Development of a compact wearable pneumatic drive unit for a ventricular assist device

Biventricular support using a centrifugal pump in a 6 year old with fulminant myocarditis

We experienced a case of ventricular assist with both a pulsatile-flow and a continuous-flow pump in a pediatric patient, and herein report the clinical course and characteristics of the pumps. A 6-year-old female was diagnosed with fulminant myocarditis and transferred to our hospital for mechanical support. After 12 days of extracorporeal membrane oxygenation, we implanted a left ventricular assist device (LVAD) and a right ventricular assist device (RVAD) using centrifugal Gyro pumps with a membrane oxygenator in a paracorporeal fashion. The membrane oxygenator was removed on postoperative day (POD) 4, and the patient was weaned from the respirator on POD 6. The LVAD was exchanged on POD 13 and 17, and the RVAD was exchanged on POD 14 because of thrombus formation inside the pumps. The RVAD was removed on POD 25. On POD 32, the patient experienced cerebral infarction and the centrifugal Gyro pump was switched to an extracorporeal pulsatile pump. No thromboembolic event occurred after pump conversion, although continuous administration of vasodilators was required to avoid hypertension. She underwent successfully heart transplantation in the USA after 8 months of ventricular support. A centrifugal pump is considered useful for pediatric patients, as pump flow and blood pressure can be relatively easily controlled in the postoperative acute phase compared with the pulsatile pump. However, special care should be taken to monitor for thrombus formation when support length becomes longer than 13 days, and a switch to a pulsatile pump should be considered once the hemodynamic status stabilizes.

Development of a flow rate monitoring method for the wearable ventricular assist device driver

Our research institute has been working on the development of a compact wearable drive unit for an extracorporeal ventricular assist device (VAD) with a pneumatically driven pump. A method for checking the pump blood flow on the side of the drive unit without modifying the existing blood pump and impairing the portability of it will be useful. In this study, to calculate the pump flow rate indirectly from measuring the flow rate of the driving air of the VAD air chamber, we conducted experiments using a mock circuit to investigate the correlation between the air flow rate and the pump flow rate as well as its accuracy and error factors. The pump flow rate was measured using an ultrasonic flow meter at the inflow and outflow tube, and the air flow was measured using a thermal mass flow meter at the driveline. Similarity in the instantaneous waveform was confirmed between the air flow rate in the driveline and the pump flow rate. Some limitations of this technique were indicated by consideration of the error factors. A significant correlation was found between the average pump flow rate in the ejecting direction and the average air flow rate in the ejecting direction (R2 = 0.704-0.856), and the air flow rate in the filling direction (R2 = 0.947-0.971). It was demonstrated that the average pump flow rate was estimated exactly in a wide range of drive conditions using the air flow of the filling phase.