Highly Sensitive Determination of Butyl Xanthate in Surface and Drinking Water by Headspace Gas Chromatography with Electron Capture Detector

Mining flotation reagents: Quantitative and robust analysis of metal-xanthate complexes in water

Xanthates, common mining flotation reagents, strongly bind thiophilic metals such as copper (Cu), lead (Pb), cadmium (Cd), and zinc (Zn) and consequentially change their bioavailability and mobility upon their discharge into the environment. However, accurate quantification of the metal-xanthate complexes has remained elusive. This study develops a novel and robust method that realizes the accurate quantification of the metal-xanthate complexes resulted from single and multiple reactions of three typical xanthates (ethyl, isopropyl, and butyl xanthates) and four thiophilic metals (Cu, Pb, Cd, and Zn) in water samples. This method uses sulfur (S2-) dissociation, followed by tandem solid phase extraction of C18 + PWAX and subsequent LC-MS/MS analysis. It has a wide linearity range (1-1000 μg/L, R2 ≥ 0.995), low method detection limits (0.002-0.036 μg/L), and good recoveries (70.6-107.0 %) at 0.01-10 mg/L of xanthates. Applications of this method showed ubiquitous occurrence of the metal-xanthate complexes as the primary species in flotation wastewaters, which the concentrations were 4.6-28.9-fold higher than those previously determined. It is the first quantitative method established for the analysis of metal-xanthate complexes in water samples, which is of great importance to comprehensively understand the fate and risks of xanthates in the environment.

Dynamics of vanadium and response of inherent bacterial communities in vanadium-titanium magnetite tailings to beneficiation agents, temperature, and illumination

Vanadium-titanium (V-Ti) magnetite tailings contain toxic metals that could potentially pollute the surrounding environment. However, the impact of beneficiation agents, an integral part of mining activities, on the dynamics of V and the microbial community composition in tailings remains unclear. To fill this knowledge gap, we compared the physicochemical properties and microbial community structure of V-Ti magnetite tailings under different environmental conditions, including illumination, temperature, and residual beneficiation agents (salicylhydroxamic acid, sodium isobutyl xanthate, and benzyl arsonic acid) during a 28-day reaction. The results revealed that beneficiation agents exacerbated the acidification of the tailings and the release of V, among which benzyl arsonic acid had the greatest impact. The concentration of soluble V in the leachate of tailings with benzyl arsonic acid was 6.4 times higher than that with deionized water. Moreover, illumination, high temperatures, and beneficiation agents contributed to the reduction of V in V-containing tailings. High-throughput sequencing revealed that Thiobacillus and Limnohabitans adapted to the tailings environment. Proteobacteria was the most diverse phylum, and the relative abundance was 85.0%-99.1%. Desulfovibrio, Thiobacillus, and Limnohabitans survived in the V-Ti magnetite tailings with residual beneficiation agents. These microorganisms could contribute to the development of bioremediation technologies. The main factors affecting the diversity and composition of bacteria in the tailings were Fe, Mn, V, SO₄^2-, total nitrogen, and pH of the tailings. Illumination inhibited microbial community abundance, while the high temperature (39.5 °C) stimulated microbial community abundance. Overall, this study strengthens the understanding of the geochemical cycling of V in tailings influenced by residual beneficiation agents and the application of inherent microbial techniques in the remediation of tailing-affected environments.

A novel method based on solid phase extraction and liquid chromatography-tandem mass spectrometry warrants occurrence of trace xanthates in water

Huge volumes of wastewater containing organic flotation reagents such as xanthates have been released into the environment via mining activities, greatly threatening the eco-environment safety. A simple and fast method is urgently needed for accurate analysis of various xanthates in mining and environmental water. Here, a robust method is realized for simultaneous determination of three trace xanthates (i.e., potassium ethyl xanthate, potassium butyl xanthate, and potassium isopropyl xanthate) in environmental water samples, including eutrophic water and flotation wastewater using solid phase extraction (SPE) and HPLC-MS/MS. HPLC-MS/MS parameters, SPE cartridges and eluting solvents, pH values, and SPE procedures were optimized. The new method had an excellent linearity in the range of 1-1000 μg/L (R² ≥ 0.998), low limits of detection (0.02-0.68 μg/L), and satisfactory accuracy and precision (72.9%-107.6% of average recoveries and <5% of relative standard deviations at 1, 10, 50, and 500 μg/L of xanthates). This is a first method developed for determination of trace xanthates in water samples. It was successfully applied to determine the target analytes in outdated flotation wastewater and river water samples, warranting the occurrence of trace xanthates (0.13-16.9 μg/L) in water and necessity of systematic investigation on environmental fate and risk of xanthates.

The effect of experimental conditions on the formation of dixanthogen by triiodide oxidation in the determination of ethyl xanthate by HPLC-ICP-MS/MS

The rising concern over the environmental impact of xanthates, especially in the arctic region, has increased the need to study these traditional flotation reagents in greater detail. The environmental concern relates mostly to the formation of carbon disulfide (CS₂) and the heavy metal complexes of xanthates. Due to the unstable nature and multiple reaction mechanisms of xanthates, their reliable determination at low concentration levels is difficult. In this study, a xanthate pretreatment method was optimized and applied for the determination of ethyl xanthate (EX⁻) by high performance liquid chromatography–inductively coupled plasma tandem mass spectrometry (HPLC–ICP-MS/MS). Ethyl xanthate was oxidized to diethyl dixanthogen ((EX)₂) by triiodide (I₃⁻) in aqueous solution and the formed (EX)₂ was extracted into n-hexane. Important experimental parameters, including pH, I₃⁻ amount, and oxidation time, were optimized and the detection limit of 0.29 mg L⁻¹ for potassium ethyl xanthate was obtained. During the optimization experiments, it was found that the oxidation reaction resulted in multiple products, decreasing the efficiency of (EX)₂ formation and, therefore, the sensitivity of the method. The proposed method was applied to wastewater samples with recoveries of 105–106%. This study provides a selective method for the determination of ethyl xanthate and introduces novel information on the parameters affecting the oxidation of xanthates.

Microbial community structures and their driving factors in a typical gathering area of antimony mining and smelting in South China

This study investigated soil microbial community in a typical gathering area of antimony mining and smelting in South China. The physical and chemical properties of different soils (mining waste dumps, flotation tailings, and smelting slag) and depths (0-20 cm, 40-60 cm, and 80-100 cm) were compared. The results showed that antimony (Sb) and arsenic (As) were the main pollutants, and their concentrations were 5524.7 mg/kg and 3433.7 mg/kg, respectively. Xanthates were found in the flotation tailings and smelting slag, and the highest concentration was 585.1 mg/kg. The microbial communities were analyzed by high-throughput sequencing, and it was shown that Proteobacteria, Acidobacteria, Chlorobacterium, Bacteroides, and Actinomycetes were the dominant taxa at the phylum level. There were obvious differences in microbial community structure in different sites. The dominant microorganism in the mining site was Chujaibacter. Subgroup_2_unclassified and Gemmatimonadaceae_unclassified were the prevalent microorganisms in the flotation and smelting sites, respectively. As, Sb, and xanthates were the main factors affecting the diversity and composition of bacteria in the flotation tailings and smelting slag areas. Therefore, this study provides experimental guidance and a theoretical basis for soil antimony pollution quality assessment, biological treatment, and environmental remediation.

Molecular Biology-Based Analysis of the Interactive Effect of Nickel and Xanthates on Soil Bacterial Community Diversity and Structure

Metals and mineral flotation collector’s toxicity to the soil living system greatly compromise the sustainability of mining and ore processing. Their effects on the soil microbial community, the most active soil component, remain less understood and addressed particularly with regards to xanthates and their combination with metals. This study analyzed the interactive effects of Ni and xanthates, potassium ethyl xanthate and sodium isopropyl xanthate, on the soil bacterial community through an efficient molecular biology-based technique, the Miseq (Illumina). Both soil microbial community diversity and structure were more affected by xanthates than by Ni. The five most dominant phyla, representing 96.31% of the whole bacterial community, comprised Proteobacteria (54.16%), Firmicutes (17.51%), Actinobacteria (15.59%), Acidobacteria (4.87%), and Chloroflexi (4.16%). Different soil treatments exhibited greater difference in the species abundance/dominance than in the species numbers. Proteobacteria was the most dominant in the presence of xanthates, individually or in mixtures with nickel, while Firmicutes exhibited its highest proportion in the Ni/xanthate-treated samples. The most abundant and proportionally different bacterial species between different treatments were presented. The most abundant bacterial strains identified should be explored more for their potential application in biomining and for the prediction and biologically-based treatment and remediation of Ni and xanthate-contaminated systems.

Toxicity of nickel to soil microbial community with and without the presence of its mineral collectors-a calorimetric approach

The toxicity of nickel and three of its main collectors, sodium isopropyl xanthate (SIPX), sodium ethyl xanthate (SEX), and potassium ethyl xanthate (PEX) to soil microbial activity, was analyzed, individually and as a binary combination of nickel and each of the collectors. The investigation was performed through the microcalorimetric analysis method. For the single chemicals, all power-time curves exhibited lag, exponential, stationary, and death phases of microbial growth. Different parameters exhibited a significant adverse effect of the analyzed chemicals on soil microbial activity, with a positive relationship between the inhibitory ratio and the chemical dose (p < 0.05 or p < 0.01). A peak power reduction level of 24.23% was noted for 50 μg g^-1 soil in the case of Ni while for the mineral collectors, only 5 μg g^-1 soil and 50 μg g^-1 soil induced a peak power reduction level of over 35 and 50%, respectively, in general. The inhibitory ratio ranged in the following order: PEX > SEX > SIPX > Ni. Similar behavior was observed with the mixture toxicity whose inhibitory ratio substantially decreased (maximum decrease of 38.35%) and slightly increased (maximum increase of 15.34%), in comparison with the single toxicity of mineral collectors and nickel, respectively. The inhibitory ratio of the mixture toxicity was positively correlated (p < 0.05 or p < 0.01) with the total dose of the mixture. In general, the lesser and higher toxic effects are those of mixtures containing SIPX and PEX, respectively.

Toxic effect of two kinds of mineral collectors on soil microbial richness and activity: analysis by microcalorimetry, microbial count, and enzyme activity assay

Flotation reagents are hugely and increasingly used in mining and other industrial and economic activities from which an important part is discharged into the environment. China could be the most affected country by the resulting pollution. However, their ecotoxicological dimension is still less addressed and understood. This study aimed to analyze the toxic effect of sodium isobutyl xanthate (SIBX) and sodium isopropyl xanthate (SIPX) to soil microbial richness and activity and to make a comparison between the two compounds in regard to their effects on soil microbial and enzymes activities. Different methods, including microcalorimetry, viable cell counts, cell density, and catalase and fluorescein diacetate (FDA) hydrololase activities measurement, were applied. The two chemicals exhibited a significant inhibitory effect (P < 0.05 or P < 0.01) to all parameters, SIPX being more adverse than SIBX. As the doses of SIBX and SIPX increased from 5 to 300 μg g^-1 soil, their inhibitory ratio ranged from 4.84 to 45.16 % and from 16.13 to 69.68 %, respectively. All parameters fluctuated with the incubation time (10-day period). FDA hydrolysis was more directly affected but was relatively more resilient than catalase activity. Potential changes of those chemicals in the experimental media and complementarity between experimental techniques were justified.