Preparation of Magnetic Kaolinite Nanotubes for the Removal of Methylene Blue from Aqueous Solution

Natural kaolinite-based hierarchical porous microspheres as effective and highly recyclable adsorbent for removal of cationic dyes

The development of efficient, recyclable, and environment-friendly adsorbent for wastewater remediation is considered a challenge. In this study, a hierarchical porous kaolinite microsphere (HPKS) with three-dimensional (3D) structure was fabricated based on natural-layered kaolinite mineral via an environmentally friendly direct hydrothermal strategy. Characterization results revealed that HPKS microsphere with 3D hierarchical porous structure was constructed with numerous nanospheres which are assembled by ultrafine aluminosilicate flakes. HPKS exhibited negative charge feature ranging from strong acid to high alkaline solution. The influence of contact time, solution pH, initial dye concentration, adsorbent dosage, and foreign ions on methylene blue (MB) adsorption capability was systematically investigated. The synthesized HPKS with higher specific surface area (250.6 m²/g) shows an outstanding adsorption capacity towards MB (411.8 mg/g) and excellent selectivity for cationic MB dyes over anionic methyl orange and competitive metal ions. The adsorption kinetic experiment results fit very well with the pseudo-second-order model and reflect the fast adsorption rate of MB on HPKS. The sorption isotherm study reveals the chemisorption of electrostatic attraction between the cationic MB molecules and the negative charged surfaces of HPKS. More importantly, the MB removal efficiency is more than 99% in a broad range of solution pH value. The adsorption capacities of HPKS can be easily recovered by calcination at 600 °C to remove the adsorbed dyes and without obvious diminishment even after six successive cycles. Therefore, the HPKS is a cost-effective and environmentally friendly adsorbent which has is promising to use in practical applications.

Insight into Structural Features of Magnetic Kaolinite Nanocomposite and Its Potential for Methylene Blue Dye Removal from Aqueous Solution

An in-depth understanding on the structural features of engineered magnetic adsorbent is important for forecasting its efficiencies for environmental clean-up studies. A magnetic kaolinite nanocomposite (MKN) was prepared using Malaysia’s natural kaolinite via co-precipitation method with a three different clay: iron oxide mass ratio (MKN 1:1, MKN 2:1 and MKN 5:1). The morphology and structural features of the magnetic composites were systematically investigated using techniques, such as: Fourier transform infrared spectroscopy (FTIR), scanning electron microscope (SEM), surface area analysis (BET), Vibrating Sample Magnetometer (VSM), and zeta potential measurement. The removal efficiencies of the adsorbent for Methylene Blue (MB) dye were studied in batch method as a function of pH and initial concentration. MKN1:1 demonstrated the highest magnetisation susceptibility (Ms) of 35.9 emu/g with four-fold-increase in specific surface area as compared to the pristine kaolinite. Preliminary experiment reveals that all MKNs showed almost 100% removal of MB at low initial concentration (<50 ppm). The spent MKN adsorbent demonstrated an easy recovery via external magnetic field separation and recorded maximum adsorption capacity of 18.1 mg/g. This research gives an insight on the surface characteristics of magnetic clay composite for potential application as an effective and low-cost adsorbent in treating dye contaminated water. Copyright © 2022 by Authors, Published by BCREC Group. This is an open access article under the CC BY-SA License (https://creativecommons.org/licenses/by-sa/4.0).

Comparative adsorption mechanism of doxycycline and Congo red using synthesized kaolinite supported CoFe2O4 nanoparticles

Kaolinite supported CoFe₂O₄ (KCF) was synthesized and employed to adsorb doxycycline (DOX), an antibiotic and Congo red (CR), a dye from aqueous solution. The prepared KCF nanocomposite was treated in a muffle furnace at 300, 500 and 700 °C, and thereafter characterized. X-ray diffractogram revealed structural damage of kaolinite and appearance of distinct peaks of CoFe₂O₄ with an increase in calcination temperature, while transmission electron microscopy (TEM) images showed that CoFe₂O₄ nanoparticles were supported on the lamellar surface of kaolinites. Comparative adsorption mechanism of the two targeted contaminants showed that adsorption of DOX was influenced by hydrogen bond and n-π interaction, while that of CR was due to hydrophobic interaction and hydrogen bond. However, the adsorption of the two contaminants was best fitted to the isotherm that was proposed by Langmuir, with a monolayer maximum adsorption capacity of 400 mg g^-1 at 333 K for DOX, and 547 mg g^-1 at 298 K for CR. The removal of DOX from aqueous solution was favored by an increase in temperature (endothermic), while that of CR was exothermic. Thermodynamics studies confirmed that the adsorption of the two contaminants is feasible and spontaneous. The presence of natural organic matter (NOM) did not affect the removal of the two contaminants. Regeneration and reusability study showed that KCF is economically viable. Therefore, introducing inorganic particles like cobalt ferrite into the matrix of kaolinites provides a composite with promising adsorption capacity.

Liquid-Phase Exfoliation of Kaolinite by High-Shear Mixer with Graphite Oxide as an Amphiphilic Dispersant

In this study, a simple, effective, and versatile method was used for the exfoliation of kaolinite by high-shear mixer with graphite oxide as an an amphiphilic dispersant. During the liquid-phase exfoliation process, the co-exfoliation of kaolinite and graphite oxide was realized. Compared with the directly exfoliated kaolinite, when 5% graphite oxide was added to facilitate exfoliation, 95% of the obtained nanosheets were distributed between 0.1 and 0.7 μm, in which the number of layers was less than 5, and part of them were curled into nanoscrolls structure with a length of 0.2-0.9 μm. The Brunauer-Emmett-Teller surface area of the graphite oxide assisted exfoliated kaolinite was 2.1 times that of the directly exfoliated kaolinite. Meanwhile, the graphite oxide assisted exfoliated kaolinite exhibited excellent adsorption properties for MB, whose theoretical maximum adsorption capacity was 250 mg/g, significantly higher than that of the directly exfoliated kaolinite, which was about 111 mg/g. It has been verified that the exfoliation method is efficient and facile and can be applied extensively.

Efficient preparation of kaolinite/methanol intercalation composite by using a Soxhlet extractor

Kaolinite/methanol intercalation composite (KMe) is a key precursor for preparing clay-based inorganic/organic hybrid materials and kaolinite nanoscrolls. However, synthesis of KMe is a time and methanol dissipative process and the complexity of this process also limits its further applications. In this study, Soxhlet extractor was introduced to synthesize an intercalation composite and KMe was efficiently synthesized in a Soxhlet extractor through a continuous displacement process by using kaolinite/DMSO intercalation composite (KD) as a precursor. The formation process of kaolinite/methanol intercalation composite was studied by X-ray diffraction (XRD) and infrared spectroscopy (IR). The results showed that the DMSO in kaolinite could be completely displaced by methanol in this process and the preparation of KMe could be completed in 8 hours, which was far faster than the reported methods. Moreover, methanol used in this process could be recycled. Furthermore, the resulting material could be successfully used to prepare kaolinite nanoscrolls in high yield.

Hierarchical Structure Kaolinite Nanospheres with Remarkably Enhanced Adsorption Properties for Methylene Blue

Kaolinite nanospheres with hierarchical structures were synthesized via dehydration-rehydration technique through calcined-hydrothermal route. The microstructure of samples were characterized and analyzed by diverse techniques. The results show that after hydrothermal treatment, the layered pseudo-hexagonal kaolinite particles transformed to hierarchical structure nanospheres. The hierarchical structures exhibit large specific surface area of 157.1 m² g^-1 and narrow mesoporous size distribution. The adsorption properties of kaolinite nanospheres were systematically investigated by the removal of methylene blue (MB) from water. It was found that the nanospheres can rapidly adsorb MB with a higher adsorption capacity (184.9 mg/g), and adsorption data followed Langmuir isotherm model and pseudo-second-order kinetic model. Furthermore, the adsorbent can be regenerated by washing with methanol-HCl solution and shown removal efficiency of more than 95% up to 4 cycles.