Ni0.6-xMo0.4-xIrx-oxide as an electrode material for supercapacitors: investigation of the influence of iridium content on the charge storage/delivery

Multifunctionality Analysis of Structural Supercapacitors- A Review

Structural supercapacitors (SSCs) are multifunctional energy storage composites (MESCs) that combine the mechanical properties of fiber-reinforced polymers and the electrochemical performance of supercapacitors to reduce the overall mass in lightweight applications with electrical energy consumption. These novel MESCs have huge potentials, and their properties have improved dramatically since their introduction in the early 2000's. However, the current properties of SSCs are not sufficient for complete energy supply of electrically driven devices. To overcome this drawback, the aim of the current study is to identify key areas for enhancement of the multifunctional performance of SSCs. Critical modification paths for the SSC constituents are systematically analyzed. Special focus is given to the improvement of carbon fiber-based electrodes, the selection of structural electrolytes and the implementation of separators for the development of more efficient SSCs. Finally, current SSCs are compared in terms of their multifunctionality including material combinations and modifications.

In Situ Electroplating of Ir@Carbon Cloth as High-Performance Selective Oxygen Evolution Reaction Catalyst for Direct Electrolytic Recovery of Lead

The hydrometallurgical technology provides an efficient and sustainable green lead recovery process from lead acid batteries. Methanesulfonic acid has been widely considered as a green solvent for lead electrolytic recovery. However, the competitive precipitation of PbO2 at anode and higher overpotential for OER limit the lead recovery efficiency. In this work, an anodic oxygen evolution reaction (OER) catalyst with a low Ir mass fraction of 7.2% is obtained by electroplating iridium on carbon cloth (CC), exhibiting a lower overpotential of 256 mV, longer lifetime of 10 h, and better stability in the 0.5 M MSA solution. When CC-Ir is used as an anodic catalyst for lead recovery in the lead methanesulfonate electrolyte, only a lesser Pb precipitation product with Pb atom mass fraction of 1.42% is found after electrolysis of 10 h, demonstrating the suppression effect of CC-Ir for a PbO2 side reaction. This work proves that the anodic catalyst plays an important role in the lead electrolytic recovery process, which can inhibit the side reaction, reduce the energy consumption, and increase recovery efficiency.

Microbial fuel cell soft sensor for real-time toxicity detection and monitoring

Real-time toxicity detection and monitoring using a microbial fuel cell (MFC) is often based on observing current or voltage changes. Other methods of obtaining more information on the internal state of the MFC, such as electrochemical impedance spectroscopy (EIS), are invasive, disruptive, time consuming, and may affect long-term MFC performance. This study proposes a soft sensor approach as a non-invasive real-time method for evaluating the internal state of an MFC biosensor during toxicity monitoring. The proposed soft sensor approach is based on estimating the equivalent circuit model (ECM) parameters in real time. A flow-through MFC biosensor was operated at several combinations of carbon source (acetate) and toxicant (copper) concentrations. The ECM parameters, such as internal resistance, capacitance, and open-circuit voltage, were estimated in real time using a numerical parameter estimation procedure. The soft sensor approach proved to be an adequate replacement for EIS measurements in quantifying changes in the biosensor internal parameters. The approach also provided additional information, which could lead to earlier detection of the toxicity onset.