Excess Adsorption of Organic Eluent Components from Mobile Phases Containing Electrolytes

Diffusion behavior of rhodamine 6G in single octadecylsilyl-functionalized silica particle revealed by fluorescence correlation spectroscopy

We investigated the diffusion behavior of rhodamine 6G (Rh6G) within single octadecylsilyl-functionalized (ODS) silica particle in an acetonitrile (ACN)/water system using fluorescence correlation spectroscopy (FCS). FCS measurements were conducted at the center of the particle to exclusively determine the intraparticle diffusion coefficient (D). The obtained D values were analyzed based on a pore and surface diffusion model, the results of which indicate that surface diffusion primarily governs the intraparticle diffusion of Rh6G. Furthermore, an increase in the concentration of ACN (CACN) resulted in a corresponding increase in the surface diffusion coefficient (Ds), whereas the addition of NaCl did not significantly affect the Ds values. We attributed this dependence of Ds to the dielectric constant change in the interfacial liquid phase formed on the ODS layer. Specially, Ds values of (4.0 ± 0.5) × 10-7, (7.7 ± 1.1) × 10-7, (1.0 ± 0.3) × 10-6, and (1.1 ± 0.2) × 10-6 cm2 s-1 were obtained for CACN = 20, 30, 40, and 50 vol%, respectively. We anticipate that this approach will contribute to advancing research on intraparticle mass transfer mechanisms.

Surface-bubble-modulated liquid chromatography: an experimental strategy for identification of molecular processes of solute retention in reversed-phase separation systems

Molecular level understanding of the chemistry at the aqueous/hydrophobe interface is crucial to separation processes in aqueous media, such as reversed-phase liquid chromatography (RPLC) and solid-phase extraction (SPE). Despite significant advances in our knowledge of the solute retention mechanism in these reversed-phase systems, direct observation of the behavior of molecules and ions at the interface in reversed-phase systems still remains a major challenge and experimental probing techniques that provide the spatial information of the distribution of molecules and ions are required. This review addresses surface-bubble-modulated liquid chromatography (SBMLC), which has a stationary gas phase in a column packed with hydrophobic porous materials and enables one to observe the molecular distribution in the heterogeneous reversed-phase systems consisting of the bulk liquid phase, the interfacial liquid layer, and the hydrophobic materials. The distribution coefficients of organic compounds referring to their accumulations onto the interface of alkyl- and phenyl-hexyl-bonded silica particles exposed to water or acetonitrile-water and into the bonded layers from the bulk liquid phase are determined by SBMLC. The experimental data obtained by SBMLC show that the water/hydrophobe interface exhibits an accumulation selectivity for organic compounds, which is quite different from that of the interior of the bonded chain layer, and the overall separation selectivity of the reversed-phase systems is determined by the relative sizes of the aqueous/hydrophobe interface and the hydrophobe. The solvent composition and the thickness of the interfacial liquid layer formed on octadecyl-bonded (C₁₈) silica surfaces are also estimated from the bulk liquid phase volume determined by the ion partition method employing small inorganic ions as probes. It is clarified that various hydrophilic organic compounds as well as inorganic ions recognize the interfacial liquid layer formed on the C₁₈-bonded silica surfaces as being different from the bulk liquid phase. The behavior of some solute compounds exhibiting substantially weak retention in RPLC or the so-called negative adsorption, such as urea, sugars, and inorganic ions, can rationally be interpreted with a partition between the bulk liquid phase and the interfacial liquid layer. The spatial distribution of solute molecules and the structural properties of the solvent layer on the C₁₈-bonded layer determined by the liquid chromatographic methods are discussed in comparison to the results obtained by other research groups using molecular simulation methods.

Characterization of the Interfacial Liquid Layer Formed on Hydrophobic Packing Material Surfaces by Liquid Chromatographic Analysis of the Distribution of Ions and Molecules

We determine the bulk liquid phase volumes in octadecyl-bonded silica (C₁₈ silica) columns equilibrated with acetonitrile-water and methanol-water (0-19%(v/v)) binary mixed solvents by a liquid chromatographic method with inorganic ions used as probes. The solvent composition and the thickness of the interfacial liquid layer formed on the C₁₈-bonded silica surface are then determined from the bulk liquid phase volume, the total liquid phase volume, the surface area of the C₁₈ silica packing material, and the retention volumes of the isotopically labeled eluent components for the columns. We used two C₁₈ silica packing materials having identical bonding structures but different pore sizes and surface areas. Our results show that various hydrophilic organic compounds as well as inorganic ions recognize the interfacial liquid layer as being different from the bulk phase. The behavior of the solute compounds exhibiting substantially weak retention in reversed-phase liquid chromatography or the so-called negative adsorption, such as urea, sugars, and inorganic ions, can rationally be interpreted with a partition between the bulk liquid phase and the interfacial solvation liquid layer. The structural properties of the solvent layer on the C₁₈-bonded layer determined by liquid chromatography are consistent with the molecular dynamics simulation results that have been obtained by other researchers.