Effects of Terbium Doping on Structural, Optical and Photocatalytic Properties of ZnO Nanopowder Prepared by Solid-State Reaction

HSBM-Produced Zinc Oxide Nanoparticles: Physical Properties and Evaluation of Their Antimicrobial Activity against Human Pathogens

This work examines the antibacterial and anticandidal activities of zinc oxide nanoparticles (ZNPs) synthesized by high-speed ball milling (HSBM), for short milling times: 0.5, 1, 1.5, and 2 h. First, ZNPs have been characterized by X-ray diffraction (XRD), transmission electron microscopy (TEM), Fourier transform infrared spectroscopy (FT-IR), Raman spectroscopy, and the Zetasizer analyzer. The HSBM results in semispherical ZNPs with some local agglomeration. We found that nanoparticles decrease in size continuously with milling time until they reach about 84% of their original size after only two hours; at 1000 rpm, HSBM reduces ZNP's average size by 6 nm/min. As particle size decreases, the X-ray diffracted patterns become broader and less intense while confirming that no phase transformation has occurred, proving HSBM's effectiveness in synthesizing nanoparticles on a large scale within a short period of time. According to FT-IR analysis, as material sizes change, the polarization charge of the ZNP surface changes as well, creating discrepancies in vibrational frequency, as demonstrated by the shifting of the IR spectra in the 300-600 cm^-1 frequency band. Raman responses have also been proven to depend on the particle size. Using the Agar well diffusion method, eleven microorganisms have been tested for the antimicrobial activity of ZNPs. Among the six Gram-negative tested bacteria, S. sonnei showed the largest inhibition zone of about 11.3 ± 0.6 mm with ZNPs measuring 148 nm in size (milled for 2 h), followed by E. coli ATCC 25922. Accordingly, S. aureus was the most susceptible Gram-positive bacteria, with inhibition zone size gradually increasing from 11.8 ± 0.3 mm to 13.5 ± 0.5 mm with decreasing nanoparticle size from 767 to 148 nm, while S. aureus ATCC 25923 was resistant to both milled and unmilled samples. Similar results were seen with candida, all milled ZNPs inhibited C. albicans, followed by C. tropicalis, whereas C. knisei was resistant to all ZNP sizes. In light of microorganism-ZNP interaction mechanisms, the obtained results have been discussed in depth.

The Influence of Al Doping on the Optical Characteristics of ZnO Nanopowders Obtained by the Low-Cost Sol-Gel Method

In this work, the influence of Al (0, 2, 4, and 6 wt.%) on the optical properties of ZnO has been briefly investigated and described. The undoped and doped samples were characterized using a UV-visible spectrophotometer and Photoluminescence (PL). The X-ray diffraction (XRD) data in our preceding study is also indexed, and materials are said to have a wurtzite-structured hexagonal phase and exhibit no impurity phases. The average crystallite sizes of the pure ZnO were found to increase, i.e., from 14.19 nm to 34.17 nm with an increase in temperature, and in the case of Al-doped ZnO, at a constant temperature, from 35.05 nm to 18.89 nm, respectively. The average crystallite size of AZO (Al-doped ZnO) decreases with increasing Al content. With the increasing temperature, increases in crystallinity and size of the pure ZnO have been observed. In the case of Al doping, with an increase in the concentration of doping the crystallite size is seen to be decreased, without any change in the temperature. Al doping improves the formation of the well-ordered crystalline structure of ZnO up to a certain limit of doping. The absorbance spectra were used to determine the optical band gap of the samples. The optical photoluminescence (PL) spectra of both ZnO and AZO nanopowder are obviously influenced by the increasing temperature and Al doping content, respectively. Different optical properties of ZnO and AZO were observed for different contents of Al in ZnO. The band gap of AZO nanopowder with different concentrations has been seen to be lower than that of undoped ZnO (3.10 eV), suggesting broad application potential. Also, the optical properties of ZnO were tailored by Al doping in the near visible region, suggesting various potential uses.