Numerical simulation on crystallization-induced warpage of injection-molded PP/EPDM part

Injection Molding Simulation of Polyoxymethylene Using Crystallization Kinetics Data and Comparison with the Experimental Process

It is well known that the processing conditions in polymer processing have a high impact on the resulting material morphology and consequently the component’s mechanical behavior. However, especially for semicrystalline polymers, the tools available for predicting the final morphology of injection molding parts still have significant limitations. In order to investigate the potential of injection molding simulation for the prediction of the morphology, POM homopolymer specimens were injection molded. The crystallization kinetics data were measured, and simulations in 3D and 2.5D with and without crystallization analysis were conducted in Autodesk Moldflow. The simulations are found to be good accordance with the experiments. Predicted spherulite size and crystalline orientation factor reveal a good qualitative correlation with optical micrographs. Also, the evolution of these parameters along the flow path is plausible. The simulation is found to be a powerful tool for morphology prediction in polymeric parts. Its applicability, however, is still limited to 2.5D models in Autodesk Moldflow, which, of course, is insufficient for complex, thick-walled 3-dimensional parts.

Warpage Prediction of RHCM Crystalline Parts Based on Multi-Layers

Warpage is a typical defect for injection-molded parts, especially for crystalline parts molded by rapid heat cycle molding (RHCM). In this paper, a prediction method is proposed for predicting the warpage of crystalline parts molded by the RHCM process. Multi-layer models were established to predict warpage with the same thicknesses as the skin-core structures in the molded parts. Warpages were defined as the deformations calculated by the multi-layer models. The deformations were solved using the classical laminated plate theory by Abaqus. A model was introduced to describe the elastic modulus with the influence of temperature and crystallinity. The simulation process was divided into two procedures, before ejection and after ejection. Thermal stresses and thermal strains were simulated, respectively, in the procedure before ejection and after ejection. The prediction results were compared with the experimental results, which showed that the average errors between predicted warpage and average experimental warpage are, respectively, 7.0%, 3.5%, and 4.4% in conventional injection molding (CIM), in RHCM under a 60 °C heating mold (RHCM60), and in RHCM under a 90 °C heating mold (RHCM90).