A universal blown film apparatus for in situ X-ray measurements

Manipulation of Chain Entanglement and Crystal Networks of Biodegradable Poly(butylene adipate-co-butylene terephthalate) During Film Blowing through the Addition of a Chain Extender: An In Situ Synchrotron Radiation X-ray Scattering Study

One prerequisite for the large-scale application of biodegradable polymers is the manipulation of macroscopic performances of commercially available biopolymers during processing according to different real service requirements. Herein, the microstructural evolution of poly(butylene adipate-co-butylene terephthalate) (PBAT) modified by chain extender during film blowing was investigated by in situ synchrotron radiation X-ray scattering to unveil the origin of different performances. The chain dynamics difference induced by the chain extender was first characterized by the rheological measurement and ¹H Multiple Quantum (MQ) NMR. It shows that the terminal relaxation is significantly slowed down, while the locally segmental dynamics is not apparently changed. With the assistance of the custom-built film blowing apparatus, the microstructure right above the die exit (D = 13-165 mm) was in situ, simultaneously captured by small- and wide-angle scattering (SAXS/WAXS), where four distinct regimes can be defined. Only the PBAT melt signals are found in regime I, whereas the formation of the mesomorphic domains as shown by the SAXS streaks appearing in regime II. The crystal shows up in regime III, where the WAXS signal appears. A dramatic increment of the crystallinity is found in regime III, which contributes to the continuous increasing bubble modulus with the formation of the crystal-based network. Such a crystal-based network is filled with crystals in regime IV, where the diameter of the PBAT bubble remains constant. The addition of the chain extender is found to significantly influence the structural evolution within different regimes. These dynamics and structure information could supply general guidance for bubble stability improvement and modification of macroscopic performances of biodegradable polymer products.

Preparation of Polyethylene and Ethylene/Methacrylic Acid Copolymer Blend Films with Tunable Surface Properties through Manipulating Processing Parameters during Film Blowing

Polymer films based on polyethylene (PE) and ionomer ethylene/methacrylic acid (EMAA) copolymer blend were prepared by film blowing, whose surface properties were tuned by varying processing parameters, i.e., take up ratio (TUR). Blends of PE/EMAA copolymer were firstly prepared by the melt-mixing method, before being further blown to films. The wettability of the film was investigated by measuring the contact angle/water-film encounter time, and optical properties, i.e., the haze and transmittance. The wettability was found to be enhanced with the increase of TUR. So too was the haze, while the transmittance was found to be almost independent of TUR. The XPS and AFM results directly show the increasing polar functional groups (-COO^-) on the surface and roughness with increasing TUR. Further analysis of the 2D SAXS and WAXS unveiled the origin of the invariant transmittance, which resulted from the minor change of the crystallinity and the monotonic increase of the haze, with TUR resulting from the evolution of crystal orientation. In addition to other post-modification methods, the current study provides an alternative route to prepare large-scale PE films as the template for the advanced potential applications, i.e., covering in the layer of roof, the privacy of protective windows, and multitudes of packaging.

Structural evolution and phase transition of uniaxially stretched poly(butylene adipate-co-butylene terephthalate) films as revealed by in situ synchrotron radiation small and wide angle X-ray scattering

Structural evolution and phase transition of poly(butylene adipate-co-butylene terephthalate) during uniaxial stretching.