Effect of brewing conditions on caffeine content in tea infusions simulating home-made cup of tea

On the relative extraction rates of colour compounds and caffeine during brewing, an investigation of tea over time and temperature

Various beliefs are common about the extraction of soluble compounds from leaf tea, suggesting that cold brewed tea or tea brewed for a shorter time than usual may contain a higher polyphenol-to-caffeine ratio, a selling point due to the potential health benefits of polyphenolic compounds. To test these beliefs, we investigated the effect of brewing time and temperature on the colour intensity and caffeine content of the extract of one type of black tea. Results showed that the extraction of the two components of interest had different half-lives, with an initial large variation of the ratio between them rapidly reaching a quite constant value. At different temperatures, a significantly different ratio between caffeine and colour compounds was observed. Although the difference in relative concentration was small, the range of brewing temperatures tested was only 20 Kelvin, so it seems possible to increase this difference. A difference in total extraction efficiency of both components together was noted too. To effectively change the ratio of the components using the extraction time would require using accurate times of less than 3 minutes and accurate temperatures unusual in a home environment.

Effect of brewing conditions using a single-serve coffee maker on black tea (Lapsang Souchong) quality

Black tea powder was used to make tea infusion using a Keuring coffee maker. Effect of tea particle size (0.30 or 0.60 mm), water volume for brewing (118, 177, or 236 ml), and the amount of tea powder (1.0, 1.5, or 2.0 g) on tea infusion quality were evaluated. The concentration of four chemical compounds (soluble sugars, total amino acids, polyphenols, and caffeine) in tea infusion was measured. In general, the concentration of the four compounds in tea infusion increased with the amount of tea powder used and decreased with increasing water volume and tea particle size. Using 2.0 g of 0.30 mm tea powder and 118 ml of water per brew, the concentration of the above four components was 412.3, 251.6, 208.9, and 205.3 μg/ml, respectively, and higher than tea infusion prepared by traditional method (312.4, 204.1, 211.6, and 175.9 μg/ml). The highest extraction efficiency (mg/cup.g) for the four chemical components per unit weight of tea powder was at using 1.0 g of 0.30 mm tea powder with 236 ml water for soluble sugars (32.3 μg/ml) and caffeine (16.3 μg/ml), at using 1.5 g tea powders for polyphenols (22.3 μg/ml) and at using 2.0 g tea powders for amino acid (13.6 μg/ml). This study suggested using a single-serve coffee maker can be a convenient and effective way to prepare the tea infusion with high quality.