Morphologies and mechanical properties of cis-1,4-butadiene rubber/polyethylene blends

Study on the Effect of Zinc on the Rheological, Mechanical and Thermal Properties and Fire Hazard of Unfilled and Filled CR/BR Vulcanizates

This paper discusses the cross-linking and functional properties of elastomer composites containing chloroprene rubber (CR) and butadiene rubber (BR) cured in the presence of zinc (Zn) and reinforced with mineral fillers. The research aimed to evaluate the effectiveness of zinc as a new cross-linking substance with the simultaneous production of elastomer materials with good mechanical properties and a reduced fire hazard. The article concerns the study and explanation of the dependencies influencing the processing and functional properties of unfilled or filled elastomer blends containing different elastomers ratio or different zinc’s amount. The following fillers were used: silica, kaolin, chalk and montmorillonite. The results revealed that the cross-linking degree of CR/BR blends decreased with the increasing amount of butadiene rubber in the blends. The mechanical properties of the cured blends depended on the proportion of elastomers in the composites, the zinc amount, and the presence and type of filler. The flammability of CR/BR/Zn vulcanizates has been investigated before and after the filling. The parameters assessed by the oxygen index method and cone calorimetry, characterizing the behavior of the tested CR/BR/Zn vulcanizates under fire conditions, have shown that they constitute a low fire hazard and can be considered as non-flammable materials.

Effects of Composition and Melting Time on the Phase Separation of Poly(3-hydroxybutyrate)/Poly(propylene carbonate) Blend Thin Films

In this study, the effect of composition and melting time on the phase separation of poly(3-hydroxybutyrate)/poly(propylene carbonate) (PHB/PPC) blend thin films was investigated. Optical microscopy under phase contrast confirms the occurrence of phase separation of PHB/PPC blends at 190 °C. Polarized optical and scanning electron microscopies (POM and SEM) demonstrate that phase separation takes place along both horizontal and vertical film planes, which should be attributed to the two different interfaces and immiscible blends. A low PPC content (e.g. 30 wt %) results in the formation of compact PHB spherulites filling the whole space, whereas the noncrystallizable PPC spherical microdomains scatter in the PHB region, and their size shows a remarkable melting-time dependence. With the increasing PPC component and melting time, it is observed from POM that the separated PHB domains scattered in the continuous PPC phase, like the island structure. However, it can be revealed by SEM micrographs that the PHB thick domains are actually connected by its thin layer under the PPC layer. The real situation is, therefore, a large amount of PPC aggregates to the surface to form a network uplayer, whereas the PHB thick domains connected by its thin layer form a continuous PHB region, leading to a superimposed bilayer structure. There is also a small amount of PHB small domains scattered in the PHB phase. The PHB thick domains crystallize cooperatively with the PHB- or PHB-rich sublayer in a way just like the growth of pure PHB spherulites. This superimposed bilayer by interplay between phase separation and crystallization may provide availability to tailor the final structure and properties of crystalline/amorphous polymer blends.