Preparation of organic porous materials-TiO2/cu composite with excellent photocatalytic degradation performances toward degradation of organic pollutants in wastewater

Copper-/Zinc-Doped TiO2 Nanopowders Synthesized by Microwave-Assisted Sol-Gel Method

Using the microwave-assisted sol-gel method, Zn- and Cu-doped TiO₂ nanoparticles with an anatase crystalline structure were prepared. Titanium (IV) butoxide was used as a TiO₂ precursor, with parental alcohol as a solvent and ammonia water as a catalyst. Based on the TG/DTA results, the powders were thermally treated at 500 °C. XRD and XRF revealed the presence of a single-phase anatase and dopants in the thermally treated nanoparticles. The surface of the nanoparticles and the oxidation states of the elements were studied using XPS, which confirmed the presence of Ti, O, Zn, and Cu. The photocatalytic activity of the doped TiO₂ nanopowders was tested for the degradation of methyl-orange (MO) dye. The results indicate that Cu doping increases the photoactivity of TiO₂ in the visible-light range by narrowing the band-gap energy.

Al/TiO2 composite as a photocatalyst for the degradation of organic pollutants

TiO₂ is a catalyst that can effectively degrade organic pollutants with the following advantages, low cost, simplicity, and pollution-free nature. In recent years, the non-noble plasmonic metal Al has effectively improved the photocatalytic performance of TiO₂. However, the current reports are limited to the photocatalytic performance of Al/TiO₂ on the substrate, which requires expensive large-scale vacuum equipment. In this study, monodispersed Al particles were proposed to enhance the photocatalysis of TiO₂. The localized surface plasmon resonance (LSPR) effect of Al is proven by finite difference time domain method (FDTF) simulation. Then, Al/TiO₂ composites were prepared by combining monodispersed Al and TiO₂. The influence of ligand (glutathione (GSH), glutamic acid (GAG), or 3-mercaptopropane acid (MPA)), Al size (40 to 300 nm), and the ratio of Al to TiO₂ (0.5:1 to 10:1) on the photocatalytic degradation of methylene blue (MB) by Al/TiO₂ were discussed. The obtained results showed that the Al/TiO₂ composite which were prepared with 200 nm Al particles, GSH as the ligand bridge, and an Al:TiO₂ ratio of 1:1 had the best MB degradation effect. It can degrade 97.7% of 10 mg/L MB in 100 min. The reaction rate of the Al/TiO₂ composite with the optimal photocatalytic performance is k=3.36×10^-2 min^-1, which is 10 times that of P25 TiO₂. In addition, Al/TiO₂ has a good photocatalytic effect on rhodamine B (RhB) and crystal violet (CV). Therefore, Al/TiO₂ composites with the advantage of high efficiency are a type of potential photocatalytic material that can be used for the photocatalytic treatment of organic pollutants in water.