Solvent effects on the photoelectrochemical properties of WO3 and its application as dopamine sensor

Development of novel nanocomposite-modified photoelectrochemical sensor based on the association of bismuth vanadate and MWCNT-grafted-molecularly imprinted poly(acrylic acid) for dopamine determination at nanomolar level

This study proposes the development of a new photoelectrochemical (PEC) sensor for the determination of dopamine (DA) at nanomolar levels. The PEC sensor was based on a physical mixture of bismuth vanadate (BiVO4) with nanocomposite molecularly imprinted poly(acrylic acid) (MIP-AA) grafted onto MWCNTox by using the surface-controlled radical polymerization strategy with an INIFERTER reagent. XRD, diffuse reflectance spectroscopy (DRE), SEM, TEM, and TGA were employed to characterize the materials. Photoelectrochemical analyses were carried out with GCE/BiVO4/MIP-AA sensor under visible light using a potential of 0.6 V, phosphate buffer (0.1 mol L-1) at pH 7.0, and modifying the GCE with a film composed of monoclinic BiVO4 at 3.5 mg mL-1 and nanocomposite MIP prepared with acrylic acid (MIP-AA) at 0.1 mg mL-1. The proposed method using the GCE/BiVO4/MIP-AA sensor presented a limit of detection (LOD) of 2.9 nmol L-1, a linear range from 9.7 to 150 nmol L-1 and it was successfully applied for analysis of DA in urine samples using external calibration curve yielding recovery values of 90-105%. Additionally, the proposed PEC sensor allowed DA determination without interference from uric acid, ascorbic acid, epinephrine, norepinephrine, and other unwanted interferences.

Detection of pollutants in water bodies: electrochemical detection or photo-electrochemical detection?

The massive discharge of pollutants including endocrine-disrupting chemicals (EDCs), heavy metals, pharmaceuticals and personal care products (PPCPs) into water bodies is endangering the ecological environment and human health, and needs to be accurately detected. Both electrochemical and photo-electrochemical detection methods have been widely used for the detection of these pollutants, however, which one is better for the detection of different environmental pollutants? In this feature article, different electrochemical and photo-electrochemical detection methods are summarized, including the principles, classification, common catalysts, and applications. By summarizing the advantages and disadvantages of different detection methods, this review provides a guide for other researchers to detect pollutants in water bodies by using electrochemical and photo-electrochemical analysis.

Photo-electrochemical detection of dopamine in human urine and calf serum based on MIL-101 (Cr)/carbon black

A new photo-electrochemical sensor based on MIL-101(Cr) MOF/carbon black (CB) is fabricated and characterized. By using differential pulse voltammetry, dopamine (DA) can be effectively detected using a photo-electrochemical MIL-101(Cr)/CB sensor under visible light. The CB acts as the electron bridge to combine with the large specific surface area and photo-catalytic feature of MOF, which contribute to the improvements of sensitivity of DA detection. The concentration of the catalyst, pH value, accumulation potential, and accumulation time were also optimized. Furthermore, the electrochemical performances of MIL-101(Cr)/CB sensor was investigated by cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS), scan rate, electrochemically active surface area (ECSA), and amperometric responses. A detection limit of 0.38 nM (LOD = 3 s_b/S, s_b = 0.028) and a working range of 1 nM to 2.22 μM has been achieved. The MIL-101(Cr)/CB sensor exhibits excellent reproducibility, stability, and selectivity and also has satisfactory recovery rate for the analysis of real samples including calf serum and human urine. Graphical abstract.

The design and growth of peanut-like CuS/BiVO4 composites for photoelectrochemical sensing

In this study, the CuS/BiVO₄-X (where X represents the mass percentage of CuS associated with CuS/BiVO₄; X = 2%, 5% and 7%) p–n heterostructures were fabricated using a two-step hydrothermal method.

Comparison between electrochemical and photoelectrochemical detection of dopamine based on titania-ceria-graphene quantum dots nanocomposite

In this study, titania-ceria-graphene quantum dot (TC-GQD) nanocomposite was synthesized by hydrothermal method for the first time. The prepared nanomaterials were characterized by XRD, FTIR dynamic light scattering (DLS), FESEM, HRTEM, and EDX spectroscopy along with elemental mapping. The synergistic effect of the nanocomposite components was studied by diffuse reflectance spectroscopy (DRS) and electrical conductivity meter. The results showed that band gap of TC-GQD nanocomposite was shifted to visible lights relative to its components (1.3 eV), and electrical conductivity of the sample was significant increased to 89.5 μS cm^-1. After chemical and physical characterization, prepared new nanocomposites were used to design a new electrochemical (EC) and photoelectrochemical (PEC) dopamine (DA) sensors. In both EC and PEC methods effecting experimental parameters were optimized. Due to the synergic effect of the nanocomposite components, an outstanding photocurrent response was observed for DA based on PEC sensor. A linear calibration curve with a lower detection limit of 22 nM DA, and sensitivity of 13.8 mA/mM_(DA), in a wider range of 0.3-750 μM DA, was obtained for TC-GQD/GCE electrode in PEC. While, the TC-GQD/GCE electrode detected DA in the range of 1-500 μM DA, with two linear calibration curve, detection limit of 0.22 μM DA, and sensitivity of 4.9 mA/mM_(DA), in the EC. Observed results from EC and PEC sensors are presented and compared.

Photoelectrochemical determination of ractopamine based on inner filter effect between gold nanoparticles and graphitic carbon nitride-copper(II) polyphthalocyanine coupled with 3D DNA stabilizer

Copper(II) polyphthalocyanine (CuPPc) was combined with graphitic carbon nitride (g-C₃N₄) to form a heterojunction with enhanced photoelectrochemical (PEC) signal. A sensitive PEC method was developed for determination of ractopamine based on a PEC inner filter effect between gold nanoparticles (AuNPs) and the g-C₃N₄/CuPPc. A gold electrode was modified with g-C₃N₄/CuPPc and the DNA was linked to the AuNPs. Initially, the PEC signal is weak due to the inner filter effect between the AuNPs and g-C₃N₄/CuPPc. In the presence of ractopamine, it interacts with the aptamer and the complementary chain (C chain) is released. This triggers the entropy-driven cyclic amplification and results in the release of the substrate B chain (SB chain) from three-dimensional DNA stabilizer. The probe is released from the electrode due to the interaction of probe DNA and the SB chain. As a result, the PEC signal increases linearly in the 0.1 pmol·L^-1 to 1000 pmol·L^-1 ractopamine concentration range. The detection limit is 0.03 pM, and the relative standard deviation is 3.4% (at a 10 pmol·L^-1 level; for n = 11). The method has been successfully applied to the determination of ractopamine in pork samples. Graphical abstract Schematic presentation of detection method based on PEC inner filter effect between AuNPs and the g-C₃N₄/CuPPc being fabricated for ractopamine. 3D DNA was used as stabilizer to decrease the PEC blank signal.

Tremella-like ZnIn2S4/graphene composite based photoelectrochemical sensor for sensitive detection of dopamine

Tremella-like ZnIn₂S₄ (ZISt) and flower-like microsphere ZnIn₂S₄ (ZISm) were synthesized via a straightforward hydrothermal method. It was found that the ZISt was superior to ZISm for photoelectrochemical (PEC) sensing because of its large surface area and high photocatalytic activity. A composite of ZISt and graphene (GR) was prepared and used for the PEC sensing of dopamine (DA). Here DA acted as an electron donor to scavenge the hole and inhibit the charge recombination. The GR enhanced visible light absorption and accelerated electron transfer, amplifying the photocurrent signal. The strong chelating coordination interaction between DA and Zn(II) in ZISt guaranteed the selective adsorption of target analyte. Thus the resulting ZISt/GR photoelectrode showed sensitive and selective PEC response to DA. Under the optimized conditions, the linear response range was from 0.01 to 20 μM, and the detection limit was down to 0.001 μM. Additionally, the sensor had good stability and reproducibility, and it could be used for the detection of DA in real samples.

The effect of varying solvents for MoS2 treatment on its catalytic efficiencies for HER and ORR

MoS₂ has been investigated intensively in the field of catalysis for the hydrogen evolution reaction (HER) in particular. Much effort has been made by various research teams worldwide to look into the specific catalyst design such as nano-structuring, defect engineering or hybrid structures. But what evades us is the fundamental preparation method for the dispersion of powdered MoS₂. Individual research teams with their best practices might be subjective and not validated by extensive experimental results. In this report, we find that the overpotential for the catalysis of HER varies from 0.57 to 0.72 V (freshly prepared) when different dispersion media are used, such as acetonitrile, N,N-dimethylformamide, ethanol, methanol and water. In terms of oxygen reduction reaction (ORR) catalysis, less significant differences were found. With both HER and ORR pertinent to the fuel cell industry, this report would serve as an insight to readers when comparing the results of MoS₂ catalysis across the literature from different research groups when different solvents were used as the dispersion medium.