Fluoroless left atrial access for radiofrequency and cryoballoon ablations using a novel radiofrequency transseptal wire

Prospective study of zero-fluoroscopy laser balloon pulmonary vein isolation for the management of atrial fibrillation

BACKGROUND

In recent years, there has been increased focus on the development of safe and effective strategies to minimize and ultimately eliminate fluoroscopy use in the electrophysiology lab due to the inherent risks to patients and staff associated with this imaging source. However, studies examining these innovative fluoroless strategies for pulmonary vein isolation (PVI) using catheters without direct 3D mapping system integration are lacking. We sought to develop a method to perform zero-fluoroscopy laser balloon PVI for patients with atrial fibrillation (AF), and to test the safety and efficacy of this approach.

METHODS

We developed a standardized method for performing PVI using the X3 laser balloon (LB) system, 3-dimensional electroanatomic mapping (3D-EAM) and intracardiac echocardiography (ICE) in a cohort of patients with symptomatic AF. The primary endpoint of the study was the ability to perform PVI without the use of fluoroscopy. Secondary outcomes were rate of successful transseptal puncture on first attempt, first pass isolation of target PVs, mean procedural time, active laser time to achieve PVI, need for use of supplemental energy sources, and procedural complication rates.

RESULTS

Two hundred consecutive patients undergoing PVI were recruited in the study. In the zero-fluoroscopy group, LB PVI was successfully performed in 100% of participants (n = 100) without the need for fluoroscopy. Transseptal access was achieved in 100% of cases on the first attempt. Successful first pass PVI was achieved in 360 of the 387 pulmonary veins attempted (93%). Mean procedural time was 68.2 ± 16.2 min in the zero-fluoroscopy group versus 67.5 ± 17.0 min in the conventional fluoroscopy group. PVI was able to be achieved in 100% of cases in both groups without need for use of supplemental energy sources. In the zero-fluoroscopy group there were minimal complications, with 3% of all cases having groin complications and 1 patient with a pericardial effusion noted post-procedure which was managed conservatively.

CONCLUSIONS

We demonstrated that successful zero-fluoroscopy LB PVI could be performed at a single high-volume center by experienced operators in an effective manner, without significant complications.

Feasibility and safety of a three-dimensional anatomic map-guided transseptal puncture for left-sided catheter ablation procedures

AIMS

Transseptal puncture (TP) for left-sided catheter ablation procedures is routinely performed under fluoroscopic or echocardiographic guidance [transoesophageal echocardiography (TEE) or intracardiac echocardiography (ICE)], although three-dimensional (3D) mapping systems are readily available in most electrophysiology laboratories. Here, we sought to assess the feasibility and safety of a right atrial (RA) 3D map-guided TP.

METHODS AND RESULTS

In 104 patients, 3D RA mapping was performed to identify the fossa ovalis (FO) using the protrusion technique. The radiofrequency transseptal needle was visualized and navigated to the desired potential FO-TP site. Thereafter, the interventionalist was unblinded to TEE and the potential FO-TP site was reassessed regarding its convenience and safety. After TP, the exact TP site was documented using a 17-segment-FO model. Reliable identification of the FO was feasible in 102 patients (98%). In these, 114 3D map-guided TP attempts were performed, of which 96 (84%) patients demonstrated a good position and 18 (16%) an adequate position after TEE unblinding. An out-of-FO or dangerous position did not occur. A successful 3D map-guided TP was performed in 110 attempts (97%). Four attempts (3%) with adequate positions were aborted in order to seek a more convenient TP site. The median time from RA mapping until the end of the TP process was 13 (12-17) min. No TP-related complications occurred. Ninety-eight TP sites (85.1%) were in the central portion or in the inner loop of the FO.

CONCLUSION

A 3D map-guided TP is feasible and safe. It may assist to decrease radiation exposure and the need for TEE/ICE during left-sided catheter ablation procedures.

Use of a novel integrated dilator-needle system in cryoballoon procedures: a zero-exchange approach

BACKGROUND

Recently, a novel integrated dilator-needle system (AcQCross Qx, Acutus Medical) was introduced to reduce the number of exchanges for a transseptal access. This system can be used in combination with large bore sheaths. In this pilot study, we evaluated the safety and efficacy of a zero-exchange approach with the AcQCross system in cryoballoon procedures.

METHODS

In this retrospective single-center study, we included 40 patients (AcQCross: n = 20; control group: n = 20) who underwent a cryoballoon procedure for the treatment of atrial fibrillation. In the AcQCross and control group, patients underwent ablation with POLARx (Boston Scientific) and Arctic Front Advance Pro (AFA-Pro, Medtronic) in equal numbers (n = 10). In the AcQCross group, the AcQGuide Max sheath (Acutus Medical) was used in all POLARx cases.

RESULTS

The baseline characteristics of the study population were comparable between groups. In the AcQCross group, there was a reduction in procedure time (49.7 ± 9.0 min vs. 59.6 ± 8.1 min, P < 0.001) and time from puncture until balloon delivery (15.5 ± 6.8 min vs. 21.5 ± 7.4 min, P = 0.01) in comparison with the control group. The balloon in body time, fluoroscopy time, number of cryoapplications, and biophysical parameters were similar between groups. There was one temporary phrenic nerve injury in the AcQCross group. Importantly, no signs of air embolism were noted with the AcQGuide Max sheath.

CONCLUSIONS

The use of the novel AcQCross system improves procedural efficacy in cryoballoon procedures by reducing the number of exchanges.