Colorimetric Determination of Pb2+ in Perfect Aqueous Solution Using Carminic Acid as a Selective Chemosensor

A new benzothiazole azo dye colorimetric chemosensor for detecting Pb2+ ion

In this work, a new benzothiazole azo dye sensor (BTS) was synthesized, and its cation binding affinity was studied using the colorimetric method, UV-vis, and ¹H NMR spectral data. The results revealed that the sensor BTS exhibits a remarkable tendency for Pb²⁺ ion to perform spontaneous visual color change from blue (BTS) to pink (BTS + Pb²⁺), without any color change in the aqueous solutions of other cations such as Hg²⁺, Cu²⁺, Al³⁺, Ni²⁺, Cd²⁺, Ag⁺_, Ba²⁺, K⁺, Co²⁺, Mg²⁺, Na⁺, Ca²⁺, Fe²⁺, and Fe³⁺ ions. The observed selectivity could be due to the formation of the complex (BTS + Pb²⁺⁾, which led to a blue shift from 586 nm (BTS) to 514 nm (BTS + Pb²⁺) in the UV spectrum. The job's plot provided the stoichiometry ratio of the complex (BTS + Pb²⁺) to be 1:1. The limit of detection (LOD) of BTS for Pb²⁺ ion sensing was obtained at 0.67 µM. Additionally, the binding constant for BTS toward Pb ²⁺ ion was studied using the Benesi-Hildebrand equation. As a result of the BTS test paper strips investigations, it was found that the synthesized sensor BTS could be used as a rapid colorimetric chemosensor for the detection of the Pb²⁺ ions in the distilled, tap, and sea waters.

Colorimetric Probe for Mn2+ Using a Mixture of an Anionic Dye and a Cationic Polyelectrolyte in an Aqueous Solution

A novel colorimetric probe for Mn²⁺ was easily prepared by mixing negatively charged alizarin complexone (ALC) with positively charged poly[bis(2-chloroethyl)ether-alt-1,3-bis[3-(dimethylamino)propyl]urea] (PQ-2) in aqueous solutions at pH 6.0. Upon adding Mn²⁺ to ALC alone, the solution underwent no distinct color change, while the mixture displayed selective detection of Mn²⁺ over different physiological and environmentally significant metal ions by an efficient naked-eye color change from red to purple. The detection of Mn²⁺ by the mixture was achieved from the electrostatic interactions between ALC and PQ-2. The quantitative determination of Mn²⁺ was obtained by spectrophotometric measurement and naked-eye observation. This sensing strategy can be an attractive approach for the development of new colorimetric probes due to the advantages such as no organic synthesis, facile fabrication, and simple visual detection.

A Simple Distance Paper-Based Analytical Device for the Screening of Lead in Food Matrices

A simple and rapid distance paper-based analytical device (dPAD) for the detection of lead (Pb) in foods is proposed herein. The assay principle is based on competitive binding between carminic acid (CA) and polyethyleneimine (PEI) to Pb in a food sample. The paper channels were pre-immobilized with PEI, before reacting with a mixture of the sample and CA. Pb can strongly bind to the CA; hence, the length of the red color deposition on the flow channel decreased as a lower amount of free CA bound to PEI. The dPAD exhibited good linear correlation, with ranges of 5-100 µg·mL-1 (R2 = 0.974) of Pb. Although, the limit of detection (LOD) of this platform was rather high, at 12.3 µg·mL-1, a series of standard additions (8.0, 9.0, and 10.0 µg·mL-1) can be used to interpret the cutoff of Pb concentrations at higher or lower than 2 µg·mL-1. The presence of common metal ions such as calcium, magnesium, nickel, and zinc did not interfere with the color distance readout. The validity of the developed dPAD was demonstrated by its applicability to screen the contamination of Pb in century egg samples. The results obtained from the dPAD are in accordance with the concentration measured by atomic absorption spectroscopy (AAS) (n = 9). In conclusion, this proposed dPAD, combined with the standard addition method, could be applied for screening Pb contamination in food matrices. This platform is, therefore, potentially applicable for field measurements of Pb in developing countries, because it is cheap and rapid, and it requires no significant laborious instruments.