Fate of three bioluminescent pathogenic bacteria fed through a cascade of urine microbial fuel cells

Assessment of microbial population in integrated CW-MFC system and investigation of organics and fecal coliform removal pathway

The current study is focused on understanding the operational mechanism of an integrated constructed wetland-microbial fuel cell (CW-MFC) reactor emphasizing fecal coliform (FC) removal. Few studies are available in the literature investigating the inherent mechanisms of pathogen inactivation in a CW-MFC system. Raw domestic wastewater was treated in three vertical reactors, one planted constructed wetland (R1), one planted CW-MFC (R2), and one unplanted CW-MFC (R3). Spatial analysis of treated effluents showed a considerable amount of organics and fecal coliform removal at the vicinity of the anode in R2. Assessment of the microbial population inside all the reactors revealed that EABs (Firmicutes, Bacteroidetes, and Actinobacteria) were more abundant in R2 compared to R1 and R3. During the activity study, biomass obtained from R2 showed a maximum substrate utilization rate of 1.27 mg COD mgVSS-1 d-1. Kinetic batch studies were carried out for FC removal in all the reactors, and the maximum first order FC removal rate was obtained at the anode of R2 as 2.13 d-1 when operated in closed circuit mode. This value was much higher than the natural die-off rate of FCs in raw wastewater which was 1.16 d-1. Simultaneous bioelectricity monitoring inferred that voltage generation can be correlated to faster FC inactivation, which was probably due to EABs outcompeting other exogenous microbes in a preferable anaerobic environment with the presence of an anode. Reactor R2 was found to be functioning as a symbiotic bio-electrochemical mesocosm.

Bioelectricity generation from human urine and simultaneous nutrient recovery: Role of Microbial Fuel Cells

Urine is a 'valuable waste' that can be exploited to generate bioelectricity and recover key nutrients for producing NPK-rich biofertilizers. In recent times, improved and innovative waste management technologies have emerged to manage the rapidly increasing environmental pollution and to accomplish the goal of sustainable development. Microbial fuel cells (MFCs) have attracted the attention of environmentalists worldwide to treat human urine and produce power through bioelectrochemical reactions in presence of electroactive bacteria growing on the anode. The bacteria break down the complex organic matter present in urine into simpler compounds and release the electrons which flow through an external circuit generating current at the cathode. Many other useful products are harvested at the end of the process. So, in this review, an attempt has been made to synthesize the information on MFCs fuelled with urine to generate bioelectricity and recover value-added resources (nutrients), and their modifications to enhance productivity. Moreover, configuration and mode of system operation, and factors enhancing the performance of MFCs have been also presented.

Microbial fuel cells and their electrified biofilms

Bioelectrochemical systems (BES) represent a wide range of different biofilm-based bioreactors that includes microbial fuel cells (MFCs), microbial electrolysis cells (MECs) and microbial desalination cells (MDCs). The first described bioelectrical bioreactor is the Microbial Fuel Cell and with the exception of MDCs, it is the only type of BES that actually produces harvestable amounts of electricity, rather than requiring an electrical input to function. For these reasons, this review article, with previously unpublished supporting data, focusses primarily on MFCs. Of relevance is the architecture of these bioreactors, the type of membrane they employ (if any) for separating the chambers along with the size, as well as the geometry and material composition of the electrodes which support biofilms. Finally, the structure, properties and growth rate of the microbial biofilms colonising anodic electrodes, are of critical importance for rendering these devices, functional living 'engines' for a wide range of applications.

A review on disinfection technologies for controlling the antibiotic resistance spread

The occurrence of antibiotic-resistant bacteria (ARB) in water bodies poses a sanitary and environmental risk. These ARB and other mobile genetic elements can be easily spread from hospital facilities, the point in which, for sure, they are more concentrated. For this reason, novel clean and efficient technologies are being developed for allowing to remove these ARB and other mobile genetic elements before their uncontrolled spread. In this paper, a review on the recent knowledge about the state of the art of the main disinfection technologies to control the antibiotic resistance spread from natural water, wastewater, and hospital wastewater (including urine matrices) is reported. These technologies involve not only conventional processes, but also the recent advances on advanced oxidation processes (AOPs), including electrochemical advanced oxidation processes (EAOPs). This review summarizes the state of the art on the applicability of these technologies and also focuses on the description of the disinfection mechanisms by each technology, highlighting the promising impact of EAOPs on the remediation of this important environmental and health problem.

Bioelectrochemical Greywater Treatment for Non-Potable Reuse and Energy Recovery

Greywater normally represents the largest fraction of wastewater generated in buildings and may be suitable for non-potable reuse after on-site treatment. Conventional technologies for greywater treatment include sequencing batch reactors, membrane filtration, and membrane biological reactors. Even though these can be very effective, they are highly energy consuming and may negatively impact the energy balance of the building where they are installed. Microbial fuel cells (MFCs) have emerged as a sustainable technology for contaminant removal and energy production from a variety of substrates. In this study, the application of MFCs for greywater treatment is reported, with a particular focus on the analysis of energy losses, in view of non-potable reuse. MFCs were fed with different types of greywater, characterized by either high or low conductivity, because greywater’s conductivity may greatly differ based on its origin; in either case, organic matter (chemical oxygen demand; COD) removal was higher than 85% and not influenced by the influent conductivity, coupled with a maximum power production of 0.46 mW L−1 and 0.38 mW L−1. Electrolyte overpotentials were dramatically higher in the case of low conductivity greywater (20% vs. 10%, compared to high conductivity influent); these overpotentials are related to the conductivity of the influent, showing that low conductivity hindered energy generation, but not COD removal. Polarization and power curves showed higher internal resistance in the case of low conductivity, confirming the overpotentials’ analysis. Results showed the feasibility of the use of MFCs in greywater treatment, with potential to reduce the energy demand connected to its reuse compared to conventional technologies; coupling with a disinfection stage would be necessary to fully comply with most non-potable reuse regulations.

Urine in Bioelectrochemical Systems: An Overall Review

In recent years, human urine has been successfully used as an electrolyte and organic substrate in bioelectrochemical systems (BESs) mainly due of its unique properties. Urine contains organic compounds that can be utilised as a fuel for energy recovery in microbial fuel cells (MFCs) and it has high nutrient concentrations including nitrogen and phosphorous that can be concentrated and recovered in microbial electrosynthesis cells and microbial concentration cells. Moreover, human urine has high solution conductivity, which reduces the ohmic losses of these systems, improving BES output. This review describes the most recent advances in BESs utilising urine. Properties of neat human urine used in state-of-the-art MFCs are described from basic to pilot-scale and real implementation. Utilisation of urine in other bioelectrochemical systems for nutrient recovery is also discussed including proofs of concept to scale up systems.

Development of efficient electroactive biofilm in urine-fed microbial fuel cell cascades for bioelectricity generation

The Microbial fuel cell (MFC) technology harnesses the potential of some naturally occurring bacteria for electricity generation. Digested sludge is commonly used as the inoculum to initiate the process. There are, however, health hazards and practical issues associated with the use of digested sludge depending on its origin as well as the location for system deployment. This work reports the development of an efficient electroactive bacterial community within ceramic-based MFCs fed with human urine in the absence of sludge inoculum. The results show the development of a uniform bacterial community with power output levels equal to or higher than those generated from MFCs inoculated with sludge. In this case, the power generation begins within 2 days of the experimental set-up, compared to about 5 days in some sludge-inoculated MFCs, thus significantly reducing the start-up time. The metagenomics analysis of the successfully formed electroactive biofilm (EAB) shows significant shifts between the microbial ecology of the feeding material (fresh urine) and the developed anodic biofilm. A total of 21 bacteria genera were detected in the urine feedstock whilst up to 35 different genera were recorded in the developed biofilm. Members of Pseudomonas (18%) and Anaerolineaceae (17%) dominate the bacterial community of the fresh urine feed while members of Burkholderiaceae (up to 50%) and Tissierella (up to 29%) dominate the anodic EAB. These results highlight a significant shift in the bacterial community of the feedstock towards a selection and adaptation required for the various electrochemical reactions essential for survival through power generation.

Resilience and limitations of MFC anodic community when exposed to antibacterial agents

•

MFC cascade can withstand and degrade high concentrations of ampicillin.

•

Chloroxylenol caused loss of power and microbial community within MFC cascade.

•

MFC anodic biofilm responds differentially to different inhibitory chemical agents.

•

MFC cascade has the potential for bioremediation of certain chemical agents.

This study evaluates the fate of certain bactericidal agents introduced into microbial fuel cell (MFC) cascades and the response of the microbial community. We tested the response of functioning urine fed MFC cascades using two very different bactericidal agents: a common antibiotic (Ampicillin, 5 g/L) and a disinfectant (Chloroxylenol 4.8 g/L) in concentrations of up to 100 times higher than the usual dose. Results of power generation showed that the established bacteria community was able to withstand high concentrations of ampicillin with good recovery after 24 h of minor decline. However, power generation was adversely affected by the introduction of chloroxylenol, resulting in a 99% loss of power generation. Ampicillin was completely degraded within the MFC cascade (>99.99%), while chloroxylenol remained largely unaffected. Analysis of the microbial community before the addition of the bactericidal agents showed a significant bacterial diversity with at least 35 genera detected within the cascade. Microbial community analysis after ampicillin treatment showed the loss of a small number of bacterial communities and proportional fluctuations of specific strains within the individual MFCs community. On the other hand, there was a significant shift in the bacterial community after chloroxylenol treatment coupled with the loss of at least 13 bacterial genera across the cascade.

Removal of Hepatitis B virus surface HBsAg and core HBcAg antigens using microbial fuel cells producing electricity from human urine

Microbial electrochemical technology is emerging as an alternative way of treating waste and converting this directly to electricity. Intensive research on these systems is ongoing but it currently lacks the evaluation of possible environmental transmission of enteric viruses originating from the waste stream. In this study, for the first time we investigated this aspect by assessing the removal efficiency of hepatitis B core and surface antigens in cascades of continuous flow microbial fuel cells. The log-reduction (LR) of surface antigen (HBsAg) reached a maximum value of 1.86 ± 0.20 (98.6% reduction), which was similar to the open circuit control and degraded regardless of the recorded current. Core antigen (HBcAg) was much more resistant to treatment and the maximal LR was equal to 0.229 ± 0.028 (41.0% reduction). The highest LR rate observed for HBsAg was 4.66 ± 0.19 h⁻¹ and for HBcAg 0.10 ± 0.01 h⁻¹. Regression analysis revealed correlation between hydraulic retention time, power and redox potential on inactivation efficiency, also indicating electroactive behaviour of biofilm in open circuit control through the snorkel-effect. The results indicate that microbial electrochemical technologies may be successfully applied to reduce the risk of environmental transmission of hepatitis B virus but also open up the possibility of testing other viruses for wider implementation.