Scanning electron microscopy and energy-dispersive X-ray analysis of self-etching adhesive systems to ground and unground enamel

Morphological and chemical comparative analysis of the human and bovine dentin-adhesive layer

Micro energy-dispersive X-ray fluorescence spectrometry (µ-EDXRF) and scanning electron microscopy (SEM) were used to evaluate dentin treated with an etch and rinse adhesive (ER) and a self-etch adhesive (SE). Ten human molars (H) and ten bovine anterior teeth (B) were prepared (exposure of dentin and divided in the middle) and allocated into two different adhesion strategy groups per substrate (n=40). µ-EDXRF data and SEM images were obtained before and after treatment. Untreated dentin of both substrates did not differ in terms of Ca (p<0.1503), P (p<0.2986) or Ca/P ratio (p<0.1400). H-SE and B-SE specimens showed reduced P content (p<0.0001; p<0.0002), while H-ER and B-ER specimens showed reduced Ca and P content (p<0.0001; p<0.0001) when compared with untreated specimens. The Ca/P ratio was significantly higher in H-ER and B-ER specimens than in H-SE and B-SE specimens (p<0.0001; p<0.0080). Untreated dentin showed a homogeneous elemental distribution. However, after adhesive treatments, the surface of the dentin showed an irregular demineralization pattern. The resin tags and adhesive layer were shorter in bovine specimens than in human specimens due to morphological differences.

Evaluation of X-ray microanalysis for characterization of dental enamel

Elemental analysis of dental hard tissues is of importance. The aim of this study is to evaluate X-ray microanalysis (XRMA) of bovine enamel in a scanning electron microscope (SEM) with different coatings. The buccal surface of bovine incisors was polished flat, one-third was coated with carbon, one-third with gold, leaving one-third uncoated for XRMA in an SEM equipped with an energy-dispersive microanalysis system. The elements oxygen, sodium, magnesium, phosphorous, chlorine, potassium, and calcium were analyzed using their respective characteristic K X-ray series. Comparisons were made with analyses of glass produced by fusion of the bovine enamel, showing that oxygen analyses using the K X-ray series are reliable and preferable to calculating oxygen by stoichiometry for natural enamel. For the gold-coated and uncoated analyses, carbon was also measured using the K X-ray series. Small area Analyses in small areas (80 × 80 μm) in variable pressure-SEM mode with low vacuum (20 Pa), without any coating, midway between 40 μm wide gold lines 140 μm apart to avoid build-up of electrostatic charge is the preferred method, especially if carbon is included in the analysis. The analyses of bovine enamel are sufficiently reproducible to be regarded as quantitative for all elements except carbon.

Mineral densities and elemental content in different layers of healthy human enamel with varying teeth age

OBJECTIVES

This study aims to evaluate the mineral density, calcium (Ca), and phosphorus (P) weight percent of healthy human enamel of varying human teeth age and enamel layers.

METHODS

Twenty human teeth were divided into "young" (18-24 years) and "old" (55 ≤ years) age groups. From each tooth, one enamel slab (approximately 8 mm × 2 mm × 1.5 mm) was obtained. All enamel slabs were embedded and scanned by micro-computed tomography. The scanned slices were reconstructed into a 3D image and regions of interest (ROIs) were defined. Then, the mineral density for each ROI was calculated. The Ca and P weight percent in the outer, middle, and inner enamel layers were quantified by scanning electron microscopy with energy dispersive spectroscopy. Finally, the data were analysed using one-way ANOVA and Student's t-test.

RESULTS

In the two age groups, the mineral density, Ca and P weight percent decreased from outer to the inner enamel layer. The mineral density, Ca and P weight percent in the outer enamel layer in the old age group were significantly higher than those in the young age group (P<0.05); however, no age-dependent differences were observed for these properties in the middle and inner enamel layers (P>0.05).

CONCLUSIONS

The mineral density, Ca and P weight percent decreased from the outer to the inner enamel layers in the two age groups. In the outer enamel layer, the differences in these properties between the two age groups were significantly different; however, no region-dependent differences were observed in the middle and inner enamel layers.