Enhancement of Resistance to Protein Fouling of Poly(ether imide) Membrane by Surface Grafting with PEG under Organic Solvent-free Condition

Preparation of Ultrafiltration Membrane by Polyethylene Glycol Non-Covalent Functionalized Multi-Walled Carbon Nanotubes: Application for HA Removal and Fouling Control

Polyethylene glycol (PEG) non-covalent-functionalized multi-walled carbon nanotubes (MWCNT) membrane were prepared by vacuum filtration. The dispersion and stability of MWCNT non-covalent functionalized with PEG were all improved. TEM characterization and XPS quantitative analysis proved that the use of PEG to non-covalent functionalize MWCNT was successful. SEM image analysis confirmed that the pore size of PEG–MWCNT membrane was more concentrated and distributed in a narrower range of diameter. Contact angle measurement demonstrated that PEG non-covalent functionalization greatly enhanced the hydrophilicity of MWCNT membranes. The results of pure water flux showed that the PEG–MWCNT membranes could be categorized into low pressure membrane. PEG-MWCNT membrane had a better effect on the removal of humic acid (HA) and a lower TMP growth rate compared with a commercial 0.01-μm PVDF ultrafiltration membrane. During the filtration of bovine serum albumin (BSA), the antifouling ability of PEG-MWCNT membranes were obviously better than the raw MWCNT membranes. The TMP recovery rate of PEG–MWCNT membrane after cross flushing was 79.4%, while that of raw MWCNT–_COOH and MWCNT membrane were only 14.9% and 28.3%, respectively. PEG non-covalent functionalization improved the antifouling ability of the raw MWCNT membranes and reduced the irreversible fouling, which effectively prolonged the service life of MWCNT membrane.

Preparation and Performance of Silica-di-Block Polymer Hybrids for BSA-Resistance Coatings

A series of tem-responsive and protein-resistance property silica-di-block polymers SiO₂-g-PMMA-b-P(PEGMA) hybrids are synthesized with methyl methacrylate (MMA) and poly (ethylene glycol) methyl ether methacrylate (PEGMA) by the surface-initiated atom transfer radical polymerization (SI-ATRP). The morphology in tetrahydrofuran (THF) solution, lower critical solution temperature (LCST), surface morphology, bovine serum albumin (BSA)-resistance property, and thermal stability of nanoparticles were analyzed. The results of ¹H-NMR, GPC, and TEM prove that the silica-di-block hybrids have been obtained. The silica-di-block hybrids shows the LCST (52–64 °C) in aqueous solution. The hybrid films casted by THF present distributed uniform granular bulges and the film surface is relatively smooth (Ra = 15.4 nm ~ 10.5 nm). The results of QCM-D showed that only a small amount of BSA protein(△f = 18.6 ~ 11.8 Hz) was adsorbed on the surface of the films. The result of XPS also demonstrated that only a small amount of BSA protein was absorbed onto the surface of the film (N% = 1.86). The TGA analyses indicate that the thermal decomposition temperature of hybrids is 288 °C. Thus, it is suggested that the hybrids are served as a suitable coating with BSA resistance property and thermal stability.