Potentiometric determination of ascorbic acid in water–acetonitrile solution using pyrite and chalcopyrite electrodes

A Sensitive Electrochemical Ascorbic Acid Sensor Using Glassy Carbon Electrode Modified by Molybdenite with Electrodeposited Methylene Blue

A non-enzymatic amperometric sensor using natural molybdenite (MLN) electrodeposited with methylene blue (MB) has been fabricated and characterized and its analytical performances were investigated for the determination of ascorbic acid (AA). The surface morphology of the electrode modified by electrodeposited MB was studied by use of the Advanced Mineral Identification and Characterization System (AMICS) and laser confocal high-temperature scanning microscope (LCSM). The poly(MB) and MLN immobilized sensor showed good stability, reproducibility, sensitivity, and selectivity. It exhibited a linear performance range from 3 to 1000 μM, with a lower detection limit of 0.083 μM (signal/noise = 3) and short response time (< 5 s). No obvious decrease in the current was observed after 20 days storage. The methodology reproducibility of this sensor was 2.6%. It showed good anti-interference ability for the potential interfering compounds. The poly(MB) film not only can enhance the electron-transfer rate but also increase the lifetime of the sensor. This study demonstrated the applicability of natural molybdenite for the fabrication of non-enzymatic electrochemical AA sensor.

A miniaturized solid-contact potentiometric multisensor platform for determination of ionic profiles in human saliva

This paper describes a miniaturized multisensor platform (MP-ISES) consisting of electrodes: a reference one (RE) and ion-selective electrodes (ISEs) for monitoring Na+, K+, Ca2+, Mg2+, Cl−, and SCN− ions and pH in human saliva. Gold electrode surface was modified by deposition of two layers: electrosynthesized PEDOT:PSS forming an intermediate layer, and ion-selective membrane. The developed ISEs were characterized by a wide linear range and sensitivity consistent with the Nernst model. The entire MP-ISEs are characterized by satisfactory metrological parameters demonstrating their applicability in biomedical research, in particular in measurements concerning determination of ionic profiles of saliva. Saliva samples of 18 volunteers aged from 20 to 26 participating in a month experiment had been daily collected and investigated using the MP-ISEs assigned individually to each person. Personalized profiles of ions (ionograms) in saliva, such as Na+, K+, Ca2+, Mg2+, Cl−, SCN−, and H+, were obtained.

Application of pyrite and chalcopyrite as sensor electrode for amperometric detection and measurement of hydrogen peroxide

The sensing performance of solid-state amperometric sensors based on natural sulfide minerals, i.e., pyrite and chalcopyrite, has been characterized for the detection and measurement of hydrogen peroxide (H₂O₂) in aqueous medium.