Inducing polymer waste biodegradation using oxo-prodegradant and thermoplastic starch based additives

Comprehensive Estimation of Combustion Behavior and Thermochemical Structure Evolution of Four Typical Industrial Polymeric Wastes

A huge amount of industrial waste will be generated during the industrialization process and their harmless disposal has always been a headache for reducing carbon emissions. In this study, the combustion behaviors and thermal kinetics of four typical industrial polymeric wastes including rubber, leather, plastic and cloth, were systematically studied by using a Thermogravimetric Analysis. The gas emission and structural evolution was comprehensively analyzed using TG-FTIR, 2D-PCIS, ICP and TEM. The results show that the combustibility of leather and cloth are better than the other two samples, while the rubber and plastic have a wider combustion temperature range for higher content of C-H bonds and, the intermediate oxidation process and the stubborn cracking process of C=C bonds. The surface reaction was considered to be the main reaction of rubber and plastic (pre-exponential factor less than 10−9), while both leather and cloth went through a complex procedure during multiple decomposition. The volatiles products are gases (e.g., CO2, CH4) and small molecules (e.g., H2O). The high levels of basic metals in the industrial waste causes serious slagging and fouling tendency (fouling index higher than 4.0), which have a serious adverse influence on the operation of a waste incineration plant.

Soil quality of simulated landfill exposure to plastics in context of heavy metal analysis

It is imperative to have soil guidelines that consider commodities on the market especially biodegradable plastics that are increasing in popularity nowadays. In this short communication, heavy metal in soil was investigated after degrading plastics commonly used on the market. The plastic materials included virgin linear low-density polyethylene, plastic waste of polyolefin origin, and biodegradables of oxo- and hydro-based types. Soil/water matrix that simulates arid land conditions was used. Metals including cobalt, chromium, cadmium, and nickel, among others, were studied after exposure of three continuous months. It was noted that background concentrations reduced with water indicating that leachate might contain the majority of the transferred metals from plastics. In particular, the concentration of nickel in soil was detected to be 84 ppm after exposure to type I of the oxo-biodegradable commercial plastics. Furthermore, the material of similar source started to retain nickel by day 74 of exposure. This surpasses both Canadian and Australian guidelines discussed herein. Furthermore, nickel concentrations exceeded international guidelines and point towards the need for remediation. Mean values of chromium exceeded soil control results and the USA remediation values in the case of single screw compounded plastics. It should also be noted that the work conducted points towards metal trace detection limits that are tied to waste and sludge disposal in an improper manner with time.