate detection of lysine enantiomers.

Multi-functional ratiometric detection based on dual-emitting N-doped carbon dots

Ratiometric fluorescence probes based on multi-emission carbon dots improve accuracy and sensitivity on detecting various environment issues. Herein, a novel dual-emitting N-doped carbon dots (N-CDs) was synthesized from citric acid and urea via a solvothermal method in N,N-dimethylformamide (DMF). The blue and orange emissions of N-CDs in water were modulated, and pure white light-emitting with Commission Internationale de L'Eclairage (CIE) coordinates of (0.33, 0.33) was achieved. The two PL centers behaved differently for Fe3+, Cu2+ and Ag+ ions, with the limit of detection (LOD) of ppm as fluorescence probes. Additionally, N-CDs displayed unique solvatochromism phenomenon. A new green emission appeared in organic solvents and gradually quenched with the increase of solvent polarity. The ratiometric PL displayed an excellent linear response for detecting water, and the LOD was between 0.003 % and 0.3 % in DMF, ethanol, isopropanol and N-methylpyrrolidone. Furthermore, N-CDs exhibited pH-sensitive response in the range of 4.0-7.0 and temperature-dependent response during heating-cooling cycles between 15 and 70 °C. A simple, efficient and reliable multi-functional ratiometric probe for detecting metal ions, water content, pH and temperature simultaneously was realized. However, there is a need for future application research to overcome the limitation imposed by the excitation wavelength of 330 nm.

Visual and rapid fluorescence sensing for hexavalent chromium by hydroxypropyl chitosan passivated bismuth-based perovskite quantum dots

Hydroxypropyl chitosan-Cs3Bi2Cl9 perovskite quantum dots (HPCS-PQDs) were synthesized by a simple ligand-assisted reprecipitation method via green hydroxypropyl chitosan as the ligand and used as the specific signal of a fluorescence probe to achieve the highly sensitive detection of hexavalent chromium (Cr(VI)) and compared with chitosan-Cs3Bi2Cl9 QDs (CS-PQDs). HPCS-PQDs with multiple active hydroxyl passivations were found to enhance the photoluminescence quantum yield (PLQY) by 90%. After being placed in aqueous solution and irradiated with ultraviolet light for 96 h the fluorescence intensity of HPCS-PQDs remained above 60%. The blue emission of HPCS-PQDs has a good selectivity and short response time (30 s) for Cr(VI). A good linear relationship is established between the fluorescence quenching rate of the HPCS-PQDs and concentration of Cr(VI) from 0.8 to 400 µM, with a limit of detection (LOD) of 0.27 µM. The fluorescence quenching mechanism is the static quenching and internal filtration effect caused by HPCS-PQDs forming a non-fluorescent ground-state complex with Cr(VI). The sensor can not only be used to detect Cr(VI) in water samples with high accuracy but can also be prepared as a test paper for the detection for Cr(VI).

Near-infrared fluorescent probe with large Stokes shift for specific detection of lysine

A new near-infrared (NIR) fluorescent probe CL based on coumarin- dicyanoisophorone was synthesized. Addition of Lys to probe CL solution in DMF/H2O (9:1, v/v) medium resulted in noticeable enhancement in the intensity of the fluorescence emission at 702 nm, accompanying distinct color change from yellow to pink. While addition of other amino acids and biothiols (Gly, Hcy, GSH, Glu, Val, Tyr, Arg, Trp, Lys, His, Leu, Phe, Asp and Met) did not bring about substantial changes in both fluorescence emission and color. The detection limit was calculated to be 0.51 μM. Job's plot test revealed that probe CL and Lys formed a complex of 1:1 stoichiometry. Probe CL showed high stability and could be used to recognize Lys in a wide pH range of 4.0-10.0. The sensing mechanism was proposed and verified by 1H NMR spectral measurement. The dual-modal fluorescence turn-on and colorimetric NIR probe with an extremely large Stokes shift of 280 nm may be utilized for highly specific and practical sensing of Lys.

A Review of Dual-Emission Carbon Dots and Their Applications

Carbon dots (CDs), as a rising star among fluorescent nanomaterials with excellent optical properties and fascinating dual-emission characteristics, have attracted increasing attention in sensing, bio-imaging, drug delivery, and so on. The synthesis of dual-emission CDs (DE-CDs) and the establishment of ratiometric fluorescence sensors can effectively diminish background interference and provide more accurate results than single-emission CDs. Although DE-CDs have generated increased attention in many fields, the review articles about DE-CDs are still insufficient. Therefore, we summarized the latest results and prepared this review. This review first provides an overview of the primary synthesis route and commonly used precursors in DE-CDs synthesis. Then, the photoluminescence mechanism behind the dual-emission phenomenon was discussed. Thirdly, the application of DE-CDs in metal cation detection, food safety analysis, biosensing, cell imaging, and optoelectronic devices has been extensively discussed. Finally, the main challenges and prospects for further development are presented. This review presents the latest research progress of DE-CDs synthesis and its application in ratiometric sensing; hopefully, it can help and encourage researchers to overcome existing challenges and broaden the area of DE-CDs research.