The feasibility of transpedicular screw fixation of the subaxial cervical spine in the Arab population: a computed tomography-based morphometric study

The Feasibility of Condylar Screws for Occipitocervical Fusion in Arabs: Computed Tomography-Based Morphometric Study

STUDY DESIGN

Retrospective, cross-sectional study.

OBJECTIVES

Occipitocervical fusion is indicated for various conditions. Some techniques require placement of screws in the occipital condyle. The objective of this study was to analyze the morphometric features of the occipital condyle among Arabs.

METHODS

Computed tomography (CT)-based morphometric analysis of occipital condyles of 200 Arab skeletally mature patients (400 condyles) was done. Axial width of at least 8 mm and coronal height of at least 6.5 mm are the cutoff values for feasibility of condylar screw placement.

RESULTS

The mean age of the patients was 48.0 ± 18.3 years. Males were 53.5% (107) of the sample. The mean axial condylar width and length were 8.5 ± 1.5 mm and 20.3 ± 2.6 mm, respectively, while the mean axial screw angle was 35.9° ± 5.5° from midline. The mean sagittal condylar length and height were 16.1 ± 1.9 mm and 8.8 ± 1.5 mm, respectively. The mean condylar coronal height was 8.2 ± 1.4 mm. Based on axial width and coronal height measurements, 150 (37.5%) condyles could safely fit a 3.5 mm condylar screw. One hundred and four (55.9% female condyles) condyles cannot fit a screw in females, while 46 (21.5% male condyles) condyles cannot fit a screw in males.

CONCLUSIONS

Condylar screw for occipitocervical fusion is feasible for the majority of Arabs in our sample; however, this applies to slightly less than half of the female condyles. Detailed preoperative radiological planning is critical to avoid complications related to occipital condyle screw placement.

CT Anatomical Analysis of C4 Pedicle and Lateral Mass in Children Aged 0-14 in Southern China

OBJECTIVE

The C4 is the transition point between the upper and lower cervical vertebrae and plays a pivotal role in the middle of the cervical spine. Currently, there are limited reports on large-scale sample studies regarding C4 anatomy in children, and a scarcity of experience exists in pediatric cervical spine surgery. The current study addresses the dearth of anatomical measurements of the C4 vertebral arch and lateral mass in a substantial sample of children. This study aims to measure the imaging anatomy of the C4 vertebral arch and lateral mass in children under 14 years of age across various age groups, investigate the growth and development of these structures.

METHODS

We measured 12 indicators, including the size (D1, D2, D3, D4, D5, D6, D7, and D8) and angle (A, C, D, and E) of the C4 vertebral arch and lateral mass, in 513 children who underwent cervical CT examinations at our hospital. We employed the aggregate function for statistical analysis, conducted t-tests for difference statistics, and utilized the least squares method for regression analysis.

RESULTS

Overall, as age increased, there was a gradual increase in the size of the vertebral arch and lateral mass. Additionally, the medial inclination angle of the vertebral arch decreased, and the lateral mass flattened gradually. The rate of change decreased gradually with age. The mean value of D1 increased from 2.31 mm to 3.88 mm, of D2 from 16.75 mm to 29.2 mm, of D3 from 2.21 mm to 4.92 mm, and of D4 from 7.34 mm to 11.84 mm. Meanwhile, the mean value of D5 increased from 5.2 mm to 9.71 mm, of D6 from 10.19 mm to 16.16 mm, of D7 from 2.53 mm to 5.67 mm, and of D8 from 6.11 mm to 11.45 mm. Angle A ranged from 49.12° to 54.97°, angle C from 15.28° to 19.83°, angle D from 39.91° to 53.7°, and angle E from 18.63° to 28.08°.

CONCLUSION

Prior to cervical spine surgery in children, meticulous CT imaging anatomical measurements is essential. The imaging data serves as a reference for posterior C4 internal fixation, aids in designing posterior cervical screws for pediatric patients, and offer morphological anatomical references for posterior cervical spine surgery and screw design in pediatric patients.

Pedicle Morphometry of Subaxial Cervical Spine Using Computed Tomography Scans among Adult Ugandan Subpopulation

Background

Accurate placement of pedicle screws in the subaxial cervical spine requires precise understanding of vertebra anatomy. Little is known about the morphometric characteristics of the subaxial cervical pedicle in the Ugandan population. The objective of the study was to determine the morphometric dimensions of pedicles in the subaxial cervical spine among the adult Ugandan population.

Methods

We conducted a cross-sectional study from March to November 2019 among adult Ugandans with a normal cervical CT scan at Nsambya hospital in Kampala. Eligible participants were consecutively recruited into the study. Data on baseline characteristics and pedicle dimensions from the CT scan finding was collected using a structured questionnaire. Data was analysed using Stata 13.0. Pedicle dimensions for the different levels of subaxial cervical vertebrae were summarised as means and standard deviations, the Mann–Whitney test was used to compare pedicle dimensions for the different vertebra levels among females and males on both right and left sides, and the level of significance was set at 0.05.

Results

A total of 700 subaxial cervical pedicles (C3-C7) from 49 males and 21 female participants were studied. Pedicle width diameter showed cephalocaudal gradual increment from C3 1.65(0.63) mm to 3.46(0.75) mm at C7. Pedicle height also showed an increase caudally with smallest diameter at C3 (1.98(0.76) mm) and largest at C5 in females (3.67(6.42) mm) and at C7 in males (3.83(0.76) mm). The pedicle height was wider than the pedicle width at all levels. The pedicle chord length gradually increased caudally in both sexes ranging from 29.08(1.35) mm at C3 to 32.53(3.19) mm at C7. The axial angles were oriented medially and showed no consistent trend ranging between 50° and 53°. The sagittal angles decreased as one moved from C3 to C7. The dimensions of females were significantly smaller than in males.

Conclusion

Pedicle endosteal width was smaller than pedicle height dimensions at all levels. Pedicle cord length increased caudally. The pedicle dimensions, except angulations, were smaller in females than in males.

Morphometric Analysis of Subaxial Cervical Spine Pedicles in a Middle Eastern Population

BACKGROUND

Pedicle screw instrumentation of the posterior cervical spine is the most secure form of fixation available to surgeons. It has not achieved widespread use yet in the Middle East, mostly due to concerns regarding its feasibility in the target population. A detailed morphometric analysis of the lower cervical spine pedicles using computerized tomography (CT) was proposed to address this issue.

METHODS

Two hundred and seventy patients were enrolled in the study. CT scans were reviewed by two experienced assessors, and measurements of pedicle width (PW), height (PH), and transverse angle (TA) were recorded for all patients. Interobserver and intraobserver reliability were calculated using the kappa statistic. Sex differences were also recorded and analyzed. The t test was used to assess for any significant differences in measurements due to sex (P < .05).

RESULTS

The mean PW varied from 4.4 mm in C3 to 6.1 mm in C7. The mean PH was 6.4 mm in C3 and 6.8 mm in C7. Pedicle TA varied from 42 to 51 degrees between the different levels. Sex differences were observed and were statistically significant for PW and PH. Interobserver reliability was high for PW and PH, but was low for TA. Intraobserver reliability was 0.99 for both assessors.

CONCLUSION

This study provides reliable PW and PH measurements and demonstrates that cervical pedicle screw instrumentation is feasible in our local population. Significant variability exists, however, and each patient must be addressed individually for best results.

LEVEL OF EVIDENCE

3.

CLINICAL RELEVANCE

This study shows that the morphology of the subaxial cervical pedicle permits instrumentation in a majority of cases of our target population.

Design and application of subaxial cervical pedicle screw placement guide device

In the present study, a novel subaxial cervical pedicle screw placement guide device was designed and developed. In cervical specimens (C3-C7), a pedicle screw was inserted into the left pedicle using the guide device with a keyhole partial laminectomy and tapping technique, and the right pedicle by drilling using the Abumi technique. After removing the pedicle screws, the channel wall of each pedicle screw was probed with a pedicle probe. The vertebral body was then dissociated for direct observation of the screw channel. Among the 10 specimens, 2 of the 50 pedicles (4%) in the guide device group were perforated. Screw placement failed in 8 of 50 pedicles (16%) in the Abumi technique group. Significant differences were observed in the outcomes for the guide device and Abumi technique groups. The subaxial cervical pedicle screw placement guide device developed in the present study decreased the failure rate of pedicle screw placement.

Computerized Tomography-Based Morphometric Analysis of Subaxial Cervical Spine Pedicle in Asymptomatic Indian Population

Background

The purpose of this study was to analyze morphometry of the subaxial cervical spine pedicles in an Indian population based on computed tomography (CT), and thus assess the safety and feasibility of cervical pedicle screw in the subaxial cervical spine.

Methods

CT scans of 500 subaxial cervical spine vertebrae were analyzed from 100 patients presenting to our institution and undergoing cervical spine CT scan for an unrelated cause as part of ATLS protocol. Pedicle width (PW), pedicle axis length (PAL), pedicle transverse angulation (PTA), and lateral pedicle distance (LPD) were calculated on axial CT scans, and pedicle height (PH), pedicle length (PL), superior pedicle distance (SPD), and pedicle sagittal angulation (PSA) were calculated on sagittal CT scans.

Results

The mean PW ranged from 4.3 mm at C3 to 5.7 mm at C7. Mean PH ranged from 5.5 mm at C3 to 6.1 mm at C7. Mean PTA ranged from 44.5° at C3 to 37.1° at C7. PSA ranged from 16.65° at C3 to 3.29° at C7. Mean LPD ranged from 1.6 mm at C3 to 3.4 mm at C6. Mean SPD ranged from 3.5 mm at C3 to 1.15 mm at C7. Mean PAL ranged from 29.6 mm at C3 to 33.04 mm at C7. Mean PL ranged from 5.2 mm at C3 to 5.78 mm at C7.

Conclusions

Our CT-based morphometric study confirms that cervical pedicle screw placement is possible in most of the Indian population except at C3 in females. A thorough understanding of pedicle anatomy with proper CT-based preoperative planning can mitigate the risk associated with pedicle screw placement in subaxial cervical spine.